How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask eautosales Your Own Question
eautosales
eautosales, ASE MECHANIC
Category: Mercedes
Satisfied Customers: 16101
Experience:  ase certified
6149662
Type Your Mercedes Question Here...
eautosales is online now
A new question is answered every 9 seconds

I am looking at replacing the radio... any suggestions, came

Customer Question

I am looking at replacing the radio... any suggestions
JA: Is this an aftermarket stereo, or did it come with the car?
Customer: came with the car
JA: What is the model/year of your Mercedes?
Customer: 95 c220 2.2
JA: Are you hoping to fix this yourself? What have you tried so far?
Customer: lookijng for a more modern factory upgrade
JA: Anything else you think the mechanic should know?
Customer: no
Submitted: 1 year ago.
Category: Mercedes
Expert:  eautosales replied 1 year ago.

Brake Disc

NOTE: Front Wheel Drive (FWD) shown, All-Wheel Drive (AWD) similar.

Removal

1.Remove the wheel and tire.
2.Disconnect the parking brake cable from the brake caliper.
•Pull back the parking brake lever.
•Disconnect the cable from the parking brake lever.
•Remove the cable conduit retaining clip.
•Disconnect the cable from the brake caliper.
3.NOTICE: Do not allow the brake caliper to hang from the brake hose or damage to the hose can occur.

Remove the 2 brake caliper anchor plate bolts and position the brake caliper, brake pads and brake caliper anchor plate aside as an assembly.

•Support the brake caliper, brake pads and brake caliper anchor plate assembly using mechanic's wire.
4.Remove the 2 brake disc screws and the brake disc.

Installation

1.NOTE: Make sure the brake disc-to-hub mounting surface is free of rust and foreign material before applying anti-seize lubricant.

Install the brake disc and the 2 brake disc screws.

•Using the specified brake cleaner, clean the mating surfaces.
•Apply specified lubricant as shown.
•Tighten the screws to 20 Nm (177 lb-in).

2.NOTE: Make sure that the brake caliper hose is not twisted.

Position the brake caliper, brake pads and brake caliper anchor plate assembly and install the 2 brake caliper anchor plate bolts.

•Tighten to 70 Nm (52 lb-ft).
3.Install the parking brake cable to the brake caliper.
•Pull back the parking brake lever.
•Connect the cable to the parking brake lever.
•Install the cable conduit retaining clip.
4.Install the wheel and tire.
5.Cycle the park brake several times to verify normal operation.
•Apply brakes several times to verify correct