Motorcycle

Motorcycle questions? Ask a mechanic.

Connect one-on-one with {0} who will answer your question

Related Motorcycle Questions
86 shadow 1100 fouls plugs with a thin glossy black film after
86 shadow 1100 fouls plugs with a thin glossy black film after a few short run cycles. becomes a hard start, change plugs and off we go. Have kit'ed carbs. Emulsion tubes were clogged with crusty stuf… read more
Wayne S.
Wayne S.
Motorcycle Mechanic
Fully Licensed Motorcycle Mechanic
1,435 satisfied customers
harley motor been rebuilt has a mikuni carby..hills lose power
hi mate i have a 1942 sevi car 750cc harley motor been rebuilt has a mikuni carby main jet 140 idel jet 35 i have trouble going up hills lose power any idear or should i go back to original carby… read more
Steve
Steve
Motorcycle Mechanic
Vocational, Technical or Trade Scho
7,602 satisfied customers
I have a 1980 ski doo blizzard 5500, mint condition I ran it
I have a 1980 ski doo blizzard 5500, mint condition I ran it last year just fine,this year it will start just fine and it will run for about ten seconds after starting then will shut of like as if shu… read more
Bike-Doc
Bike-Doc
senior motorcycle technician
Vocational, Technical or Trade Scho
671 satisfied customers
much higher exhaust temp on the rear cylinder..Bike is fitted
My 98 Softtale has a much higher exhaust temp on the rear cylinder. There is obvious discolouration visible after a short ride abut a foot from the end of the pipe. Bike is fitted with a 42mm Mikuni .… read more
.......
.......
Vocational, Technical or Trade Scho
211 satisfied customers
2006 Honda: back together..idiot left the key..I jumped the bike
Hear is an awesome problem for you. I recently painted my 2006 Honda VTX 1300 S. I put it back together and like an idiot left the key in the ignition and killed the battery. I jumped the bike and rod… read more
Eric
Eric
technician
Vocational, Technical or Trade Scho
1,573 satisfied customers
1995 flstn, just had 10:1 pistons and a S&S 520 cam instaled...jets
I have a 1995 FLSTN, just had 10:1 pistons and a S&S 520 cam instaled. Still in the break in period. What jets would you suggest? I installed a dynojet kit and it has 44 slow jet with main jet 180. it… read more
Steve
Steve
Motorcycle Mechanic
Vocational, Technical or Trade Scho
7,602 satisfied customers
ride..onto the main highway and reach speeds of around 60 to 70..die
I have a 2005 VL1500 c90 that I used to ride to work. Three miles from my house I would get onto the main highway and reach speeds of around 60 to 70 for about 5 to 10 seconds before it would begin to… read more
Eric
Eric
technician
Vocational, Technical or Trade Scho
1,573 satisfied customers
When i open my oil cap, air is pulsing..bike yesterday..stalling..revs
When i open my oil cap, air is pulsing in and out as the engine idles, is this normal? I had trouble with the bike yesterday when i rode it home. It keep stalling if i didnt keep the revs up and was v… read more
Wayne S.
Wayne S.
Motorcycle Mechanic
Fully Licensed Motorcycle Mechanic
1,435 satisfied customers
back cylinder, on a 107 ci S&S engine when backing off on the trottle
How do I eliminate back fireing from the back cylinder, on a 107 CI S&S engine when backing off on the trottle ?… read more
Steve
Steve
Motorcycle Mechanic
Vocational, Technical or Trade Scho
7,602 satisfied customers
My secondary air supply system on my 1984 gold wing what..run properly
removed my secondary air supply system on my 1984 gold wing what modifications are needed to make it run properly… read more
Ski Doctor
Ski Doctor
Owner, operator
Vocational, Technical or Trade Scho
530 satisfied customers
honda: 1987 cr 125 it runs good..too rich..working correctly
I have a 1987 cr 125 it runs good in low end but fouls plugs even when i use a b8es. I have had it bored to 30 over and it seems to be running way too rich at the honda recomended 32 to one. The apc v… read more
MrHonda
MrHonda
Vocational, Technical or Trade Scho
398 satisfied customers
73 honda: bike runs on 3 out of four cyl.,right side plug fouls..soot
73 honda cb500,bike runs on 3 out of four cyl.,right side plug fouls out and its black with soot… read more
Wayne S.
Wayne S.
Motorcycle Mechanic
Fully Licensed Motorcycle Mechanic
1,435 satisfied customers
48 pilot: Tune..I recently opened up the air flow, and put
Hi, I have a 2006 standard XL-883 with 9000 miles on the clock. Tune-ups were done at required intervals. I recently opened up the air flow, and put in a #48 pilot jet. All was good till yesterday: af… read more
.......
.......
Vocational, Technical or Trade Scho
211 satisfied customers
Correct sequence to adjust Mikuni carb VM 44 for a skidoo 670
Correct sequence to adjust Mikuni carb VM 44 for a skidoo 670 summit snowmachine. It starts up good but runs rich and fouls spartk plugs.… read more
Wayne S.
Wayne S.
Motorcycle Mechanic
Fully Licensed Motorcycle Mechanic
1,435 satisfied customers
engine starts..dies..48 makoni carb Iv tried adjusting the needle
my 75 johnson skimmer 650cc snowmobile engine starts them bogs and dies its not losing spark it has a 48 makoni carb Iv tried adjusting the needle the idle ajust screw the air jet or high rpm screw to… read more
.......
.......
Vocational, Technical or Trade Scho
211 satisfied customers
cv..kit..mikuni hsr 42mm) will it work with my stock intake and seal
i have a 2002 fatboy it has a cv carb i ran av-gas and got partlices of the line in the carb, broke it down, cleaned & installed a new kit. didn't run right, so i want to change my carb with a new car… read more
.......
.......
Vocational, Technical or Trade Scho
211 satisfied customers
Have a Harley 2001 883 sportster...start back riding..bad gas
Have a Harley 2001 883 Sportster. Have not rode in a couple of months but when I did start back riding, it started fouling plugs every few days. Could this be a fuel problem with bad gas or the gas je… read more
Motorcycle Tech
Motorcycle Tech
1,297 satisfied customers
I put a REV-TECH 110 enjine in my custom harley with a HSR ...
I put a REV-TECH 110 enjine in my custom harley with a HSR 45 mikuni and as I adjust the pilot air screw it revs higher the farther in it goes with the highest idle all the way in and I have tried lar… read more
.......
.......
Vocational, Technical or Trade Scho
211 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.

CharlesWalnut Creek, CA

As a single woman, I really appreciate an excellent and affordable opinion.
Thank you Geordie, I will not hesitate to contact justanswer in the future!

SueCharleston, WV

Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.

JimCastleberry, FL

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

< Previous | Next >

Meet the Experts:

Jeff Policky

Jeff Policky

Motorcycle Mechanic

2,425 satisfied customers

Yamaha Gold, Suzuki Gold, Honda Bronze, Polaris Bronze, BRP

TIMOTO

TIMOTO

Motorcycle Mechanic

1,305 satisfied customers

Honda registered technician, silver level award, former Kawasaki/Suzuki tech, 40+ years exp.

Andre Pilon

Andre Pilon

Motorcycle Mechanic

1,044 satisfied customers

Over 25 years experience, ICS, MMI, Owned shop for 12 years, worked tech-support for Harley Davidson

Kenny O.

Kenny O.

Motorcycle, ATV, Mules, Side by Side's Product Specialist. All Brands

619 satisfied customers

Worked for Kawasaki Motors as a Product Support Specialist (Factory Support) for 24 years

asphaltcycles

asphaltcycles

Motorcycle Mechanic

468 satisfied customers

I operate a motorcycle dealership and CCS Ducati Race team.

Glenn Adams II

Glenn Adams II

Motorcycle/ATV Technician

393 satisfied customers

6 years Motorcycle/ATV/Water Craft; 4 years auto; 18 years carpenter

kwiggins29059

kwiggins29059

Motorcycle Mechanic

320 satisfied customers

Experience in Harley Davidson and Triumph

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x