Nissan

Nissan repair questions? Ask a mechanic for answers ASAP

Connect one-on-one with {0} who will answer your question

Related Nissan Questions
My manual shift 4x4 1991 nissan pickup will not go into
My manual shift 4x4 1991 nissan pickup will not go into neutral & will move just a little before engine kills. … read more
Roy Sheidenberger
Roy Sheidenberger
8,605 satisfied customers
I have a d40 navara when the engine warm up you have a noise
I have a d40 navara when the engine warm up you have a noise from the gear box when you mash in the clutch the noise go away and when you relese the clutch the noise come back what do you think is the… read more
Jay
Jay
Shop Forman / Lead Tech
Vocational, Technical or Trade Scho
25,454 satisfied customers
The engine shows as running lean,but has not responded to
Hello, The engine shows as running lean,but has not responded to changing the ECM, MAF,TPS PCV, knock sensor or EGR. The fuel pressure is fine at 40 psi. The #1 O2 sensor graphs flat lines with 30-degree angle changes in voltages (whereas my Honda CRV and Ford Focus graph normal "loping" voltage changes with the same OBD II). The engine will crank and run fine when cold, but when warm, it will show extreme changes in timing (6 to 39 degrees at idle, 18 to 40+ degrees at steady throttle on the highway. If I disconnect the TPS, the timing will run near dead flat at 18 degrees at idle. I installed the new TPS and it still shows variations, so no change there). Plugs, wires,cap and rotor were changed and it still ran fine cold, surged on the road, lost power or quit at intersections (shows extreme advanced or unstable timing when it loses power or quits). What next? … read more
Jake
Jake
5,680 satisfied customers
I have a 2003 Nissan Frontier XE with the 2.4 l engine and 5
Hi, I have a 2003 Nissan Frontier XE with the 2.4 l engine and 5 speed transmission. It has 112,000 miles on it and is used as a daily commuter. Recently I've noticed that my engine will rev from 1500… read more
Chad Farhat
Chad Farhat
Owner
Associate Degree
8,772 satisfied customers
There: and I am working on a 1997 Nissan 4x4 Cab XE with the
Hello, There: My name is ***** ***** I am working on a 1997 Nissan 4x4 King Cab XE with the 2400 4 cyl with a 5 speed transmission. I just replaced the clutch, pressure plate, throw out bearing, ect..… read more
Chris(aka-Moose)
Chris(aka-Moose)
Nissan Technician
Vocational, Technical or Trade School
991 satisfied customers
frontier: Ok I have a 2008 Nissan Frontier 4.0L with nearly
Ok I have a 2008 Nissan Frontier 4.0L with nearly 175,000 miles oon it. It seems like there is zero consistency with this "problem" but when idling in park or drive it seems to shake on occation. Some… read more
Jake
Jake
5,680 satisfied customers
Titan: I just purchased a heavily used (191k mi) 2004 Titan
I just purchased a heavily used (191k mi) 2004 Titan LE Crew Cab from a private party, I brought it to my dealer to have it inspected and had the rear axles rebuilt, and the oil cooler o-rings replace… read more
Matt
Matt
Engineer
Bachelor's Degree
17,363 satisfied customers
Frontier XE: I have a 2000 Nissan Frontier XE 4 cylinder 2wd
I have a 2000 Nissan Frontier XE 4 cylinder 2wd reg. cab with manual transmission and 200k miles. 3 days ago the transmission started making a noise on 1st gear when I would push in the clutch after I… read more
Jay
Jay
Shop Forman / Lead Tech
Vocational, Technical or Trade Scho
25,454 satisfied customers
1995 Nissan Pickup, 4x4, 4 cyl, manual transmission stuck in
1995 Nissan Pickup, 4x4, 4 cyl, manual transmission stuck in 5th gear. Truck will start with clutch pedal pushed in like normal, but when released, truck stall do to being in gear. Shifter does move t… read more
Ricardo Hohl
Ricardo Hohl
Auto Motive Instructor
Automotive tech
4,563 satisfied customers
Why does the clutch in the 2006 350 Z feel, and seem to engage,
Why does the clutch in the 2006 350 Z feel, and seem to engage, differently than other clutches I am use to in BMW, Toyota, Chevy? Does the pedal articulate differently? Is there an aftermarket clutch… read more
Dj
Dj
Auto Failure Analysis & Inspections
High School or GED
1,890 satisfied customers
2000 Nissan Frontier XE: quad cab..speed manual..first gear
I have a 2000 Nissan Frontier XE quad cab, 5 speed manual. I'm not able to get into first gear with out forcing it and then it makes a loud grinding noise. Is this a major repair I'm looking at or is … read more
Mike V.
Mike V.
Nissan Technician
Subaru and Nissan factory training.
9,929 satisfied customers
1995 Nissan: V6..4WD..Heads rebuilt at 156K bent valve..distributor
1995 Nissan XE V6 4WD 5 spd manual. Generally, runs well for a pickup with 170K. Heads rebuilt at 156K bent valve, timing chain worn and distributor wobbly as I recall. Tach is steady but I can sense … read more
HondaPlatinum
HondaPlatinum
Vocational, Technical or Trade School
25,791 satisfied customers
2001 Nissan Maxima SE: speed manual..first gear..shake..nuetral
I have a 2001 Nissan Maxima SE 20th Anniversary Edition ( 5 speed manual) with 128000 miles on it. For a month now, on cold starts, when in first gear, the car will shake front and back with a violent… read more
Rick
Rick
Master Technician (Team Leader)
Vocational, Technical or Trade Scho
503 satisfied customers
89 Nissan pickup: master and slave cylinder..disengage..hydralic
I have a 89 Nissan pickup, which I just replace the master and slave cylinder, but the clutch will not disengage. Is this a hydralic problem or a warn out clutch?… read more
Steve
Steve
Service Manager/ Technician
5,473 satisfied customers
2002 nissan: XE 4 cyl automatic and the check engine soon light came
I have a 2002 Nissian XE 4 cyl automatic and the check engine soon light came on today. How do I address that issue with out costing me lots of money? I can be reached [email protected]… read more
Mike V.
Mike V.
Nissan Technician
Subaru and Nissan factory training.
9,929 satisfied customers
1995 Nissan pickup: Manual transmission..4 wheel drive, 6 cyl..clutch
Manual transmission locked up on 1995 Nissan pickup (4 wheel drive, 6 cyl. engine). Original symptoms were chattering and burning smell... was waiting for clutch to go, but never experienced a lock-up… read more
Mike V.
Mike V.
Nissan Technician
Subaru and Nissan factory training.
9,929 satisfied customers
Air flow sensor..throttle position sensor..distributor..garage
I still need help. Update. Replaced air flow sensor, throttle position sensor, had to change out distributor, same problem, took by wrecker to a garage. He replaced coolant temperature sensor, now he … read more
JamesH
JamesH
Associate Degree
432 satisfied customers
Nissan 350z: a rattling noise coming from underneath..clutch..idling
i have a nissan 350z 2008 it has a rattling noise coming from underneath but when you step on the clutch the noise disappears. I took it to the dealer and they say that it is normal. why does it make … read more
Shimell
Shimell
Team Leader/ Master technician
Vocational, Technical or Trade Scho
363 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I was in trouble with an electrical issue with my brand new Nissan. I frantically went online trying to find help and luckily I found your site. I reached a NISSAN tech named RIP. He was absolutely tremendous and helped me work through the issue. What a pro!

cjazLexington, KY

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.

CharlesWalnut Creek, CA

As a single woman, I really appreciate an excellent and affordable opinion.
Thank you Geordie, I will not hesitate to contact justanswer in the future!

SueCharleston, WV

Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.

JimCastleberry, FL

< Previous | Next >

Meet the Experts:

Chris(aka-Moose)

Chris(aka-Moose)

Nissan Technician

991 satisfied customers

16 years of experience

Tim Mohr

Tim Mohr

ASE MASTER TECH

648 satisfied customers

30 YRS EXPERIENCE, FOREIGN AND DOMESTIC, GAS AND DEISEL

Marty

Marty

ASE Certified Technician

203 satisfied customers

ASE & Bosch master tech. 30 years experience.

Mike V.

Mike V.

Nissan Technician

9,929 satisfied customers

Nissan factory trained and Certified Subaru Technician.

Ron

Ron

ASE Certified Technician

662 satisfied customers

34 years of automotive Repair

Anthony

Anthony

ASE Certified Technician

332 satisfied customers

ASE Master Automobile Technician with over 18 years exp. in this field.

Richard

Richard

ASE Certified Technician

92 satisfied customers

Nissan Tech ASE certified technician

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x