Medium and Heavy Trucks

Have truck repair questions? Ask an Expert

Ask an Expert,
Get an Answer ASAP!

2010 F750 TRANSMISSION WENT LIMP, SPEEDO WENT TO 90 THEN O…

Customer Question
2010 F750 TRANSMISSION WENT LIMP...
2010 F750 TRANSMISSION WENT LIMP, SPEEDO WENT TO 90 THEN O // UNHOOKED BATTERYS AND THEN WENT INTO LIMP ONLY AND SPEEDO SHOWS 90 WHEN ONLY GOING 10
Submitted: 11 months ago.Category: Medium and Heavy Trucks
Show More
Show Less
Ask Your Own Medium and Heavy Trucks Question
Answered in 11 hours by:
8/2/2017
Technician: Pete, Automotive Mechanic replied 11 months ago
Pete
Pete, Automotive Mechanic
Category: Medium and Heavy Trucks
Satisfied Customers: 32,899
Experience: Performed various automotive repairs on several light duty and medium duty vehicles over 15 years of service.
Verified

My name is ***** ***** I am a professional here at Just Answer. I noticed that your question had not received a response and thought I would see if you still need help with this.I apologize for the delay and I hope I can still assist you with this here.

With what you have described here this sounds like a fault with the speed sensor.If the speed sensor is sending a false signal this causes the speedometer to act up like this here as well as causes limp mode.What needs to be done is to have the fault codes read out/checked to see what codes are set then those codes diagnosed and repaired to resolve this issue.I suspect the speed sensor will need replaced or speed sensor wiring is damaged.

If more help is needed, use the reply tab to continue our conversation. If no further assistance is needed, kindly rate my service,your 5 star rating is appreciated ( should be a link to click on here or above).You can rate at any time and we can continue to work on your question as this will not close out your question.Keep in mind in some cases it can be difficult to fully diagnose or help repair your vehicle without seeing it and I work on delivering the best possible answer from what I see to work with.

Thanks Pete

Ask Your Own Medium and Heavy Trucks Question
Customer reply replied 11 months ago
HAS CODES P2724, P0777, P0966, P0880, P0757, P0976 ALL SPEED SENSORS ARE GOOD. I ORDERED A SCANNER SO I CAN MONITOR THIS SYSTEM. SORRY I DIDN'T GIVE YOU MORE INFO.
Technician: Pete, Automotive Mechanic replied 11 months ago

I apologize for the delay.

Some of these codes are not coming up in my info on your model here.But the ones that do are leading towards a faulty transmission wiring harness in the transmission itself.I would check the wiring leading to the transmission for any issues and if this is found o.k. inspect to see if there is any wiring damage with the internal harness.This can be a short to ground issue.

If this was already checked and found o.k. let me know.

Let me know if you need anything else and feel free to rate my help here or above ( should be a link to click on ) as this is how I receive credit for my time,this can be done at any time and you can still come back here and reply if needed.Your 5 star rating is appreciated

Thanks Pete

Ask Your Own Medium and Heavy Trucks Question
Was this answer helpful?

How JustAnswer works

step-image
Describe your issueThe assistant will guide you
step-image
Chat 1:1 with a technicianLicensed Experts are available 24/7
step-image
100% satisfaction guaranteeGet all the answers you need
Ask Pete Your Own Question
Pete
Pete
Pete, Automotive Mechanic
Category: Medium and Heavy Trucks
Satisfied Customers: 32,899
32,899 Satisfied Customers
Experience: Performed various automotive repairs on several light duty and medium duty vehicles over 15 years of service.

Pete is online now

A new question is answered every 9 seconds

How JustAnswer works:

  • Ask an ExpertExperts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional AnswerVia email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction GuaranteeRate the answer you receive.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Daniel Wilson

Daniel Wilson

2,775 satisfied customers

Owner at DJ Wilson

Cat Man

Cat Man

Cat Engine Expert

4,493 satisfied customers

I am ASE Master Truck Certified.

Wayne

Wayne

Journeyman

2,869 satisfied customers

worked on, Gmc, Macks, Freight liner,Mercedes Benz,,Ford, sterling

Jeremy

Jeremy

Certified Truck/Bus Technician

2,235 satisfied customers

ASE Med/HD Truck Technician, NATEF Diesel Engines and Electrical/Electronics Technician, EPA 608/609 HVAC Certified, Steering/Suspension and ABS/Brakes Technician

cumminsdr

cumminsdr

Mechanic

1,337 satisfied customers

All types of Cummins applications

Curtis B.

Curtis B.

Technician

961 satisfied customers

Technician turned service manager on multiple lines of trucks and engines, used in industry.

dieseldan55

dieseldan55

Contractor

74 satisfied customers

Road Service mechanic for Volvo Construction.

< Previous | Next >

Related Medium and Heavy Trucks Questions
I have a 4 wire speed sensor. One set of wires plugs in and
I have a 4 wire speed sensor. One set of wires plugs in and goes by air cleaner on passenger side of truck. Where does the other one go … read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
2,775 satisfied customers
2008 mt 45 fed ex box truck... no headlights s... rear
2008 mt 45 fed ex box truck... no headlights s... rear marker lights stay on at all times, speedo,odometer,turn signal arrows etc lit at all times. even with headlight switch and turn signal switchs u… read more
Andy3221
Andy3221
truck /coach technician
Vocational, Technical or Trade Scho
222 satisfied customers
2007 F750 5.9L Cummins stop engine light intermitent - when
2007 F750 5.9L Cummins stop engine light intermitent - when light comes on it accelerator doesnt respond 10 15 sec light may go out and runs great. Want to get it up to cummins but afraid of getting r… read more
Wayne
Wayne
Journeyman
Vocational, Technical or Trade Scho
2,869 satisfied customers
I have a 2007 gmc w4500 cab over it start and runs fine if
I have a 2007 gmc w4500 cab over it start and runs fine if you put it in gear and do brake stand it ok until wheel turn or you drive 5 feet then rpm will not go over 1000 rpm its a Isuzu 5.2 l diesel … read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
2,775 satisfied customers
I have a meritor 10 speed that will not go in high gear. I
I have a meritor 10 speed that will not go in high gear. I hear air at the air over electric valve but its not switching … read more
Wayne
Wayne
Journeyman
Vocational, Technical or Trade Scho
2,869 satisfied customers
Ecu fault mid 128 pid 84 fmi 2 lost throttle will only idle
Ecu fault mid 128 pid 84 fmi 2 lost throttle will only idle won't even idle up by bumping cruise … read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
2,775 satisfied customers
I have a 2010 Volvo semi truck. I started it this morning
I have a 2010 Volvo semi truck. I started it this morning and motor quit after running about ten or fifteen minutes. the computer panel reads maintenance required gear selector ECU. Will not start aga… read more
Jeremy
Jeremy
Certified Truck/Bus Technician
Associate Degree
2,235 satisfied customers
2003 International with Meritor ZF auto transmission.. can
2003 International with Meritor ZF auto transmission.. can be going down the road just fine, i notice that i lose my speedo and then transmission shows system malfunction on ZF gear indicator on dash.… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
2,775 satisfied customers
2004 F750 with Allison automatic MD3060, Intermitant loss of
2004 F750 with Allison automatic MD3060, Intermitant loss of power to shift selector. Truck wont start. When there is power, sometimes it wont go into gear. We did get code D13500 when it was powered … read more
Wayne
Wayne
Journeyman
Vocational, Technical or Trade Scho
2,869 satisfied customers
2009 STERLING 6.7 ISB IT'S OVER FUELING HEAVY BLACK SMOKE 30
2009 STERLING 6.7 ISB IT'S OVER FUELING HEAVY BLACK SMOKE 30 SEC AFTER START UP THE SHOP REPLACE INJECTORS TURBO EXHAUST FILTER & ECM IT'S STILL DOING THE SAME THING TRUCK IDLES FINE ITS NOT MISSING F… read more
cumminsdr
cumminsdr
Mechanic
High School or GED
1,337 satisfied customers
On Freightliner Custom Chassis (2010) where is odometer
On Freightliner Custom Chassis (2010) where is odometer miles pickup located? The miles are shown in the instrument panel but is this by cable or electrical registered. It has to be sent (or picked up… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
2,775 satisfied customers
I have a 2009 ford f750 with an altec bucket system and when
I have a 2009 ford f750 with an altec bucket system and when I flip the pto switch the pto engages and cuts out and re engages constantly. I just recently had the tcm replaced due to the transmission … read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
2,775 satisfied customers
replaced solenoid on 1966 Ford F750. the starter begins to
replaced solenoid on 1966 Ford F750. the starter begins to turn while key is in the run position and therefore stays engaged after the truck starts?… read more
Curtis B.
Curtis B.
Technician
Associate Degree
961 satisfied customers
Jeremy, Just took delivery of a 2012 International prostar
Hi Jeremy, Just took delivery of a 2012 International prostar tow truck with 55,000 miles. On the road for 3 hours and transmission went into limp mode. Had code fmi31. wanted to be methodical so I re… read more
Jeremy
Jeremy
Certified Truck/Bus Technician
Associate Degree
2,235 satisfied customers
I have a Thomas school bus, freightliner chassis, ISB 6.7 EPA
I have a Thomas school bus, freightliner chassis, ISB 6.7 EPA 2010 Cummins 240 HP S/N 73183037, Allison 2350 PTS automatic, manufactured January 2011. When started in neutral at a stop the speedometer… read more
John Vieira
John Vieira
Heavy Duty Diesel Mechanic
63 satisfied customers
How can i change how much the odometer shows that i drive.
How can i change how much the odometer shows that i drive. Ive got Cummins Insite. The truck shows 6 miles per hour slower at 50 MPH… read more
Travis A. Wells
Travis A. Wells
Truck Mechanic
Associates of Applied Science
4 satisfied customers
freightliner 2009 Mercedes engine , code P 84 speed sensor
freightliner 2009 Mercedes engine , code P 84 speed sensor fault (VCU) speedo does not work , speedo worked before changing transmission swaped over speed sensor housing and pickup , have ohm resistan… read more
roy
roy
Associate Degree
3 satisfied customers
freightliner chassis allison 1000 mfr nov 99 stays in low and
freightliner chassis allison 1000 mfr nov 99 stays in low and speedo shows 0 is this some thing i can check thanks lloyd… read more
spankyjr1
spankyjr1
Retired
Vocational, Technical or Trade Scho
19 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x