Medium and Heavy Trucks

Have truck repair questions? Ask an Expert

Ask an Expert,
Get an Answer ASAP!

Related Medium and Heavy Trucks Questions
I have a 2006 peterbilt oil pressure goes from 42# to 80# to
Second opinion] i have a 2006 peterbilt oil pressure goes from 42# ***** 80# ***** 03 while running it is a C-13 acert cat engine do you think it is a sensor and where is it located… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
4,530 satisfied customers
2007 ford f650. The right fuel tank is over filling, fuel
2007 ford f650. The right fuel tank is over filling, fuel transfer pump keeps on pumping while the engine is running. New left side sender, new transfer pump. Mine is set up to draw from left tank and… read more
Jeremy
Jeremy
Certified Truck/Bus Technician
Associate Degree
2,243 satisfied customers
I have a 7740 sle from 93 and it does not move, when i turn
hello, i have a 7740 sle from 93 and it does not move, when i turn the ignition on the display i can see the working hours and then it disapears i nr 4 comes but now moving … read more
dd85
dd85
Service Manager
20 years Service Manager at Dealersh
223 satisfied customers
Fuel gauge inop. Reads empty normal key off. Once ignition
Fuel gauge inop. Reads empty normal key off. Once ignition turned to on the gauge will peg full left below empty. Both wires to gauge have full continuety to ground. Wire to gauge that has nut attachi… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
7,395 satisfied customers
Spanky, We'll my temp gauge and fuel gauge were both
Hey spanky,We'll my temp gauge and fuel gauge were both fluctuating up and down. I was thinking they were released but now I am not so sure. The fuel gauge is now showing fuel at all times while the t… read more
spankyjr1
spankyjr1
Retired
Vocational, Technical or Trade Scho
697 satisfied customers
2005 international 7600 c13 engine. It has some codes for
2005 international 7600 c13 engine. It has some codes for data link issues . But it has two codes SID. FMI 232. 14 232. 4 Which I believe are the problem for the engine not having power. Came in with … read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
4,530 satisfied customers
Have 2007 peterbelt with a c15 cat eng was in a front end t
have 2007 peterbelt with a c15 cat eng was in a front end hit repaired damage and got it to run. but the instrument gauges go up halfway and then swipe back and forth then stop and then swipe again. w… read more
Jeremy
Jeremy
Certified Truck/Bus Technician
Associate Degree
2,243 satisfied customers
2013 Cascadia fuel gauge needle not working. Tanks are full.
2013 Cascadia fuel gauge needle not working. Tanks are full. DEF tanks full and all green bars are lit. Fuel gauge needle on E, no ***** *****ght and no red light. What I have tried, bumpy roads with … read more
Roy
Roy
shop foreman
Associate Degree
4,538 satisfied customers
Yesterday my speedometer, odometer, voltage gauge and
Yesterday my speedometer, odometer, voltage gauge and instrument light cluster stopped working. Checked fuses and relays in fuse box as well as relay directly behind gauges. Could not resolve the prob… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
7,395 satisfied customers
I am working on a 2013 Kenworth with an Isx. Engine code
I am working on a 2013 Kenworth with an Isx. Engine code 2222 comes up. It is a high voltage at the main fuel tank sender. I need help with this. Hopefully there is a simple solution to finding proble… read more
Jeremy
Jeremy
Certified Truck/Bus Technician
Associate Degree
2,243 satisfied customers
I have a 2004 Topkick duramax deisel. My tachometer and oil
I have a 2004 Topkick duramax deisel. My tachometer and oil gauge do not work at all and the fuel gauge is not accurate, i.e. it will go from a full tank reading to an 1/8 of a tank or the opposite. A… read more
Pete
Pete
Automotive Diagnostic Specialist
General auto certifications
30,392 satisfied customers
I'm interested reading fuel level directly from the fuel
Hi, i'm interested reading fuel level directly from the fuel sending unit wire. I have a device which is capable of reading analog values, and latter translate to any format i want. We have succeeded … read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
7,395 satisfied customers
Can a Cummins ISX from an international prostar be installed
Can a Cummins ISX from an international prostar be installed in a peter built 379. The pete is a 2005 egr,- The international is a 2009 erg only (order date was 2006) neither truck has a burner. Thank… read more
Jeremy
Jeremy
Certified Truck/Bus Technician
Associate Degree
2,243 satisfied customers
Hello, I have a 2006 International 8600 with a CAT. The
Hello, I have a 2006 International 8600 with a CAT. The truck is not transferring fuel at all. Fuel draws and returns to left tank. The right tank only has one fuel line that goes to the transfer pump… read more
Andy
Andy
truck /coach technician
Vocational, Technical or Trade School
254 satisfied customers
2004 international 4300 dt466. the fuel gauge went started going to 6 o'clock. checke
2004 international 4300 dt466. the fuel gauge went started going to 6 o'clock. checked the sensor and wiring. all is fine. replaced the gauge. now the gauge sweeps normally, then goes from E all the w… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
7,395 satisfied customers
The speedo and fuel guage in my 1998 T2000 dont work. How do
The speedo and fuel guage in my 1998 T2000 dont work. How do i test the speed sensor. Where can i get a good wire diagram for this truck. The engine is N14… read more
spankyjr1
spankyjr1
Retired
Vocational, Technical or Trade Scho
697 satisfied customers
I have a question about gauges in a 2004 peterbilt 387.
I have a question about gauges in a 2004 peterbilt 387 (c15). My truck was set up for the fans to kick on at 216 degrees and the gauge would read in the red whenever the fans would kick on and so I fo… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
4,530 satisfied customers
napa(NNN) NNN-NNNN i just installed a fuel gauge set napa #501-1742
i just installed a fuel gauge set napa #501-1742 in an old international truck. i followed the instructions very carefully and no luck. says overfull always. any suggestions?… read more
gmtech1967
gmtech1967
business owner
ASE Master Tech Certification
151 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Daniel Wilson

Daniel Wilson

7,395 satisfied customers

Owner at DJ Wilson

Cat Man

Cat Man

Cat Engine Expert

4,530 satisfied customers

I am ASE Master Truck Certified.

Wayne

Wayne

Journeyman

2,892 satisfied customers

worked on, Gmc, Macks, Freight liner,Mercedes Benz,,Ford, sterling

Jeremy

Jeremy

Certified Truck/Bus Technician

2,243 satisfied customers

ASE Med/HD Truck Technician, NATEF Diesel Engines and Electrical/Electronics Technician, EPA 608/609 HVAC Certified, Steering/Suspension and ABS/Brakes Technician

cumminsdr

cumminsdr

Mechanic

1,351 satisfied customers

All types of Cummins applications

Curtis B.

Curtis B.

Technician

991 satisfied customers

Technician turned service manager on multiple lines of trucks and engines, used in industry.

dieseldan55

dieseldan55

Contractor

74 satisfied customers

Road Service mechanic for Volvo Construction.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x