Nissan

Nissan repair questions? Ask a mechanic for answers ASAP

Connect one-on-one with {0} who will answer your question

Related Nissan Questions
I have a 2005 Nissan Pathfinder LE that I just purchased
I have a 2005 Nissan Pathfinder LE that I just purchased with 260000 km. When you turn the ignition on and start it the VDC, SLIP, ABS, tire pressure, 4WD and CEL all come on and stay on. The display … read more
Gregg Lathem
Gregg Lathem
Consultant
Associate Degree
991 satisfied customers
Speedometer and rpm guage is not working. 1995. Nothing
speedometer and rpm guage is not working JA: What is the model/year of your Nissan? Customer: 1995 JA: Are you fixing your vehicle yourself? What have you tried so far? Customer: nothing JA: Anything … read more
Jay
Jay
Shop Forman / Lead Tech
Vocational, Technical or Trade Scho
27,760 satisfied customers
2008 Nissan Pathfinder SE v6, one of my kids drove it and it
2008 Nissan Pathfinder SE v6, one of my kids drove it and it blew one of the hoses and drove until it stopped. It immediately would not start. When it cooled it started okay. My mechanic replaced all … read more
Jay
Jay
Shop Forman / Lead Tech
Vocational, Technical or Trade Scho
27,760 satisfied customers
Code says VSS yet I replaced that and the Mileage/how fast
Hello code says VSS yet I replaced that and the Mileage/how fast I'm going has not moved. So I wonder if I change out the ECM if it will work … read more
Clifton B.
Clifton B.
nissan master auto tech
Associate Degree
5,464 satisfied customers
Just had the crankshaft sensor replaced Thursday (after some
Good afternoon - just had the crankshaft sensor replaced Thursday (after some major issue with "stalling" / surging) and it was one of the codes. The other code was around the system efficiency (Bank … read more
Jake
Jake
6,640 satisfied customers
1999 nissan frontier 3.3L 4wd (pre 4/99). speedometer went
1999 nissan frontier 3.3L 4wd (pre 4/99). speedometer went to zero and odometer stopped incrementing. P0500. Assuming VSS. Brfore I dig into it, I'm wondering what the difference is between the 25010-… read more
Jay
Jay
Shop Forman / Lead Tech
Vocational, Technical or Trade Scho
27,760 satisfied customers
2001 pathfinder wont rev up and misfire all time, 189K is
189K is steady. replaced all cam, crank sensors, replaced variable timming solenoid valve on bank 2. showing codes with P0340cam shaft sensofr on bank 1 which I already replaced with a new one and P1111 intake valve timing circuit bank one and the P1131 swirl control valve … read more
David Craig
David Craig
OWNER/MECHANIC
Associates
14,820 satisfied customers
Front left clicking sound when moving at slow speeds only
Front left clicking sound when moving at slow speeds only after cold start. Disappears after 5 minute warm up. clicking is proportional with speed. slow speed = slow click. faster speed = faster click… read more
Peter B.
Peter B.
master technition
Vocational, Technical or Trade School
2,293 satisfied customers
2000 Nissan Frontier SE - V-6 3L motor - well cared for
2000 Nissan Frontier SE - V-6 3L motor - well cared for -165,000 miles - few problems other than Knock Sensor and Distributor failure (injectors not working) which we fixed some time ago. Truck genera… read more
Jay
Jay
Shop Forman / Lead Tech
Vocational, Technical or Trade Scho
27,760 satisfied customers
I bought a 92 Nissan D21 Se 6 cyl 4wd w/ 3 speed auto trans (RE4R01A according to Chilton
I bought a 92 Nissan D21 Se 6 cyl 4wd w/ 3 speed auto trans (RE4R01A according to Chilton manual) Need to debug various issues to restore performance and mileage. 1. Overdrive does not engage switch a… read more
Jay
Jay
Shop Forman / Lead Tech
Vocational, Technical or Trade Scho
27,760 satisfied customers
Nissan Pathfinder: 2008 5.6 V-8 Pathfinder. Humming noise coming
2008 5.6 V-8 Pathfinder. Humming noise coming from rear of vehicle. Noise becomes audible at approx 30 mph and increases with speed. Noise is the same on accel and decel, in gear or in Neutral, Up hil… read more
Jay
Jay
Shop Forman / Lead Tech
Vocational, Technical or Trade Scho
27,760 satisfied customers
I have a 1997 nissan pathfinder 3.3 4X4 and I just installed
I have a 1997 nissan pathfinder 3.3 4X4 and I just installed a used engine. I bought it from a reputable store on ebay and the spark plugs were clean and it was apparently running good. Ive installed … read more
Tim\u0027s Auto Repair
Tim\u0027s Auto Repair
Mechanic
High School or GED
16,076 satisfied customers
i just had my engine piston rings changed, and we seem to have
i just had my engine piston rings changed, and we seem to have missed the timing chain arrangement for my 2002 VQ3.5 v6 nissan pathfinder. can someone help by providing the timing chain arrangement fo… read more
Tim\u0027s Auto Repair
Tim\u0027s Auto Repair
Mechanic
High School or GED
16,076 satisfied customers
Ive got a 1992 Nissan Pathfinder. Just recently, it started
I've got a 1992 Nissan Pathfinder. Just recently, it started having sporadic shifting problems. Sometimes it is fine, other times it won't shift beyond 2nd gear. Any ideas?… read more
HondaPlatinum
HondaPlatinum
Vocational, Technical or Trade School
27,972 satisfied customers
Pathfinder: v6..4X4..Fuel starts cutting out at 2800 rpm..Runs great
1987Nissan Pathfinder, v6, 4X4. Fuel starts cutting out at 2800 rpm. Runs great at lower rpm. Ejectors replaced & ECU changed. Ran great for a few weeks, then started cutting out at 2800 rpm again.… read more
HondaPlatinum
HondaPlatinum
Vocational, Technical or Trade School
27,972 satisfied customers
93 Infiniti J30: even fire..injectors..crank position sensor..rotated
My sister's '93 Infiniti J30 with 3.0 quit suddenly. Now it will not start or even fire. It has 40 psi fuel and injectors click and #1 plug fires when crank position sensor is rotated. There is no spa… read more
Amedee
Amedee
Automotive Consultant
Vocational, Technical or Trade Scho
24,602 satisfied customers
1998 Pathfinder: speedometer..the highway..speedo..check engine light
My 1998 Pathfinder speedometer won't work (set idle at 0 mph) unless the vehicle is going 50 mph on the highway for fews minutes. Soon get off the highway and go under 50 mph and the speedo set idel a… read more
Jay
Jay
Shop Forman / Lead Tech
Vocational, Technical or Trade Scho
27,760 satisfied customers
I have a 1995 4wd 4 cyl 5 speed..seal..grinding noise
i have a 1995 4wd 4 cyl 5 speed. i drain the transfluild and found a chipped gerar and broken snap rings. now the front seal is leaking, and obviously a grinding noise can be hgeard. especially when t… read more
Louis138
Louis138
Aviation Structural Technician
Bachelor's Degree
22 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I was in trouble with an electrical issue with my brand new Nissan. I frantically went online trying to find help and luckily I found your site. I reached a NISSAN tech named RIP. He was absolutely tremendous and helped me work through the issue. What a pro!

cjazLexington, KY

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.

CharlesWalnut Creek, CA

As a single woman, I really appreciate an excellent and affordable opinion.
Thank you Geordie, I will not hesitate to contact justanswer in the future!

SueCharleston, WV

Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.

JimCastleberry, FL

< Previous | Next >

Meet the Experts:

Chris(aka-Moose)

Chris(aka-Moose)

Nissan Technician

1,157 satisfied customers

24 years of experience diagnosing & repairing

Tim Mohr

Tim Mohr

ASE MASTER TECH

650 satisfied customers

30 YRS EXPERIENCE, FOREIGN AND DOMESTIC, GAS AND DEISEL

Marty

Marty

ASE Certified Technician

203 satisfied customers

ASE & Bosch master tech. 30 years experience.

Mike V.

Mike V.

Nissan Technician

35,963 satisfied customers

Nissan factory trained and Certified Subaru Technician.

Ron

Ron

ASE Certified Technician

727 satisfied customers

34 years of automotive Repair

Anthony

Anthony

ASE Certified Technician

332 satisfied customers

ASE Master Automobile Technician with over 18 years exp. in this field.

Richard

Richard

ASE Certified Technician

93 satisfied customers

Nissan Tech ASE certified technician

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x