Medium and Heavy Trucks

Have truck repair questions? Ask an Expert

Connect one-on-one with {0} who will answer your question

Related Medium and Heavy Trucks Questions
ON A 2008 6.4,,, REPLACED HIGH PRESSURE FUEL PUMP... LIFT
Second opinion] IM WORKING ON A 2008 6.4,,, REPLACED HIGH PRESSURE FUEL PUMP... LIFT PUMP... FUEL FILTERS... GOOD CRANK... NO START... BLED FUEL LINES AT LAST FITTING BEFORE HIGH PRESSURE PUMP... NO A… read more
Chris (aka-Moose)
Chris (aka-Moose)
Technician
Vocational, Technical or Trade School
353 satisfied customers
2004 ford 6.0 with low to no fuel pressure. Have preformed
2004 ford 6.0 with low to no fuel pressure. Have preformed the following, Replaced the pick up in the tank along with the vent on the tank (tank behind rear axle) blew out fuel lines unplugged from pu… read more
Keiphun Sowell
Keiphun Sowell
AutoDiesel Technology
975 satisfied customers
I have a 2015 N-13 that will not start. I have replace FR
Andy, I have a 2015 N-13 that will not start. I have replace FR sensor, FPRV and I'm only getting 27 lbs on low pressure. Once in a while it crank, and have correct pressure, run only short time- coul… read more
Andy
Andy
truck /coach technician
Vocational, Technical or Trade School
207 satisfied customers
I am having two engine codes 94 fml 0 and 3055 fml 15.
I am having two engine codes 94 fml 0 and 3055 fml 15 … read more
Mike Mcmillan
Mike Mcmillan
Triage Tech/Shop Foreman
Associates
389 satisfied customers
I have a 2016 freightliner m2 106 that wont start. It tries
I have a 2016 freightliner m2 106 that wont start. It tries but wont. … read more
Mike Mcmillan
Mike Mcmillan
Triage Tech/Shop Foreman
Associates
389 satisfied customers
2005 f550 6.0 diesel. Serviced regularly, starts and runs
serviced regularly, starts and runs but dies after a 10 minutes at idle. fuel tank has delaminated, new tank installed, pick up tube cleaned (with light in one end you can see through it) also shop air pass through freely. new pick up screen, both lines cleaned from tank to HFCM, new motorcraft HFCM installed, lines cleaned from HFCM to secondary fuel filter, new secondary fuel filter installed. both lines disconnected under air filter and removed from secondary filter housing and cleaned + shop air through them. updated blue spring in regulator as well as all the seals. secondary housing cleaned and shop air through inlet and return ports, filter standpipe removed and cleaned. … read more
Keiphun Sowell
Keiphun Sowell
AutoDiesel Technology
975 satisfied customers
First off, what does your service cost? I have a 2003 38'
Hi - First off, what does your service cost? I have a 2003 38' Dutch Star with a 300 hp Cat (3214?). The last time it ran was a couple of years ago. I was driving it home and it lost power. I limped t… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
5,234 satisfied customers
No fuel pressure. CAT C7. 2004 GMC 8500 C7. Checked fuel
Checked fuel pressure after secondary filter and registered zero. Changed primary and secondary filters, still zero pressure. Loosened fuel line going to intake after secondary filter, fuel dripped out. Took off fuel filter mount and blew and cleaned it out. Hooked it back up with no filter on and cranked engine, filled up with fuel very very slowly. Probably 15 minutes of on off engine cranking. … read more
Mike Mcmillan
Mike Mcmillan
Triage Tech/Shop Foreman
Associates
389 satisfied customers
I have a 2012 Freightliner with a 3 filter DD15 engine,
Good morning I have a 2012 Freightliner with a 3 filter DD15 engine, Customer just had a one kit overhaul done and now truck is hard start after it sits I have followed all trouble shooting steps and … read more
Expert
Expert
7,404 satisfied customers
Ron I have a Ford F250 Super Duty 6.4 Diesel. I believe I'm
Hello RonI have a Ford F250 Super Duty 6.4 Diesel. I believe I'm having a fuel issue. When you turn the key to start the truck, it immediately starts and dies. You have to place your foot on the accel… read more
Curtis B.
Curtis B.
Technician
Associate Degree
1,571 satisfied customers
Truck wont start. I have a code # 033 000 613 14 spn, Should
Truck wont start. I have a code # 033 000 613 14 spn … read more
Expert
Expert
7,404 satisfied customers
Working on a 1995 international with a 7.3L diesel with a no
Working on a 1995 international with a 7.3L diesel with a no start condition. I'm working a flowchart for this condition but I need an expert to help sort this out. Fuel tanks full. Lift pump will fil… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
4,737 satisfied customers
I have a 6nz c15 cat in a 2002 western star. I loose prime
I have a 6nz c15 cat in a 2002 western star. I loose prime when my tanks are not full. I have changed the steel line from the transfer pump to the filter housing. Changed the filter housing, all fuel … read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
5,234 satisfied customers
I have a 2006 c-15 cat engine. It wont start. It cranks but
I have a 2006 c-15 cat engine. It wont start. It cranks but wont fire. Its a t800 Kenworth dump truck. What could be the problem?… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
5,234 satisfied customers
I hope you can help me out like you have so many others. I
I hope you can help me out like you have so many others. I have a 2001 ford f-650 with the 3126-B engine. It started to run ratty and missing when I was moving the truck around. I shut it off to check… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
5,234 satisfied customers
I have a 2008 Peterbuilt with a c15 set at 550 hp. All of a
I have a 2008 Peterbuilt with a c15 set at 550 hp. All of a sudden when climbing a hill either empty or loaded the power drops way of and the truck shakes like crazy. No check engine or warnig lights.… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
5,234 satisfied customers
ford f-650: i have a ford f-650 with a 5.9 215 ISB engine in
i have a ford f-650 with a 5.9 215 ISB engine in it. I recently ran it low on fuel and 1/8 tank and went up a small incline and i died out and will not start again. I bought a new fuel filter and fill… read more
Wayne
Wayne
Journeyman
Vocational, Technical or Trade Scho
4,023 satisfied customers
i have a 2008 maxforce 7 ihc 4200 that we changed the oil and
i have a 2008 maxforce 7 ihc 4200 that we changed the oil and fuel filters on and now it will not start.this engine has hand fuel prime pump and after priming it will still not start,we have never had… read more
sevn103
sevn103
232 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Daniel Wilson

Daniel Wilson

4,737 satisfied customers

Owner at DJ Wilson

Cat Man

Cat Man

Cat Engine Expert

5,234 satisfied customers

I am ASE Master Truck Certified.

Wayne

Wayne

Journeyman

4,023 satisfied customers

worked on, Gmc, Macks, Freight liner,Mercedes Benz,,Ford, sterling

Jeremy

Jeremy

Certified Truck/Bus Technician

2,740 satisfied customers

ASE Med/HD Truck Technician, NATEF Diesel Engines and Electrical/Electronics Technician, Network Engineer specializing in CAN faults, Aftertertreatment, and vehicle communications

cumminsdr

cumminsdr

Mechanic

1,700 satisfied customers

All types of Cummins applications

Curtis B.

Curtis B.

Technician

1,571 satisfied customers

Technician turned service manager on multiple lines of trucks and engines, used in industry.

Chris (aka-Moose)

Chris (aka-Moose)

Technician

353 satisfied customers

24 years of experience diagnosing & repairing

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x