Medium and Heavy Trucks

Have truck repair questions? Ask an Expert

Connect one-on-one with {0} who will answer your question

Related Medium and Heavy Trucks Questions
Have a leeboy paver with a Deutz 4 cyl engine lost prime to
Have a leeboy paver with a Deutz 4 cyl engine lost prime to injectors cannot get engine to start … read more
Curtis B.
Curtis B.
Technician
Associate Degree
991 satisfied customers
Cat tl 934 telehandler Perkins 3054c. Engine continues to
cat tl 934 telehandler Perkins 3054c. Engine continues to run at slow idle with key off. Shutdown solenoid appears operate normally. … read more
Curtis B.
Curtis B.
Technician
Associate Degree
991 satisfied customers
I am looking for an ISCHigh-pressure fuel pump high pressure
I am looking for an ISC(###) ###-####High-pressure fuel pump high pressure sensor … read more
cumminsdr
cumminsdr
Mechanic
High School or GED
1,351 satisfied customers
Skytrak 8042. Serial 13198. Service brakes applied suddenly
Skytrak 8042. Serial 13198. Service brakes applied suddenly and will not release. … read more
Curtis B.
Curtis B.
Technician
Associate Degree
991 satisfied customers
We bought a used sullair 375 CFM compressor with a low and
we bought a used sullair 375 CFM compressor with a low and high switch on the unit. on low pressure we are seeing around 100 PSI and on high it is building pressure as high as 200 PSI and blowing off … read more
Wayne
Wayne
Journeyman
Vocational, Technical or Trade Scho
2,892 satisfied customers
REBUILT RTO11903 LL TRANS WON'T GO INTO HIGH SIDE IN BACK
REBUILT RTO11903 LL TRANS WON'T GO INTO HIGH SIDE IN BACK HALF NEW SLIDING CLUTCHES & GEARS GOES IN LOW LOW BUT WHEN SHIFT TO HIGH GRINDS CHECKED AIR & GOOD. PULLING BACK OFF TO CHECK GEARS & CLUTCH A… read more
spankyjr1
spankyjr1
Retired
Vocational, Technical or Trade Scho
697 satisfied customers
3 piston is gauled and does not want to knock out on my 3.9
3 piston is gauled and does not want to knock out on my 3.9 cummins, I don't want to damage the rod if I can help it. Do I drill out the top of the piston? … read more
cumminsdr
cumminsdr
Mechanic
High School or GED
1,351 satisfied customers
I need the diagram for the auger cabling for a blaw Knox
I need the diagram for the auger cabling for a blaw Knox paver … read more
Wayne
Wayne
Journeyman
Vocational, Technical or Trade Scho
2,892 satisfied customers
Have a 6 cyl deutz blows oil out the exhaust. F6L913.
Blows blue smoke exhaust on idle, when you step on it pushes oil out exhaust … read more
Curtis B.
Curtis B.
Technician
Associate Degree
991 satisfied customers
I have a deutz 1011 turbo went bad we replaced it then the
i have a deutz 1011 turbo went bad we replaced it then the timing belt broke we replaced it the push rods and the rocker bolts now the crankcase builds enough pressure to blow the dipstick into orbit.… read more
Curtis B.
Curtis B.
Technician
Associate Degree
991 satisfied customers
Whats torque specs and valve adjuments on a cat 966b.
whats torque specs and valve adjuments on a cat 966b … read more
catmastertech
catmastertech
Field service technician
Vocational, Technical or Trade Scho
1,284 satisfied customers
We have a 1980 blaw knox 115pf trucks loaded when lowering
we have a 1980 blaw knox 115pf trucks loaded when lowering screed it pops back up … read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
3,164 satisfied customers
I have a Mahindra 4110 tractor with a worn injector pump
hi I have a Mahindra 4110 tractor with a worn injector pump that the part numbers for the parts inside the pump are worn off and my local pump rebuilder can't seem to by rebuild parts for it since it … read more
Curtis B.
Curtis B.
Technician
Associate Degree
991 satisfied customers
I'm getting severe smoke out of blow by on casein 7120. It
I'm getting severe smoke out of blow by on casein 7120 . It has almost 8000 hours … read more
Curtis B.
Curtis B.
Technician
Associate Degree
991 satisfied customers
I have blow by with my 2011 terex backhoe with a Perkins
I have blow by with my 2011 terex backhoe with a Perkins engine. It has 2000 hours on it There's more air coming out of the pipe not … read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
3,164 satisfied customers
Cat Man, I have a 3114 engine in a 942f loader. It looses
Hey Cat Man, I have a 3114 engine in a 942f loader. It looses power after the engine is ran under load. It seemed like its starving for fuel. i removed the primer button on top of the filter housing a… read more
catmastertech
catmastertech
Field service technician
Vocational, Technical or Trade Scho
1,284 satisfied customers
Komatsu motor found lifter spring broke push rod bent can I
Komatsu motor found lifter spring broke push rod bent can I replace parts without taking head off?… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
3,164 satisfied customers
Freightliner FL70: I am working on an FL70, Freightliner truck.
I am working on an FL70, Freightliner truck. It has developed a cold start problem,to where it starts and dies after a few seconds. Then if it is cranked over and over again it starts back and runs th… read more
cumminsdr
cumminsdr
Mechanic
High School or GED
1,351 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Daniel Wilson

Daniel Wilson

3,164 satisfied customers

Owner at DJ Wilson

Cat Man

Cat Man

Cat Engine Expert

4,530 satisfied customers

I am ASE Master Truck Certified.

Wayne

Wayne

Journeyman

2,892 satisfied customers

worked on, Gmc, Macks, Freight liner,Mercedes Benz,,Ford, sterling

Jeremy

Jeremy

Certified Truck/Bus Technician

2,243 satisfied customers

ASE Med/HD Truck Technician, NATEF Diesel Engines and Electrical/Electronics Technician, EPA 608/609 HVAC Certified, Steering/Suspension and ABS/Brakes Technician

cumminsdr

cumminsdr

Mechanic

1,351 satisfied customers

All types of Cummins applications

Curtis B.

Curtis B.

Technician

991 satisfied customers

Technician turned service manager on multiple lines of trucks and engines, used in industry.

dieseldan55

dieseldan55

Contractor

74 satisfied customers

Road Service mechanic for Volvo Construction.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x