Nissan

Nissan repair questions? Ask a mechanic for answers ASAP

Connect one-on-one with {0} who will answer your question

Related Nissan Questions
Thanks for any info sent. Working on 2008 pathfinder v6 4.0.
Hi, thanks for any info sent. Working on 2008 pathfinder v6 4.0 . My scan tool is reading 2.3 pos volts and fluctuations slightly lower . Open or closed loop! Have a code p0430 . O2 sensors are suppos… read more
Bradley Jordan
Bradley Jordan
Retired
diploma
265 satisfied customers
I conected the scanner and said operation error, i the codes
hi, i conected the scanner and said operation error, i toke the codes with flashing enging light and the code it's u 1000 … read more
Julio Quispe
Julio Quispe
181 satisfied customers
P1273 code STFT bank 1 +8 at idle and increases as rpm
P1273 code STFT bank 1 +8 at idle and increases as rpm increases … read more
Jake
Jake
5,278 satisfied customers
2004 Titan. codes p1148 p1031 p1278 &p1279 replaced upstream
2004 Titan. codes p1148 p1031 p1278 &p1279 replaced upstream O2 on bank 1 and now showing p1148 and p1031 … read more
Jay
Jay
Shop Forman / Lead Tech
Vocational, Technical or Trade Scho
23,910 satisfied customers
Very rough idle after replacing head cover gaskets on 2005
Very rough idle after replacing head cover gaskets on 2005 Nissan Xterra. I found online that I need to do 3 procedures after unplugging throttle body etc. 1)Accelerator Pedal Released Position Learni… read more
Jake
Jake
5,278 satisfied customers
I'm getting code P0030 found out it's the heated fault of o2
Chris , I'm getting code P0030 found out it's the heated fault of o2 sensors. I ohmed both o2 sensors pins 3&4 and they are closed loop. So i believe they are good. Then I checked connectors pins 3&4 … read more
rpmdiag
rpmdiag
High school
9,140 satisfied customers
How do I complete a drive cycle for a 2004 nissan Murano to
How do I complete a drive cycle for a 2004 nissan Murano to get the 02 sensors to pass smog… read more
6Bucs
6Bucs
Senior Master Tech
Associate Degree
1,349 satisfied customers
The engine shows as running lean,but has not responded to
Hello, The engine shows as running lean,but has not responded to changing the ECM, MAF,TPS PCV, knock sensor or EGR. The fuel pressure is fine at 40 psi. The #1 O2 sensor graphs flat lines with 30-degree angle changes in voltages (whereas my Honda CRV and Ford Focus graph normal "loping" voltage changes with the same OBD II). The engine will crank and run fine when cold, but when warm, it will show extreme changes in timing (6 to 39 degrees at idle, 18 to 40+ degrees at steady throttle on the highway. If I disconnect the TPS, the timing will run near dead flat at 18 degrees at idle. I installed the new TPS and it still shows variations, so no change there). Plugs, wires,cap and rotor were changed and it still ran fine cold, surged on the road, lost power or quit at intersections (shows extreme advanced or unstable timing when it loses power or quits). What next? … read more
Jake
Jake
5,278 satisfied customers
I drove over 300 miles with speeds over 50 mph but my computer
i drove over 300 miles with speeds over 50 mph but my computer is still ready to be inspected. Co2 and catalyst not ready… read more
internal88
internal88
Product Manger
Bachelor's Degree
3,342 satisfied customers
I have a 2005 Altima 3.5. Within the past year I have
I have a 2005 Altima 3.5. Within the past year I have replaced the Throttle body due to a bad Throttle Position Sensor, the cam shaft position sensors, spark plugs, transmission control module among v… read more
Mike V.
Mike V.
Nissan Technician
Subaru and Nissan factory training.
9,761 satisfied customers
Quest: i bought a 2004 Nissan Quest 3.5L SE. I purchased this
i bought a 2004 Nissan Quest 3.5L SE. I purchased this vehicle with the check engine light on. I hooked up my OBD reader to it and it gave me the two codes which were P-1148 and P-1168 ( NO DFC DEFINI… read more
Jake
Jake
5,278 satisfied customers
Altima: 08 Altima 3.5, will a bad, rear upstream O2 sensor
08 Altima 3.5, will a bad, rear upstream O2 sensor throw a specific code? I am getting the lean bank 1 code and poor gas mileage and assume this is the issue. The sensor is $120. and want to be sure t… read more
jazzmaster
jazzmaster
LEAD AUTO TECH
Vocational, Technical or Trade Scho
2,873 satisfied customers
Sentra: Working on a friend's 2006 Nissan Sentra 1.8, automatic
Working on a friend's 2006 Nissan Sentra 1.8, automatic transmission. The owner stopped using the car some time last year after unknown driveability problems (as in, can't really describe). Battery di… read more
Mike V.
Mike V.
Nissan Technician
Subaru and Nissan factory training.
9,761 satisfied customers
Nissan/Datsun Quest GXE: I have nissan scandata. The O2s show
I have nissan scandata. The O2s show engine run lean but has -10 lft and -15 sft. the active test of cut off cylinders show 1,3,5 work fine but 2,4,6 are weak. swapped injector from 6 to 2. 2 run bett… read more
Jake
Jake
5,278 satisfied customers
2.0SL: 2007 sentra I use to get 39 to 41 MPG on highway trips,
2007 sentra I use to get 39 to 41 MPG on highway trips, now 29 to 31. What is the problem. 129500 miles in the sentra. Bill… read more
BOBBYSS
BOBBYSS
Automotive Repair/Damage Investigator
Associate Degree
14,694 satisfied customers
Nissan/Datsun Maxima SL: 2004 Nissan Maxima, 3.5L engine, 112kmiles.
2004 Nissan Maxima, 3.5L engine, 112kmiles. Engine light on. Used Actron AutoScanner Plus to read codes and view freeze data. Error code P1168 (Closed Loop Bank 2) indicates high values for upstream O… read more
I. Silva
I. Silva
High School or GED
1,349 satisfied customers
1999 nissan quest: check engine light..o2 sensor..knock sensor..van
my 1999 nissan quest van check engine light is on and it is coding #p1148 closed loop, #p0130 o2 sensor bank 1, circuit 1, and # XXXXX knock sensor. van is running great and the only thing that is wro… read more
NicksSticks
NicksSticks
Vocational, Technical or Trade Scho
1,430 satisfied customers
1996 Nissan Pickup: automatic 2wd..stay running..dies..1000 rpm
1996 Nissan Pickup 2.4 automatic 2wd my buddy bought this off of a used car lot and its been running REALLY crummy. its got a HUGE miss at idle and will barely stay running in gear. it starts bucking … read more
Infiniti Brian
Infiniti Brian
Infiniti Master Technician
Vocational, Technical or Trade Scho
97 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I was in trouble with an electrical issue with my brand new Nissan. I frantically went online trying to find help and luckily I found your site. I reached a NISSAN tech named RIP. He was absolutely tremendous and helped me work through the issue. What a pro!

cjazLexington, KY

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.

CharlesWalnut Creek, CA

As a single woman, I really appreciate an excellent and affordable opinion.
Thank you Geordie, I will not hesitate to contact justanswer in the future!

SueCharleston, WV

Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.

JimCastleberry, FL

< Previous | Next >

Meet the Experts:

Chris(aka-Moose)

Chris(aka-Moose)

Nissan Technician

921 satisfied customers

16 years of experience

Tim Mohr

Tim Mohr

ASE MASTER TECH

630 satisfied customers

30 YRS EXPERIENCE, FOREIGN AND DOMESTIC, GAS AND DEISEL

Marty

Marty

ASE Certified Technician

202 satisfied customers

ASE & Bosch master tech. 30 years experience.

Mike V.

Mike V.

Nissan Technician

9,761 satisfied customers

Nissan factory trained and Certified Subaru Technician.

Ron

Ron

ASE Certified Technician

625 satisfied customers

34 years of automotive Repair

Anthony

Anthony

ASE Certified Technician

332 satisfied customers

ASE Master Automobile Technician with over 18 years exp. in this field.

Richard

Richard

ASE Certified Technician

92 satisfied customers

Nissan Tech ASE certified technician

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x