How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Doug Your Own Question
Doug, ASE Certified Technician
Category: Mitsubishi
Satisfied Customers: 6953
Experience:  Mitsubishi employed and Factory trained ASE certified technician
Type Your Mitsubishi Question Here...
Doug is online now
A new question is answered every 9 seconds

Mitsubishi Endeavor: DougI have a 2006 Mitsubishi endeavor

Customer Question

I have a 2006 Mitsubishi endeavor that will not start changed the timming belt and tensioner because tensioner was making alot of noise after changing the belt and tensioner kicks a p0335 code and no spark injector pulse or fuel pump
Submitted: 2 years ago.
Category: Mitsubishi
Expert:  Doug replied 2 years ago.
The p0335 is certainly of utmost concern since it will result in no spark, no injector pulse and no fuel pump operation.
When you examine the crank position sensor harness that runs down the front of the engine behind the accessory belts, there is no indication that one of the belts hit it right?
Customer: replied 2 years ago.
Expert:  Doug replied 2 years ago.
I apologize if we have to do a little re-checking here.
Please unplug the crank sensor and confirm for me you have one wire with 12V and one wire with 5V when the key is on (Again sensor is unplugged).
Customer: replied 2 years ago.
yes i do
Expert:  Doug replied 2 years ago.
Please plug the sensor back in and back probe the 5V wire. Then use a ratchet to rotate the engine by hand clockwise (do not use the starter) and tell me what your peak voltages are up and down.
Customer: replied 2 years ago.
switches back and forth from 4.97 to .03
Expert:  Doug replied 2 years ago.
Is there anything else you might be leaving out? For example you replaced the crank or cam sensor too, or you are using a different key than before, etc?
Customer: replied 2 years ago.
will have to continue this later got to go on a road call
Expert:  Doug replied 2 years ago.
No problem.