Medium and Heavy Trucks

Have truck repair questions? Ask an Expert

Connect one-on-one with {0} who will answer your question

Related Medium and Heavy Trucks Questions
2009 Volvo vin# ***************** with a Cummins ESN#
2009 Volvo vin# ***** with a Cummins ESN# ***** truck was towed in, would not start, hooked a Bosch DCU 100 to it, showed inactive code for oil sending unit, replaced and it started fine... truck ran … read more
cumminsdr
cumminsdr
Mechanic
High School or GED
1,700 satisfied customers
Dan Rich here again.my own truck has a problem it is code
Hi Dan Rich here again.my own truck has a problem it is code 627 fmi 2.says ECUs loss of power,while its running.our local Peterbilt is worthless for info.its a 2013 Paccar mx13,can you get any info o… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
4,737 satisfied customers
ISX 15 CM2350 I disconnected this two sensors when the
ISX 15 CM2350 I disconnected this two sensors when the engine was running and got this 2 codes right away and plug them back up but codes stayed active, don't they suppose to go out once plug back in?… read more
cumminsdr
cumminsdr
Mechanic
High School or GED
1,700 satisfied customers
Got a 2010 kenworth t800 with a cummins... driver says
got a 2010 kenworth t800 with a cummins... driver says sometimes it won't start and on occasion will cut off going down road,, he'll cut key off and back on until it starts... pulling a code 1117 as i… read more
Expert
Expert
7,408 satisfied customers
The Dressta TD-20M is showing the following fault code 1117.
Hi, the Dressta TD-20M is showing the following fault code 1117. Do you know what the fault is please? Thank you. … read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
4,737 satisfied customers
Getting a 2215 code on Cummins isx 15. 2009Peterbilt 387
Getting a 2215 code on Cummins isx 15 JA: What is the complete model and serial number of your machine? Customer: 2009Peterbilt 387 engine serial 79317472 JA: Are you fixing this yourself? What have y… read more
Eddy
Eddy
HD Truck Tech
GED
2 satisfied customers
I have a 2008 Freightliner M2 with a ISB Cummins, has code
Hello, I have a 2008 Freightliner M2 with a ISB Cummins , has code 559 , 43, 1117 inactive in the ecm. The driver states DPF light comes on along with check engine light, intake heater, engine protect… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
4,737 satisfied customers
02 int. 4300 single axle tractor 5spd allison. Truck goes
02 int. 4300 single axle tractor 5spd allison. Truck goes into limp mode after 5/10 miles when bobtailing and within a mile with just an empty trailer. Reduced power. No codes presently … read more
Andy
Andy
truck /coach technician
Vocational, Technical or Trade School
207 satisfied customers
I have a cummins isb 230hp eng no 57053453 cpl8136. truck
good morning, I have a cummins isb 230hp eng no 57053453 cpl8136. truck seems to run fine except when i hit any kind of incline it falls flat. I thought it was fuel filters so now they are new. It got… read more
Jeremy
Jeremy
Certified Truck/Bus Technician
Associate Degree
2,740 satisfied customers
2006 autocar xpiditor eng# 46628541 active code 094. Its in
2006 autocar xpiditor eng# ***** active code 094 JA: What's the make/model/year of your truck? Engine type? Customer: its in first message JA: Are you fixing your truck yourself? What have you tried s… read more
cumminsdr
cumminsdr
Mechanic
High School or GED
1,700 satisfied customers
I have a 2009 kenworth T660 with an isx one day it decided
I have a 2009 kenworth T660 with an isx one day it decided not to start. We replaced both cams about two weeks ago and drove the truck 5000 miles now it won't start and has a code of 2215 I hear the l… read more
Alex Olsen
Alex Olsen
auto/diesel/industrial
524 satisfied customers
I have a 2010 intentional isx cm871 in my shop with a code
I have a 2010 intentional isx cm871 in my shop with a code of spn 94 fmi 18 as low delivery fuel pressure. Put my inside on truck and checked Dara logger and fuel rail pressure is 240 to 280. Is that … read more
Andy
Andy
truck /coach technician
Vocational, Technical or Trade School
207 satisfied customers
2009 STERLING 6.7 ISB IT'S OVER FUELING HEAVY BLACK SMOKE 30
2009 STERLING 6.7 ISB IT'S OVER FUELING HEAVY BLACK SMOKE 30 SEC AFTER START UP THE SHOP REPLACE INJECTORS TURBO EXHAUST FILTER & ECM IT'S STILL DOING THE SAME THING TRUCK IDLES FINE ITS NOT MISSING F… read more
cumminsdr
cumminsdr
Mechanic
High School or GED
1,700 satisfied customers
2000 international 4700 dt466e... no power under load revs
2000 international 4700 dt466e... no power under load revs to 1500 rpm. in nuetral will rev to 2700 rpm… read more
Jeremy
Jeremy
Certified Truck/Bus Technician
Associate Degree
2,740 satisfied customers
Doctor from Texas. I'm working on a cm870 ser # 79327398 we
Hello this is The Truck Doctor from Texas. I'm working on a cm870 ser # ***** we had this unit in for shutting down and derating found codes 3167,1896,1117 we followed the trouble shooting tree and re… read more
Andy
Andy
truck /coach technician
Vocational, Technical or Trade School
207 satisfied customers
2004 ihc 4400 with dt 466 engine. truck was running fine. sat
2004 ihc 4400 with dt 466 engine. truck was running fine. sat at job site idylling for 20 hours when went to leave engine will not rev over 2000 rpm. changed fuel filters and still wont rev over 2000 … read more
Jeremy
Jeremy
Certified Truck/Bus Technician
Associate Degree
2,740 satisfied customers
I have a 2010 peterbilt 387 with a cummins isx CM871. The engine
I have a 2010 peterbilt 387 with a cummins isx CM871. The engine cranks but wont run. It did run only twice while here ...(Low idle, rough with no throttle response).Checked all the fuses...all good. … read more
Travis A. Wells
Travis A. Wells
Truck Mechanic
Associates of Applied Science
15 satisfied customers
2007 cummins 8.9 ISL PID 94 FMI 1. truck starts and runs fine.
2007 cummins 8.9 ISL PID 94 FMI 1. truck starts and runs fine. code only appears under load. i can read the truck with a prolink. i do not have cummins software. so i cant read fuel pressure. should t… read more
cumminsdr
cumminsdr
Mechanic
High School or GED
1,700 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Daniel Wilson

Daniel Wilson

4,737 satisfied customers

Owner at DJ Wilson

Cat Man

Cat Man

Cat Engine Expert

5,234 satisfied customers

I am ASE Master Truck Certified.

Wayne

Wayne

Journeyman

4,023 satisfied customers

worked on, Gmc, Macks, Freight liner,Mercedes Benz,,Ford, sterling

Jeremy

Jeremy

Certified Truck/Bus Technician

2,740 satisfied customers

ASE Med/HD Truck Technician, NATEF Diesel Engines and Electrical/Electronics Technician, Network Engineer specializing in CAN faults, Aftertertreatment, and vehicle communications

cumminsdr

cumminsdr

Mechanic

1,700 satisfied customers

All types of Cummins applications

Curtis B.

Curtis B.

Technician

1,571 satisfied customers

Technician turned service manager on multiple lines of trucks and engines, used in industry.

Chris (aka-Moose)

Chris (aka-Moose)

Technician

353 satisfied customers

24 years of experience diagnosing & repairing

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x