Medium and Heavy Trucks

Have truck repair questions? Ask an Expert

Ask an Expert,
Get an Answer ASAP!

I am working on a 1997 f700 with 7.0 gas engine. It will…

Customer Question
I am working on a...
I am working on a 1997 f700 with 7.0 gas engine. It will crank but won’t start. We aren’t getting any spark. Replaced coil, distributor, and ignition module. When cranking a light on the instrument panel says fuel switch.
Submitted: 5 months ago.Category: Medium and Heavy Trucks
Show More
Show Less
Ask Your Own Medium and Heavy Trucks Question
Answered in 8 hours by:
3/7/2018
Technician: Pete, Automotive Mechanic replied 5 months ago
Pete
Pete, Automotive Mechanic
Category: Medium and Heavy Trucks
Satisfied Customers: 33,359
Experience: Performed various automotive repairs on several light duty and medium duty vehicles over 15 years of service.
Verified

Hi, my name is ***** ***** I will be happy to assist with this today.In some cases, I may need more info to assist better.I apologize for any delay.
I am here Sundays through Thursdays from around 5 am to 2 pm Mountain time.If you respond and I do not respond back right away I will do so as soon as I can.My info is somewhat limited on your model here but no one else has responded and would like to see if I can help here since your question has been sitting for so long.If at any time you feel that I cannot help with this please let me know.

Is the rotor under the distributor cap rotating while cranking over the engine?

Let me know,thanks Pete.

Ask Your Own Medium and Heavy Trucks Question
Customer reply replied 5 months ago
Truck is being towed to my shop. I will let you know once it gets here.
Technician: Pete, Automotive Mechanic replied 5 months ago

O.k., let me know when your ready.

Thanks Pete

Ask Your Own Medium and Heavy Trucks Question
Customer reply replied 5 months ago
Rotor is spinning
Technician: Pete, Automotive Mechanic replied 5 months ago

Have you tested for power at the ignition coil?

Ask Your Own Medium and Heavy Trucks Question
Customer reply replied 5 months ago
I’m getting fire on both wires though. The signal wire is hot 12 volts with ignition on.
Technician: Pete, Automotive Mechanic replied 5 months ago

Can you tell me what color the wires are at the coil connection?

Ask Your Own Medium and Heavy Trucks Question
Customer reply replied 5 months ago
Red with green stripe and black with yellow stripe
Technician: Pete, Automotive Mechanic replied 5 months ago

O.k., unfortunately, my diagrams are not matching up with your model here.Let me see if anyone else can assist on this further.I will open this up for others here to help.I hope you can get this resolved with ease.

Thanks Pete

Ask Your Own Medium and Heavy Trucks Question
Was this answer helpful?

How JustAnswer works

step-image
Describe your issueThe assistant will guide you
step-image
Chat 1:1 with a technicianLicensed Experts are available 24/7
step-image
100% satisfaction guaranteeGet all the answers you need
Ask Daniel Wilson Your Own Question
Daniel Wilson
Daniel Wilson
Daniel Wilson
Category: Medium and Heavy Trucks
Satisfied Customers: 2,825
2,825 Satisfied Customers
Experience: Owner at DJ Wilson

Daniel Wilson is online now

A new question is answered every 9 seconds

How JustAnswer works:

  • Ask an ExpertExperts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional AnswerVia email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction GuaranteeRate the answer you receive.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Daniel Wilson

Daniel Wilson

2,825 satisfied customers

Owner at DJ Wilson

Cat Man

Cat Man

Cat Engine Expert

4,530 satisfied customers

I am ASE Master Truck Certified.

Wayne

Wayne

Journeyman

2,892 satisfied customers

worked on, Gmc, Macks, Freight liner,Mercedes Benz,,Ford, sterling

Jeremy

Jeremy

Certified Truck/Bus Technician

2,243 satisfied customers

ASE Med/HD Truck Technician, NATEF Diesel Engines and Electrical/Electronics Technician, EPA 608/609 HVAC Certified, Steering/Suspension and ABS/Brakes Technician

cumminsdr

cumminsdr

Mechanic

1,351 satisfied customers

All types of Cummins applications

Curtis B.

Curtis B.

Technician

991 satisfied customers

Technician turned service manager on multiple lines of trucks and engines, used in industry.

dieseldan55

dieseldan55

Contractor

74 satisfied customers

Road Service mechanic for Volvo Construction.

< Previous | Next >

Related Medium and Heavy Trucks Questions
I have a 1979 Ford f800 truck that cranks but won't start. I
I have a 1979 Ford f800 truck that cranks but won't start. I have put a new distributor in new plugs . Will run when I put gas in the carburetor then dies. What am I missing. Please help … read more
Curtis B.
Curtis B.
Technician
Associate Degree
991 satisfied customers
Working on a 2009 sterling CNG intermittently won't start
Working on a 2009 sterling CNG intermittently won't start sometimes shuts off won't restart. New purchase no history available. Loosing spark code spn 0725 FMI 4. Red stop on the dash.… read more
Steven
Steven
Triage Tech/Shop Foreman
Associates
11 satisfied customers
Clarke forklift mitsubishi engine no spark new coil resistor
clarke forklift mitsubishi engine no spark new coil resistor and module 12 volts on both side of coil … read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
2,825 satisfied customers
Have a hino195h 2014. Won't start. Not a battery issue. Has
Have a hino195h 2014. Won't start. Not a battery issue. Has fuel. Just won't turn over. … read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
2,825 satisfied customers
2001 Isuzu NPR with a problem. I am not getting any power to
2001 Isuzu NPR with a problem. I am not getting any power to the ignition coil. I am getting a ground signal but no power in the wiring harness. I think it could possibly be a bad wiring harness or a … read more
Alex Olsen
Alex Olsen
auto/diesel/industrial
488 satisfied customers
I have a 1990 topkick truck with a 366 and will not rev up.
i have a 1990 topkick truck with a 366 and will not rev up. it will idle fine. ive replaced the coolant temp sensor,distributor and cap. what else to check? it doesnt have any codes.… read more
Doug Barnowski
Doug Barnowski
HD truck tech
14 satisfied customers
Looking ignition wiring diagram 1992 ford f700. I have no
Looking for a ignition wiring diagram for a 1992 ford f700. I have no spark and have replaced the distributer, coil and ignition module.… read more
Jeremy
Jeremy
Certified Truck/Bus Technician
Associate Degree
2,243 satisfied customers
I have a 1997 gmc c7500 with a 366. When i get into 3rd, 4th
I have a 1997 gmc c7500 with a 366. When i get into 3rd, 4th ,and 5th gears, pushing on throttle it sputters and back fires. the backfire seems to be coming out of the throttle body.It doesn't do it a… read more
roy
roy
Associate Degree
3 satisfied customers
I have a 97 c6500topkick with a 366 6.0 gas engine that caught
I have a 97 c6500topkick with a 366 6.0 gas engine that caught on fire and melted the wiring harness and fuel lines and fuse block.I have replaced all damaged parts but because it was all melted toget… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
2,825 satisfied customers
Ran my 642 on Wednesday. parked it and Thursday it wouldn't
ran my 642 on Wednesday. parked it and Thursday it wouldn't start. Cranks but doesn't fire. does 642 have a tendency. its a used machine and I don't have a manual. is there a setting of choke and thro… read more
Curtis B.
Curtis B.
Technician
Associate Degree
991 satisfied customers
I have a 1980 truck with a 360 engine.Iam getting spark out
I have a 1980 for f700 truck with a 360 engine.Iam getting spark out of coil but none when I try the distributor. Replaced ing switch&the pickup in the distributor.It cranks over fine just wont start.… read more
Wayne
Wayne
Journeyman
Vocational, Technical or Trade Scho
2,892 satisfied customers
I have a 1979 IH 1624 gas burner single axle truck with a
I have a 1979 IH 1624 gas burner single axle truck with a 404 engine. Since day one we have had problems with the ignition. There are times that it loses spark then after a while it quits cranking. Le… read more
Pete
Pete
Automotive Mechanic
33,359 satisfied customers
1991 Ford F700 EFI w/ 7.0 liter/429 cu. in. fuel injection
1991 Ford F700 EFI w/ 7.0 liter/429 cu. in. fuel injection w/ governor, 5 speed manual with 2 speed rear axle. Starts quickly without hesitation, idles smoothly. Will drive normally on first start up,… read more
John Vieira
John Vieira
Heavy Duty Diesel Mechanic
63 satisfied customers
I have a 1979 C70 tandem grain truck with a 427 engine and
I have a 1979 C70 tandem grain truck with a 427 engine and HEI ignition, which occasionally refuses to start even though it cranks well ( no spark ) I have replaced the distributor cap, rotor, coil, p… read more
Pete
Pete
Automotive Mechanic
33,359 satisfied customers
we have a 1998 Ford 700 series box truck that we are having
we have a 1998 Ford 700 series box truck that we are having we think electrical problems. We have changed out the coil wire, coil, alternator, new spark plug wires and plugs and just now the ECM unit.… read more
James
James
Bachelors degree automotive technology with minor in diesel
3,578 satisfied customers
ford f700: I have a 1991 ford f700 with a 7.0 efi it shut
I have a 1991 ford f700 with a 7.0 efi it shut off going down the road changed the electronic ignition module. started and ran for less than 2 minutes and has not ran since. the electric fuel pumps ar… read more
Pete
Pete
Automotive Mechanic
33,359 satisfied customers
I Have a 95 f700 U-Haul box truck with a bad miss, that
I Have a 95 f700 U-Haul box truck with a bad miss, that comes and goes...lately it's been pretty much all the time. I did get it to run 95% better when I changed the Ignition module but after 2 short … read more
tractordoc65
tractordoc65
heavy equipment mechanic
Vocational, Technical or Trade Scho
8 satisfied customers
Have a 94 F700 that wont start, No spark. I replaced the rotor
Have a 94 F700 that wont start, No spark. I replaced the rotor cap and Rotor button as well as the coil. I have continuity at the coil but not at the cap. Any suggestions on narrowing this problem dow… read more
tractordoc65
tractordoc65
heavy equipment mechanic
Vocational, Technical or Trade Scho
8 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x