Medium and Heavy Trucks

Have truck repair questions? Ask an Expert

Connect one-on-one with {0} who will answer your question

Related Medium and Heavy Trucks Questions
1979 yale forklift forks are stuck at about 4' off the
1979 yale forklift forks are stuck at about 4' off the ground. Will go up, but not further down … read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
3,632 satisfied customers
I have a 6000 lb Toyota fork lift. My employees let it run
I have a 6000 lb Toyota fork lift. My employees let it run out of hydraulic. Now the mast etc won't lift … read more
Edward Haniewski
Edward Haniewski
General Studies/Automotive
1 satisfied customers
My 2fgc20 Toyota forklift starts fine. I was using it turned
My 2fgc20 Toyota forklift starts fine. I was using it turned it off, got a drink and started it up but it wouldn't move forward or reverse … read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,517 satisfied customers
Have a GCS20MB forklift, low hours, less than 2000, forward
Have a Clark GCS20MB forklift, low hours, less than 2000, forward and revers are problematic, reading this thread I see the inching spool can be sticky and cause this, any idea where to find a diagram… read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,517 satisfied customers
Maybe you can help me, I have a 1997 iron horse tractor 224
good morning maybe you can help me, I have a 1997 iron horse tractor 224 diesel 3 cylinder engine the bucket on the front of the tractor continues to seep down loaded or empty I had both cylinders reb… read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,517 satisfied customers
I have a Nissan 50 forklift with a propane engine. It has
I have a Nissan 50 forklift with a propane engine. It has been stalling when I turn the wheel without keeping the engine rpm up. Also it will stall when the mast tilt hits bottom. Recently it is very … read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,517 satisfied customers
I have a single cylinder electric dump system that was
i have a single cylinder electric dump system that was leaking fluid out rear end of the cylinder yesterday. Today i tried to raise the bed to inspect for repair and it sounds normal but bed wont go u… read more
][\][iCk0411
][\][iCk0411
Fleet Warranty Manager
Vocational, Technical or Trade School
5 satisfied customers
The forklift will not drive forward or reverse, Model
Model 8FGCU25 , serial 32054. Mast FSV, back tilt 5, attach side shift, type LP … read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,517 satisfied customers
Have a 2010 International tractor with eaton clutch. It was
Have a 2010 International tractor with eaton clutch. It was making terrible loud cackling rattling bolts in a can sound in bellhousing. Clutch was replaced and Flywheel got resurfaced. Still making a … read more
spankyjr1
spankyjr1
Retired
Vocational, Technical or Trade Scho
420 satisfied customers
On the 584C the fork stops about a foot off the ground, you
on the 584C the fork stops about a foot off the ground , you have to wait for 6 to 20 seconds before it will go all the way … read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,517 satisfied customers
Is there an internal solenoid on a or in a governor on an
Is there an internal solenoid on a or in a governor on an 8.2 detroit engine. Another way to ask the question: does the electric governor on an 8.2 detroit have an internal solenoid.… read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,517 satisfied customers
I am having the exact same problem as described in this post
I am having the exact same problem as described in this post the cover is stuck. all six bolts are removed and the cover rocks a little I have tried to pry it off but not having any luck. I was hoping… read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,517 satisfied customers
I'm working on a 13 spd eaton fuller I just rebuilt the
I'm working on a 13 spd eaton fuller I just rebuilt the Trany and mounted on truck and 3rd and 4th where not going in the rest where but didn't. Feel normal so I took off top cover and manually put th… read more
spankyjr1
spankyjr1
Retired
Vocational, Technical or Trade Scho
420 satisfied customers
Older NISSAN forklift. Model #258H 900 diesel (SD33). Here
Older NISSAN forklift. Model #258H 900 diesel (SD33). Here is the info off of the label on the fuel rail/injector pump. "Diesel Kiki". 240 cc.(###) ###-#### ***** L9000. Pump #(###) ###-#### ***** han… read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,517 satisfied customers
dt466e just got rebuilt. had put new injector pump and injectors
dt466e just got rebuilt. had put new injector pump and injectors in it and was running fine. afler about 2 weeks noticed water in oil. Took oil pain off to discover that the third cylinder from front … read more
Jeremy
Jeremy
Certified Truck/Bus Technician
Associate Degree
2,672 satisfied customers
I have an 02 Pete with a N-14. Just rebuilt it, and now it
I have an '02 Pete with a N-14. Just rebuilt it, and now it has a slow tick anytime its reved above an Idle. Narrowed it down to the rear head area. Replaced the head gasket again, thinking one didnt … read more
DirectInjection
DirectInjection
Field Service
Diplom
56 satisfied customers
Have a c15 6nz rebuilt 1 month ago because putting antifreeze
Have a c15 6nz rebuilt 1 month ago because putting antifreeze in base around bottom of #2 liner because o rings bad. Liner protusion good and block deck good, first rebuild. After 3 weeks starting put… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
4,965 satisfied customers
got that fixed and it woked great. now it is losing air over
got that fixed and it woked great. now it is losing air over nite slowly the secondary is at zero and primary is at 50. when i start it up i lose air very fast from charge to lose air to charge is abo… read more
spankyjr1
spankyjr1
Retired
Vocational, Technical or Trade Scho
420 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Daniel Wilson

Daniel Wilson

3,632 satisfied customers

Owner at DJ Wilson

Cat Man

Cat Man

Cat Engine Expert

4,965 satisfied customers

I am ASE Master Truck Certified.

Wayne

Wayne

Journeyman

13,476 satisfied customers

worked on, Gmc, Macks, Freight liner,Mercedes Benz,,Ford, sterling

Jeremy

Jeremy

Certified Truck/Bus Technician

2,672 satisfied customers

ASE Med/HD Truck Technician, NATEF Diesel Engines and Electrical/Electronics Technician, Network Engineer specializing in CAN faults, Aftertertreatment, and vehicle communications

cumminsdr

cumminsdr

Mechanic

1,458 satisfied customers

All types of Cummins applications

Chris (aka-Moose)

Chris (aka-Moose)

Technician

149 satisfied customers

16 years of experience

dieseldan55

dieseldan55

Contractor

77 satisfied customers

Road Service mechanic for Volvo Construction.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x