Mitsubishi

Mitsubishi repair problems? Ask a mechanic for answers ASAP

Connect one-on-one with {0} who will answer your question

Related Mitsubishi Questions
Automatic Transmission isn't pulling. Gear shifter and gear
Automatic Transmission isn't pulling. Gear shifter and gear indicator move, but transmission never engages. Has plenty of fluid … read more
Daniel Chaidez
Daniel Chaidez
Technician
Diploma
3,384 satisfied customers
Turns over but wont start. cleaned out tank of bad gas but
turns over but wont start. cleaned out tank of bad gas but still wont start. was running fine when parked it to replace front brakes,but would not start when brakes were finished … read more
Amedee
Amedee
Automotive Consultant
Vocational, Technical or Trade Scho
22,610 satisfied customers
Car starts but won't idle just dies..sputters..getting error
Car starts but won't idle just dies..sputters..getting error code P0335 cam shaft position shaft a circuit … read more
Chris Carr
Chris Carr
Ase Master
Ase Master Tech
463 satisfied customers
My fuel pump amd injectors are not firing. the pump works as
My fuel pump amd injectors are not firing. the pump works as I grounded the pump but the injectors are not firing … read more
Greg
Greg
Shop owner, technician
Vocational, Technical or Trade Scho
7,113 satisfied customers
P0335. Replaced crankshaft position sensor but code
P0335. Replaced crankshaft position sensor but code persists. … read more
Matt
Matt
Engineer
Bachelor's Degree
17,642 satisfied customers
P0335 and P0340 simultaneously, 2003 Eclipse GTS, 3.0l V6,
Those two codes along with P0134 (O2 sensor), P0171 (System Lean), and P0660 (intake manifold tuning valve) all popped up simultaneously after doing some work on the brakes, cam cover gasket, and serpentine belt. Engine suffered a loss of power and rough idling, after working on it the last few weekends I've replaced the O2 sensor, front and rear spark plugs/wires/gaskets, and emission solenoid and cleared up all the codes except the cam and crank sensor codes but the engine is still suffering the same problems as before so I'm assuming these last two codes must be the source of the problem. Any advice? I was going to try getting the timing belt replaced next. … read more
Chad Farhat
Chad Farhat
Owner
Associate Degree
9,521 satisfied customers
Won't start throws code p0340 and when it did start it would
Won't start throws code p0340 and when it did start it would rev to full throttle then fry the distributor. Have put two new distributors on it new crank sensor map sensor IAC valve and MAF sensor … read more
Jake
Jake
6,000 satisfied customers
Someone messed w my relays or fuses! New fuel pump
Someone messed w my relays or fuses! New fuel pump ,distributor cap and button ,plugs, wires, crank shaft sensor, … read more
sprinkles08
sprinkles08
Technician
High School or GED
19,846 satisfied customers
The mits falls on its face above 2500 rpm and was running
the mits falls on its face above 2500 rpm and was running great before I had changed the MAP with a new one. All has been changed at a dealership and the engine crankshaft sensor which had corrected t… read more
Chris (aka- Moose)
Chris (aka- Moose)
Technician
Vocational, Technical or Trade School
373 satisfied customers
Mitsubishi Eclipse Spyder GS: 2001 Eclipse spider 2.4 dies
2001 Eclipse spider 2.4 dies with P0335 Crankshaft position sensor. Replaced sensor, timing belts, tensioner & water pump. Failed again with same code within 11 miles. What could the problem be?… read more
Doug
Doug
ASE Certified Technician
Vocational, Technical or Trade Scho
7,006 satisfied customers
Mitsubishi Eclipse GT: I have a 2002 eclipse v6 3.0. I put
I have a 2002 eclipse v6 3.0. I put a new motor in it and changed timing belt. It is throwing a p0171, p0175, p0134, p0340, and p0335. I have checked the timing belt and all the marks look like they a… read more
Doug
Doug
ASE Certified Technician
Vocational, Technical or Trade Scho
7,006 satisfied customers
Mitsubishi Eclipse RS: i did an engine swap on my 2002 eclipse
i did an engine swap on my 2002 eclipse 2.4l. runs but give 2 error codes p0335 and p0340. I believe the replacement engine is a 2003. I put in a ecu from a 2003 and now get p0315 incorrect immobilize… read more
Doug
Doug
ASE Certified Technician
Vocational, Technical or Trade Scho
7,006 satisfied customers
Mitsubishi eclipse sypder gt: Hey Doug..you helped me with
Hey Doug..you helped me with my cps last year. Driving my eclipse 3.0 this morning and it stalled. I was low on gas and thought that was my issue. Put gas in but still wold not start until cooled down… read more
Doug
Doug
ASE Certified Technician
Vocational, Technical or Trade Scho
7,006 satisfied customers
Mitsubishi Eclipse Spyder GT: I have a 2002 Mitsubishi Eclipse
I have a 2002 Mitsubishi Eclipse Spyder GT 3.0 V6. It ran fine with the exception of a service engine soon light with the code for a misfire in cylinder 3. After letting this car sit for the winter, I… read more
Doug
Doug
ASE Certified Technician
Vocational, Technical or Trade Scho
7,006 satisfied customers
Mitsubishi Eclipse Spyder GT: Im getting no spark on 2001
I'm getting no spark on 2001 Eclipse spyder 3.0. It's throwing p0340/p0335 codes(cam/cps). Would either cause no spark?… read more
Doug
Doug
ASE Certified Technician
Vocational, Technical or Trade Scho
7,006 satisfied customers
Mitsubishi Eclipse GT: 2003 Eclipse GT 3.0 codes 0175, 0171,
2003 Eclipse GT 3.0 codes 0175, 0171, 0134, 0340, 0335. Car runs great. Replaced both 0175 and 0171 sensors. Codes still on. All codes clear but come back on after just a second of running.… read more
Doug
Doug
ASE Certified Technician
Vocational, Technical or Trade Scho
7,006 satisfied customers
Mitsubishi Eclipse GS: 2002 Eclipse. new reman head and now
2002 Eclipse. new reman head and now have p0340 p0335 reoccuring. Scoped both at same time and in spec for hz readings. Both now new sensors and new timing tensioner n belt. Ran additional ground to h… read more
Doug
Doug
ASE Certified Technician
Vocational, Technical or Trade Scho
7,006 satisfied customers
2002 eclipse: dtc..harness from sensor to pcm.harness checks..volt
2002 eclipse 2.4 dtc 340 cam circut.allready replaced cam sensor.code resets.ohmed the harness from sensor to pcm.harness checks good.b+ 5 volt refference,and ground ok.do you have any sugestions.… read more
Doug
Doug
ASE Certified Technician
Vocational, Technical or Trade Scho
7,006 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.

CharlesWalnut Creek, CA

As a single woman, I really appreciate an excellent and affordable opinion.
Thank you Geordie, I will not hesitate to contact justanswer in the future!

SueCharleston, WV

Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.

JimCastleberry, FL

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

< Previous | Next >

Meet the Experts:

Doug

Doug

ASE Certified Technician

7,006 satisfied customers

Mitsubishi employed and Factory trained ASE certified technician

Chris (aka- Moose)

Chris (aka- Moose)

Technician

373 satisfied customers

24 years of experience diagnosing & repairing

George H.

George H.

ASE Certified Technician

321 satisfied customers

ASE Master tech 15+ years

Tim Mohr

Tim Mohr

ase master

230 satisfied customers

30 yrs foriegn and domestic, gas and diesel

Don - Mo Lurch

Don - Mo Lurch

Mitsubishi Mechanic

60 satisfied customers

16 years, Line Mechanic, Electronics trouble shooting, etc

AMD

AMD

Master Technician

48 satisfied customers

L1 Advanced Level Diagnostics Specialist

BigBob

BigBob

Service manager/Technician

46 satisfied customers

25 years in the auto repair business

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x