Connect one-on-one with a Mercury expert who will answer your question
Expert avatar
Chris (aka- Moose), Mercury Technician
2,068 satisfied customers
16 years experience with Mercury
Pearl avatarPearl Wilson, Assistant
10 Mercury Mechanics are Online Now

Need help with a Mercury? Ask a technician now.

Verified Mercury experts are online around the clock and ready to answer your question online or by phone. 
Related Mercury questions
NO power to new fuel pump just installed. Consistent. 2002
i've run a wire from the fuse box by the battery over to the fuel pump relay… read more
Kenny Z.
Kenny Z.
Ford Senior Master Technician
High School or GED
6,091 satisfied customers
The wrench light came on. It then starts to drag/reduced
The wrench light came on. It then starts to drag/reduced acceleration … read more
Gregg Lathem
Gregg Lathem
Consultant
High School Diploma
29 satisfied customers
Man I replaced my ignition coil a week ago. Service engine
Man I replaced my ignition coil a week ago. Service engine soon light went of. A couple of days later the light came back on. AutoZone diagnost it for me and said it was the intake manifold gasket. A … read more
Chris Carr
Chris Carr
Ase Master
Ase Master Tech
109 satisfied customers
The abs and brake light flashed on for a half second. System
The abs and brake light flashed on for a half second … read more
Gregg Lathem
Gregg Lathem
Consultant
High School Diploma
29 satisfied customers
Lift gate wont open. Monterey 2005. I switched off the power
I switched off the power door lockout from the inside lift gate access panel … read more
Chris (aka- Moose)
Chris (aka- Moose)
Mercury Technician
Vocational, Technical or Trade School
2,068 satisfied customers
Heater is blowing cold air. Coolant level is good and I
yes, coolant level is good and I can't hear any hissing like a vacuum leak … read more
Chris Hermosillo
Chris Hermosillo
Level 2 gasoline tech
16 satisfied customers
I have a 2006 Mercury Milan 3.0L Its having some trouble.
I have a 2006 Mercury Milan 3.0L Its having some trouble. Sometimes stalls, sometimes jumps when acccelerating, sometimes hard to start after stall. I just threw a code. P2105 and P0320. I have replac… read more
Ethan Lankford
Ethan Lankford
Self Employed
Diploma
122 satisfied customers
I have a 2006 Mercury Milan and it was diagnosed with miss
I have a 2006 Mercury Milan and it was diagnosed with miss firing, I've replaced the spark plugs and coils but, it still runs the same; upon cranking it up the vehicle vibrates, rides like its being f… read more
rpmdiag
rpmdiag
High school
8,125 satisfied customers
We just replaced the starter on our 2002 mercury cougar v6
We just replaced the starter on our 2002 mercury cougar v6 2.5L. After reconnecting everything, the car wont start but not like before. Now it tries but it just kind is whines and then the positive ba… read more
Pete
Pete
Automotive Diagnostic Specialist
General auto certifications
30,287 satisfied customers
Misses near top of hills,not much just a few times.Spits
Misses near top of hills,not much just a few times.Spits back or falters if you accelerate hard.New fuel filter plugs coil and wires … read more
Chris (aka- Moose)
Chris (aka- Moose)
Mercury Technician
Vocational, Technical or Trade School
2,068 satisfied customers
2008 mercury grand marquis. engine light came on. went to
2008 mercury grand marquis. engine light came on. went to local auto zone. they checked out code PO456. said I needed canister vent valve solenoid. Special order part. told it was easy to replace on t… read more
Mike
Mike
24 satisfied customers
2006 Mercury Grand Marquis rear brake hose to caliper banjo
2006 Mercury Grand Marquis rear brake hose to caliper banjo bolt torque spec needed: I'm on the road without manuals and had to do an emergency caliper rebuild. I'm using a new OEM 385116-S2 3/8"-24x1… read more
Ron Z.
Ron Z.
- Mercury Tech -
Vocational, Technical or Trade Scho
297 satisfied customers
I need to replace the starter on my 2002 mercury cougar v6
I need to replace the starter on my 2002 mercury cougar v6 2.5L. … read more
Mike V.
Mike V.
technician
Subaru and Nissan factory training.
27,687 satisfied customers
I got cut off, my fault. Mercury grand marquis. How I remove
Pearl,I got cut off, my fault. Mercury grand marquis. How I remove the light control module? 2005 grand Marquis. self repair. If I get it out, I can put it back. … read more
Chris (aka- Moose)
Chris (aka- Moose)
Mercury Technician
Vocational, Technical or Trade School
2,068 satisfied customers
I have a 2009 mercury milan and it leaks on the inside.
I have a 2009 mercury milan and it leaks on the inside … read more
Jay
Jay
Shop Forman / Lead Tech
Vocational, Technical or Trade Scho
22,047 satisfied customers
2008 mercury sable. Heat and temp control works fine on
2008 mercury sable. Heat and temp control works fine on driver side. Only high heat on passenger side. A/C works fine both sides. … read more
Randall C
Randall C
Auto Technician / Consultant
Vocational, Technical or Trade Scho
12,714 satisfied customers
Blower motor runs fine from direct wire to battery but not
blower motor runs fine from direct wire to battery but not when heat is turned on...switch is a wheel type...switch or resister unit ??? … read more
6Bucs
6Bucs
Senior Master Tech
Associate Degree
1,174 satisfied customers
Need to remove a 6cd changer on a 08 mariner tonight, and
need to remove a 6cd changer on a 08 mariner tonight, and need to know what i need for tools or do you have a procedure link? … read more
Tim's Auto Repair
Tim's Auto Repair
mechanic
High School or GED
333 satisfied customers

How to get help keeping your Mercury on the road


The certified Mercury Experts on JustAnswer have dealt with a multitude of vehicular issues and questions. Some of these include:


  • My digital dashboard lights go out when it gets dark outside.
  • My 2003 Mercury Sable's fuel gauge won't read as full. I just replaced the fuel pump, and it was doing this since before the replacement.
  • The car's RPM seems to run oddly at higher speeds
  • My 2003 Mercury Grand Marquis' check engine light keeps turning on. The car stutters when I step on the gas, and has a hard time moving.
  • The low oil pressure light turns on after the car warms up, around 1000 RPM. It turns off if the RPM rises above 1000.

When you reach out to the Experts on JustAnswer with your Mercury questions and concerns, having the following items prepared will allow for a more complete assessment of your situation:


  • Your Mercury's model, year and total mileage
  • The specifics of your issue, including symptoms and duration
  • Any repairs you've already attempted. Whether it's troubleshooting on your own, or with assistance, be sure to let the Experts know.

This information will help the Expert answer your question promptly and accurately.