Nissan

Nissan repair questions? Ask a mechanic for answers ASAP

Connect one-on-one with {0} who will answer your question

Related Nissan Questions
2006 Nissa Altima 2.5s. The front axle disengaged while I
2006 Nissa Altima 2.5s. The front axle disengaged while I was replacing the passenger side strut assemble. Can it be slipped back in somehow or does the axle need to be remove from the transmission fi… read more
kalamykid
kalamykid
Pactor automotive
Vocational, Technical or Trade Scho
6,156 satisfied customers
Low level groan at 40 mph on left front tire area..and a
Low level groan at 40 mph on left front tire area..and a steering wheel shimmy at 65 or so..checked wheel bearing on left..absolutely no play in bearing...if CV boots are intact..can CV joints still b… read more
JOHN aka Eauto
JOHN aka Eauto
self employed
High School or GED
24,313 satisfied customers
Good afternoon! I have a 2008 Nissan Rogue with 70 K miles.
Good afternoon! I have a 2008 Nissan Rogue with 70 K miles. I have a clicking noise coming from the left front wheel area when I start to accelerate from a stop and the the car vibrates slightly until… read more
Internal88
Internal88
Bachelor
5,346 satisfied customers
Pathfinder: I am installing new struts on 98 Pathfinder and
I am installing new struts on 98 Pathfinder and traverse arm supporting jack fell while I had strut out. Now I can't align steering knuckle to strut attachment. It seems like drive (cv joint) has pull… read more
Mike V.
Mike V.
Nissan Technician
Subaru and Nissan factory training.
10,242 satisfied customers
G20: The CV axle boot repeated tears (average of once every
The CV axle boot repeated tears (average of once every 12-18 months). I'm a conservative driver, and never take the car on gravel roads, or subject it to undue stresses. Of course, this could happen e… read more
HondaPlatinum
HondaPlatinum
Vocational, Technical or Trade School
27,997 satisfied customers
replacing..steering knuckle..bolts the suspension arm shot..left turn
I am replacing the driver front strut. I can't get the steering knuckle back in to bolt it up with the lower bolt connections on the strut. When I removed the bolts the suspension arm shot up a few in… read more
jpaug01
jpaug01
technician
Vocational, Technical or Trade Scho
427 satisfied customers
I hear a quick rattle noise when i turn left..only happens..accelerate
I hear a quick rattle noise when i turn left sometimes, but not all the time. it only happens when i am at a stop and when i turn left and just when i accelerate turning left. But remember, not all th… read more
Tim\u0027s Auto Repair
Tim\u0027s Auto Repair
Mechanic
High School or GED
16,080 satisfied customers
95 Nissan Maxima GLE: Automatic..cv..drivers side..joint assembly
I have a 95 Nissan Maxima GLE Automatic with a RE4F04A transaxle. How do you change the CV boots left and right side? I started on the driver's side with joint assembly pulled from knuckle. The old bo… read more
jpaug01
jpaug01
technician
Vocational, Technical or Trade Scho
427 satisfied customers
2003 NISSAN ALTIMA: 4 cyl, auto trans, while re..left front..axel
2003 NISSAN ALTIMA, 4 cyl, auto trans, while re-installing a new left front strut, I cannot re-attach the hub to the lower ball joint and / or the two mounting holes on the new strut. The axel "seems … read more
JOHN aka Eauto
JOHN aka Eauto
self employed
High School or GED
24,313 satisfied customers
2003 NISSAN ALTIMA: 4 cyl, auto trans..new left front strut..axel
2003 NISSAN ALTIMA, 4 cyl, auto trans, while installing a new left front strut, I cannot re-attach the hub to the lower ball joint and / or the two mounting holes on the new strut. The axel "seems too… read more
Jay
Jay
Shop Forman / Lead Tech
Vocational, Technical or Trade Scho
27,773 satisfied customers
2005 nissan: rotate..mounts..it be done w/o removing entire CV shaft
2005 nissan altima....im replacing the front struts and the right wheel will not rotate back up to match the strut mounts...extreme negative camber...the left one worked just fine possible that inner … read more
HondaPlatinum
HondaPlatinum
Vocational, Technical or Trade School
27,997 satisfied customers
Nissan ALtima: 000 miles..clunking/knocking noise coming..front end
I have a 05 Nissan ALtima with 140,000 miles. I have had a clunking/knocking noise coming from the front end and/or motor for several months. I just recently took it to a mechanic who fixed the follow… read more
Tim Mohr
Tim Mohr
ASE MASTER TECH
Master's Degree
650 satisfied customers
I am trying to replace the front struts on a 2004 Nissan Altima
I am trying to replace the front struts on a 2004 Nissan Altima 2.5S, but it seems like the inner CV joints will not slide back in to allow for the connection to the bottom of the strut. What is the s… read more
Jay
Jay
Shop Forman / Lead Tech
Vocational, Technical or Trade Scho
27,773 satisfied customers
2005 Nissan Altima: shudder..Manual Transmission..my tires..clutch
I noticed a shudder under acceleration in my 2005 Nissan Altima 3.5SE Manual Transmission after rotating my tires, and just a few weeks after a clutch replacement. I assumed that it was just the tires… read more
Jay
Jay
Shop Forman / Lead Tech
Vocational, Technical or Trade Scho
27,773 satisfied customers
94 Nissan Maxima: freeway..car starts to sort of shudder..vibrate
My 94 Nissan Maxima drives well and has 77K miles. When I go on the freeway and the speed gets to about 50 the car starts to sort of shudder or vibrate periodically.… read more
AutoTech08
AutoTech08
Workshop owner
Vocational, Technical or Trade Scho
676 satisfied customers
1993 Nissan Maxima GXE: 10,000 miles..shifts..Front wheels..braking
1993 Nissan Maxima GXE, 85,000 miles, remanufactured transmission installed about 10,000 miles ago. Car usually runs and shifts normally. Front wheels do not vibrate when free rolling or under braking… read more
AzNissanMaster
AzNissanMaster
High School or GED
64 satisfied customers
2002 Nissan Sentra: 55 to 60 mph and the steering wheels also shakes
I have a 2002 Nissan Sentra GXE. The wheels start shaking at 55 to 60 mph and the steering wheels also shakes at that speed. Other than that it drives ok. It does not click when I make sharp turns. Th… read more
Roy Sheidenberger
Roy Sheidenberger
12,882 satisfied customers
1996 Nissan Quest: I get a vibration..steering wheel..axle..rotors
On my 1996 Nissan Quest (140K miles) I get a vibration at about 60 mph. You feel it in the body as opposed to the steering wheel. I noticed this after the front passenger wheel bearing was replaced an… read more
Jason
Jason
Toyota Service Technician
Associate Degree
106 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I was in trouble with an electrical issue with my brand new Nissan. I frantically went online trying to find help and luckily I found your site. I reached a NISSAN tech named RIP. He was absolutely tremendous and helped me work through the issue. What a pro!

cjazLexington, KY

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.

CharlesWalnut Creek, CA

As a single woman, I really appreciate an excellent and affordable opinion.
Thank you Geordie, I will not hesitate to contact justanswer in the future!

SueCharleston, WV

Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.

JimCastleberry, FL

< Previous | Next >

Meet the Experts:

Chris(aka-Moose)

Chris(aka-Moose)

Nissan Technician

1,157 satisfied customers

24 years of experience diagnosing & repairing

Tim Mohr

Tim Mohr

ASE MASTER TECH

650 satisfied customers

30 YRS EXPERIENCE, FOREIGN AND DOMESTIC, GAS AND DEISEL

Marty

Marty

ASE Certified Technician

203 satisfied customers

ASE & Bosch master tech. 30 years experience.

Mike V.

Mike V.

Nissan Technician

10,242 satisfied customers

Nissan factory trained and Certified Subaru Technician.

Ron

Ron

ASE Certified Technician

727 satisfied customers

34 years of automotive Repair

Anthony

Anthony

ASE Certified Technician

332 satisfied customers

ASE Master Automobile Technician with over 18 years exp. in this field.

Richard

Richard

ASE Certified Technician

93 satisfied customers

Nissan Tech ASE certified technician

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x