Medium and Heavy Trucks

Have truck repair questions? Ask an Expert

Connect one-on-one with {0} who will answer your question

Related Medium and Heavy Trucks Questions
I have 2000 Sterling with a cummins isc 8.3 with a caps fuel
I have 2000 Sterling with a cummins isc 8.3 with a caps fuel system. It is on its 6th pump and I'm about to set this truck on fire if the fuel pump goes out again. What can cause the pump to be giving… read more
cumminsdr
cumminsdr
Mechanic
High School or GED
1,351 satisfied customers
Have been trying to figure this out, check for a short to
Have been trying to figure this out, check for a short to ground. Measure the resistance from pin 16 actuator harness connector to engine block the ground is not more than 100 Kohms , I get 7.8 ohms. … read more
Andy
Andy
truck /coach technician
Vocational, Technical or Trade School
254 satisfied customers
I have a 97 freightliner tractor that developed a leak in
I have a 97 freightliner tractor that developed a leak in the air pressure switch under the dash behind the steering column. Had a "mechanic" change out the sender, the buzzer system then went into re… read more
FIX-IT
FIX-IT
Comercial transport technician
Vocational, Technical or Trade Scho
829 satisfied customers
A guy has purchased a Secondhand Grove RT58/RT58A All
Hi there. A guy has purchased a Secondhand Grove RT58/RT58A All Terrain Crane, Basicly he Drove/Rolled it off the Float and asked me to service it, I Performed and Completed the Service where it was U… read more
Curtis B.
Curtis B.
Technician
Associate Degree
991 satisfied customers
Flashing light above DEF Detroit diesel engine, Freightliner
I had a check engine warning light last week that I had cleared at a shop, then 3 days later it came back on … read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
3,164 satisfied customers
Our autoshift will not go into gear at start. You can push
Our autoshift will not go into gear at start. You can push it off and it will run then gets stuck about 6th gear. We have tried everything, please help… read more
FIX-IT
FIX-IT
Comercial transport technician
Vocational, Technical or Trade Scho
829 satisfied customers
2005 peterbilt with 18 speed transmission. It grinds from
2005 peterbilt with 18 speed transmission. It grinds from low to high and vise versa. What to check first before condemning the high and low clutch.… read more
Wayne
Wayne
Journeyman
Vocational, Technical or Trade Scho
2,892 satisfied customers
I have 1996 freightliner with Cummin M-11 yesterday I
Hi I have 1996 freightliner with Cummin M-11 yesterday I started to feel some shaking in 9th gear under 40 mph and 10 gear under. 60 mph… read more
Jeremy
Jeremy
Certified Truck/Bus Technician
Associate Degree
2,243 satisfied customers
2013 kentworth. VIN 1NKBL50X6DJ342143 Has code FAULT CODE
2013 kentworth. VIN 1NKBL50X6DJ342143 Has code FAULT CODE 3382. SPN 3058 FMI 18. Need diagnostic info and location of sensors. Took on the road with scanner on and the percent on the egr fluctuates ac… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
3,164 satisfied customers
I have 2008 kenworth with 450 cummins isx in it.i was
I have 2008 kenworth with 450 cummins isx in it.i was driving down the interstate and got a.check engine light .I stopped and it said tube acuator. I got within a mile from my destination and stop eng… read more
cumminsdr
cumminsdr
Mechanic
High School or GED
1,351 satisfied customers
I have a 2006 Travel Supreme Class A motorhome with a cummins
I have a 2006 Travel Supreme Class A motorhome with a cummins ISL 400 diesel. It recently had the "Stop Engine" light come on but everything was fine. I had another 20 miles to my camp site and everyt… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
3,164 satisfied customers
I cut about a 3" gap in the exuast line just before the first
I cut about a 3" gap in the exuast line just before the first dpf filter then behind the second dpf filter I removed the rest of the exuast line including the muffler. The egr lines are still intact. … read more
GM Tech (Cam)
GM Tech (Cam)
Owner/Technician
Vocational, Technical or Trade Scho
26,890 satisfied customers
I rebuild engine in march2014 on my international 9200 truck
I rebuild engine in march2014 on my international 9200 truck year 2005. Engine is Cummins ism 370 hp. Till now I ran it almost 43 K. In its first week I found out that it is emitting black smoke for a… read more
Travis A. Wells
Travis A. Wells
Truck Mechanic
Associates of Applied Science
15 satisfied customers
2012 IH 4300 Stop engine light still on after having DPF and
2012 IH 4300 Stop engine light still on after having DPF and DOC cleaned. Ran it down the street and then the DPF "temp". warning lamp came on.… read more
Andy
Andy
truck /coach technician
Vocational, Technical or Trade School
254 satisfied customers
GMC C6500 v8 shook violently driving down the highway and then
GMC C6500 v8 shook violently driving down the highway and then lost power, sat 30 min and now traveling at 50 mph. what should I look for?… read more
Wayne
Wayne
Journeyman
Vocational, Technical or Trade Scho
2,892 satisfied customers
HelloCustomer my name isXXXXX is not often I am beat
HelloCustomer my name isXXXXX is not often I am beat but this 180 tector has so far. I think it is broken wire!!! To date had key and immobiliser checked. changed alternator, checked big fuse at batte… read more
spankyjr1
spankyjr1
Retired
Vocational, Technical or Trade Scho
697 satisfied customers
I have a volvo truck, 2003, with a D12C engine. It came in
I have a volvo truck, 2003, with a D12C engine. It came in with fuel in the water. I replaced the injector sleeves. Now it has no power. My bad, I did not test drive before working on it because of al… read more
dieseldan55
dieseldan55
Contractor
Vocational, Technical or Trade Scho
74 satisfied customers
I have a 1999 Sterling L9511 tandem dump truck 10spd with a
I have a 1999 Sterling L9511 tandem dump truck 10spd with a M-11 with 200,000 miles. I'm the only driver who treats it easy. I am getting a 321 fault code. Intake pressure fault. The turbo spools up t… read more
Wayne
Wayne
Journeyman
Vocational, Technical or Trade Scho
2,892 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Daniel Wilson

Daniel Wilson

3,164 satisfied customers

Owner at DJ Wilson

Cat Man

Cat Man

Cat Engine Expert

4,530 satisfied customers

I am ASE Master Truck Certified.

Wayne

Wayne

Journeyman

2,892 satisfied customers

worked on, Gmc, Macks, Freight liner,Mercedes Benz,,Ford, sterling

Jeremy

Jeremy

Certified Truck/Bus Technician

2,243 satisfied customers

ASE Med/HD Truck Technician, NATEF Diesel Engines and Electrical/Electronics Technician, EPA 608/609 HVAC Certified, Steering/Suspension and ABS/Brakes Technician

cumminsdr

cumminsdr

Mechanic

1,351 satisfied customers

All types of Cummins applications

Curtis B.

Curtis B.

Technician

991 satisfied customers

Technician turned service manager on multiple lines of trucks and engines, used in industry.

dieseldan55

dieseldan55

Contractor

74 satisfied customers

Road Service mechanic for Volvo Construction.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x