Medium and Heavy Trucks

Have truck repair questions? Ask an Expert

Connect one-on-one with {0} who will answer your question

Related Medium and Heavy Trucks Questions
P0762, 2010 international maxxforce durastar, driver ran it
P0762 , 2010 international maxxforce durastar , driver ran it low on fluid , filled up fluid and still won't shift , what's first step to diagnose solenoid or entire transmission bad , thanks I have n… read more
Andy
Andy
truck /coach technician
Vocational, Technical or Trade School
207 satisfied customers
2014 PETERBILT 337 WITH A ALLISON 3000 GEN 5. I HAVE CODES
2014 PETERBILT 337 WITH A ALLISON 3000 GEN 5. I HAVE CODES P0713, P0843 & P0848. I HAVE 5 VOLTS ON TERMINAL 54, I HAVE 1.2OHMS RESISTANCE BETWEEN 18 & 19 AT TRANSMISSION CONNECTOR. TCM HAS BEEN TESTED… read more
Scott Anthony
Scott Anthony
Master Technician
HS Diploma
1 satisfied customers
Have a allison 15L04 in a 2014 pete push pad shift wont go
have a allison 15L04 in a 2014 pete push pad shift wont go into gear jake is stuck on as well . it will change over with engine off … read more
Bradey V
Bradey V
Certificate
Installed new motor 2004 cat 7 now transmission is saying
Installed new motor 2004 cat 7 now transmission is saying 0872 when you put it in drive it goes into first gear and the goes into 9872 code no problems with trans before engine. Have since replaced tr… read more
Jeremy
Jeremy
Certified Truck/Bus Technician
Associate Degree
2,740 satisfied customers
I have a 2015 ford f-750 with a allison 3000 transmission,
I have a 2015 ford f-750 with a allison 3000 transmission, with a code P0843-00 code Transmission Fluid Pressure Switch 1 Circuit High, Transmission temperature reaches 190F stops shifting… read more
Mike Mcmillan
Mike Mcmillan
Triage Tech/Shop Foreman
Associates
387 satisfied customers
Have a 2005 international 4200 with transmission issue.
Have a 2005 international 4200 with transmission issue. Engine is VT365 running normally. Transmission is allison 2200 automatic. Had check transmission light on dash. Put it in gear and only goes slo… read more
Jeremy
Jeremy
Certified Truck/Bus Technician
Associate Degree
2,740 satisfied customers
Transmission. Today. 2000 freight liner Allison transmission
Alison transmission JA: When was your transmission fluid last checked? Customer: Today JA: What is the make/model/year of your transmissions? Customer: 2000 freight liner Allison transmission JA: Are … read more
Jeremy
Jeremy
Certified Truck/Bus Technician
Associate Degree
2,740 satisfied customers
06 International 4300 dt466 Allison 2000 series Transmission
06 International 4300 dt466 Allison 2000 series Transmission fault code p0872 Won't shift......fine metal shaving in pan. Is it time for a new old?!… read more
Jeremy
Jeremy
Certified Truck/Bus Technician
Associate Degree
2,740 satisfied customers
I have a 2010 mits fuso driver complained of gear light
hello, I have a 2010 mits fuso driver complained of gear light illuminating in cluster vehicle was powered down. when he turned off and restarted again all was well after several miles it would happen… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
4,737 satisfied customers
I have a 2001 4700 INT with a 2000 Allison. Showing 3 codes.
I have a 2001 4700 INT with a 2000 Allison. Showing 3 codes. P0841, P0843 and a U2105. Check trans light comes on within 30 seconds of cold start. When engine is warm I restart the truck and the light… read more
Andy
Andy
truck /coach technician
Vocational, Technical or Trade School
207 satisfied customers
06 International with DT365 & automatic trans. Engine at
06 International with DT365 & automatic trans. Engine at idle, shift trans to drive with brakes off, engine stalls. If I shift from Neutral to Reverse, it will move about 20 mph in reverse (watch out … read more
Wayne
Wayne
Journeyman
Vocational, Technical or Trade Scho
14,553 satisfied customers
I have a 2004 international 4300 we changed the pto from a
i have a 2004 international 4300 we changed the pto from a pull cable controlled to a electric the pto had a worn gear we had it changed by a driveline shop we get it all together everything works fin… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
4,737 satisfied customers
International 4300 with Allison automatic transmission,
international 4300 with Allison automatic transmission, 1HTMMAAN12H540535. Pulled trannie to replace flex plate (broken teeth). After the trannie was reinstalled, I am getting electrical solenoid fail… read more
Curtis B.
Curtis B.
Technician
Associate Degree
1,571 satisfied customers
We have a 2005 f650 with a C7 Cat motor 125K and Allison Trans
We have a 2005 f650 with a C7 Cat motor 125K and Allison Trans and a PacBrake system. We had the truck into Cat for service and had a couple new Injectors installed, the truck ran great leaving there … read more
Wayne
Wayne
Journeyman
Vocational, Technical or Trade Scho
14,553 satisfied customers
I have a 2010 CF 500 International Cab over truck. Check transmission
I have a 2010 CF 500 International Cab over truck. Check transmission light comes on. Then the truck starts to shift like it's slipping gears so I pull over put into park and put the parking brake and… read more
Andy
Andy
truck /coach technician
Vocational, Technical or Trade School
207 satisfied customers
I have an automatic 1994 Ford L8000. For whatever reason, when
I have an automatic 1994 Ford L8000. For whatever reason, when I came to a stop sign, the engine started to act really rough, almost like it was a manual transmission and I needed to press the clutch … read more
Wayne
Wayne
Journeyman
Vocational, Technical or Trade Scho
14,553 satisfied customers
hello my name is XXXXX XXXXX I have a 2002 Chevrolet Duramax
hello my name is XXXXX XXXXX I have a 2002 Chevrolet Duramax with Allison 1000 transmission I have 5 codes PO841 PO 843 PO848 po870 po875do you have any ideal what would cause all 5 codes… read more
Toby
Toby
Vocational, Technical or Trade Scho
107 satisfied customers
po757 trans stuck in limp home. reset with computer and it
po757 trans stuck in limp home. reset with computer and it will run fine till it gets trans temp over 165-170. have changed slenoid twice and installed new pan wire harness.… read more
Toby
Toby
Vocational, Technical or Trade Scho
107 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Daniel Wilson

Daniel Wilson

4,737 satisfied customers

Owner at DJ Wilson

Cat Man

Cat Man

Cat Engine Expert

5,234 satisfied customers

I am ASE Master Truck Certified.

Wayne

Wayne

Journeyman

14,553 satisfied customers

worked on, Gmc, Macks, Freight liner,Mercedes Benz,,Ford, sterling

Jeremy

Jeremy

Certified Truck/Bus Technician

2,740 satisfied customers

ASE Med/HD Truck Technician, NATEF Diesel Engines and Electrical/Electronics Technician, Network Engineer specializing in CAN faults, Aftertertreatment, and vehicle communications

cumminsdr

cumminsdr

Mechanic

1,700 satisfied customers

All types of Cummins applications

Curtis B.

Curtis B.

Technician

1,571 satisfied customers

Technician turned service manager on multiple lines of trucks and engines, used in industry.

Chris (aka-Moose)

Chris (aka-Moose)

Technician

353 satisfied customers

24 years of experience diagnosing & repairing

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x