Medium and Heavy Trucks
Have Truck Repair Questions? Ask an Expert
here is the pages from manual. Lip goes in, flat part of seal goes out.
I see question is still open, did you get my link? Please rate to close and get me credit.
Question was how to install front seal!
Smoke is indication that the injection timing is off.
I can opt out and see if anyone else with cummins info can help. Do not respond to me, or it will lock the question.
Hi I'm Wayne
I will help you with this
what is the part of question you are seeking a answer,Let me know
Thank you for that
did this happen all of a sudden
does it all the time, cold or hot
let me know
what you are describing is a injector or 2 has failed
I suggest to replace all,
I hope this helped you
Hi. If this helped you,
please remember to rate my answer 3 or more stars.
If more info is needed, use the reply button -
NOT THE POOR/BAD SERVICE
that is the most common issue
check the wire harness wiggle the terminal ends,
use a heat gun and measure the heat at the
exhaust manifold each cylinder
get back to me when you have performed these test
Just a follow up with you
did my answer help you
let me know, Please
No manifold stays on engine
Hi if this helped you
Please rate my answer 3 or more stars
If need more info use the info button
Not Poor/Bad service
Yes I would like to know what it is
they should all me within 10-15 degree of each other
Lets do the test 1st
that I am requesting, Please