How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Doug Your Own Question
Doug
Doug, ASE Certified Technician
Category: Mitsubishi
Satisfied Customers: 6963
Experience:  Mitsubishi employed and Factory trained ASE certified technician
21364095
Type Your Mitsubishi Question Here...
Doug is online now
A new question is answered every 9 seconds

After changing waterpump timing belts, my car started, then

Customer Question

after changing waterpump timing belts, my car started, then would not start start again. I put a code reader on it and get a "P0335 crank position sensor a circuit error" Did i damage the sensor when changing the timing belts?
Submitted: 5 months ago.
Category: Mitsubishi
Expert:  Gunvir Singh replied 5 months ago.

Hello, does the engine turn oner strong?

Customer: replied 5 months ago.
Turns over normal. but will not fire.
Customer: replied 5 months ago.
Turns over fine. Will not fire.
Expert:  Gunvir Singh replied 5 months ago.

Since the problem occured after timing belt replacement. Need to make sure timing marks line up. If good, check the crank sensor connector for bent pins or bad connection.