Medium and Heavy Trucks

Have truck repair questions? Ask an Expert

Connect one-on-one with {0} who will answer your question

Related Medium and Heavy Trucks Questions
Have an issue with a NEW cyl head on ISX cm871 upon start up
have an issue with a NEW cyl head on ISX cm871 upon start up find we have a HUGE amount of combustion pressure in the fuel system . new injectors, new head , engine runs poorly diesel knock , timing i… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
4,737 satisfied customers
2014 pete isx15 cm2350 got two issues but may be related,
2014 pete isx15 cm2350 got two issues but may be related, one is the coolant is building a lot of pressure sometimes coolant comes out from relief cap and when open main cap coolant wants to rush out,… read more
cumminsdr
cumminsdr
Mechanic
High School or GED
1,700 satisfied customers
I have a 2009 Volvo d13. We have do pistons and rings. Fuel
Hi. I have a 2009 Volvo d13. We have do pistons and rings. Fuel filter housing. Fuel pump. Fuel regulator. Truck has no power. Fuel pressure is 15 at idle and 75 with the pedal to the floor. What is t… read more
Mike Mcmillan
Mike Mcmillan
Triage Tech/Shop Foreman
Associates
390 satisfied customers
I have another Mack mp7 question. I have a garbage truck in
I have another Mack mp7 question. I have a garbage truck in here now, it came in with a low power complaint. Basically it would barely pull its self. Dropped the fuel filters diesel fuel looked like l… read more
Mike Mcmillan
Mike Mcmillan
Triage Tech/Shop Foreman
Associates
390 satisfied customers
I have an 06 international 4300 with a dt466. It starts fine
I have an 06 international 4300 with a dt466. It starts fine and runs great for about 5 minutes and then stars running rough and with eventually die. Bleed the air out of the schrader valve and it run… read more
Mike Mcmillan
Mike Mcmillan
Triage Tech/Shop Foreman
Associates
390 satisfied customers
I have an isx 871. Came in and had oil in coolant and water
Hi. I have an isx 871. Came in and had oil in coolant and water in oil. Changed oil coolers. Checked rod and main bearing. Changed oil. Flushed rad and ran it. Found it had bad blowby. Puffing out dip… read more
cumminsdr
cumminsdr
Mechanic
High School or GED
1,700 satisfied customers
I'm working on an 07 kw with an isx. Esn 79247718. It is
Hello. I'm working on an 07 kw with an isx. Esn 79247718. It is running extremely rough. At cold idle it is awful and diesel knocking really bad. When you rev it up it's a little better but still very… read more
Mike Mcmillan
Mike Mcmillan
Triage Tech/Shop Foreman
Associates
390 satisfied customers
Have an isx Cummins that's skipping and passed injector test
Have an isx Cummins that's skipping and passed injector test but failed #6 on cylinder test, opened the valve cover and appeared to be exhaust smut inside what's your thing this may be, I'm replacing … read more
cumminsdr
cumminsdr
Mechanic
High School or GED
1,700 satisfied customers
We have a 2006 dt466 that we have at our shop it came in
we have a 2006 dt466 that we have at our shop it came in originally with a code for idm relay voltage issue and was not starting but first they called out a road call and they had fuel lines off etc a… read more
Andy
Andy
truck /coach technician
Vocational, Technical or Trade School
207 satisfied customers
2014 cummins in international prostar, 299,000 miles,
2014 cummins in international prostar, 299,000 miles, complete DPF services 2 months ago/19000 miles ago. Service at next interval triangle warning light came on then Stop engine about hour later. Wha… read more
cumminsdr
cumminsdr
Mechanic
High School or GED
1,700 satisfied customers
I've got a isx engine. 2000. I have air bubbling out of my
Hi. I've got a isx engine. 2000. I have air bubbling out of my return line. I shut the engine down run my transfer pump. Bleed line and then the engine will run good till I pull a hill. Then it starts… read more
Jeremy
Jeremy
Certified Truck/Bus Technician
Associate Degree
2,740 satisfied customers
Lets try this one more time, I have a Detroit 14L 2008 under
Lets try this one more time, I have a Detroit 14L 2008 under load in higher gears I will get a stumble for just a couple of seconds when getting into the fuel, it will come out and run good, I have no… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
4,737 satisfied customers
I have a peterbilt 379 w/a cCummins ISX [email protected] engine. This is
I have a peterbilt 379 w/a cCummins ISX [email protected] engine. This is a brand new engine just installed in July. When my fuel gets hot or at a 1/2 tank it starts missing and acts like it is runnign out of fuel.… read more
cumminsdr
cumminsdr
Mechanic
High School or GED
1,700 satisfied customers
I have a 2006 ih 4900 with a dta 1/4 mile it bogs down like
I have a 2006 ih 4900 with a dt*****a 1/4 mile it bogs down like its running out of fuel I open the fuel filter cap and there is a massive amount of air ,reinstall the cap prime system it goes another… read more
James
James
Bachelors degree automotive technology with minor in diesel
3,584 satisfied customers
2011 peterbilt 389 dies intermit at idle or no start.
2011 peterbilt 389 dies intermit at idle or no start. Starter, sensors, relays, ignition equip, DEF redone, 2 injectors replaced, and more. At a loss. Once in awhile code for fuel pressure. Planning t… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
4,737 satisfied customers
I have a 2006 KW with an ISX ESN-79096134 Just did an in frame
I have a 2006 KW with an ISX ESN-79096134 Just did an in frame and when I start it up it seems to miss for a little and then clears up. Any ideas? engine has not been broke in yet.… read more
spankyjr1
spankyjr1
Retired
Vocational, Technical or Trade Scho
420 satisfied customers
how can a 2001 series 60 be turning fuel black? fuel test said
how can a 2001 series 60 be turning fuel black? fuel test said fuel was being heated to 300 degrees plus. said injectors were purculating,did flow back test found #2 & #5 not returning fuel properly. … read more
Jeremy
Jeremy
Certified Truck/Bus Technician
Associate Degree
2,740 satisfied customers
i have a 2006 cummins isx 500hp and 1850lb torque in a kenworth
i have a 2006 cummins isx 500hp and 1850lb torque in a kenworth heavy spec truck. it wont pull an empty set of super-b woodchip vans. i have done the delete of the egr last november. it has 2 codes fo… read more
Clayton
Clayton
Technician
Vocational, Technical or Trade Scho
627 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Daniel Wilson

Daniel Wilson

4,737 satisfied customers

Owner at DJ Wilson

Cat Man

Cat Man

Cat Engine Expert

5,234 satisfied customers

I am ASE Master Truck Certified.

Wayne

Wayne

Journeyman

14,574 satisfied customers

worked on, Gmc, Macks, Freight liner,Mercedes Benz,,Ford, sterling

Jeremy

Jeremy

Certified Truck/Bus Technician

2,740 satisfied customers

ASE Med/HD Truck Technician, NATEF Diesel Engines and Electrical/Electronics Technician, Network Engineer specializing in CAN faults, Aftertertreatment, and vehicle communications

cumminsdr

cumminsdr

Mechanic

1,700 satisfied customers

All types of Cummins applications

Curtis B.

Curtis B.

Technician

1,571 satisfied customers

Technician turned service manager on multiple lines of trucks and engines, used in industry.

Chris (aka-Moose)

Chris (aka-Moose)

Technician

353 satisfied customers

24 years of experience diagnosing & repairing

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x