Medium and Heavy Trucks

Have truck repair questions? Ask an Expert

Connect one-on-one with {0} who will answer your question

Related Medium and Heavy Trucks Questions
I HAVE A 2001 AGCHEM 1254 ROGATOR WITH 5.9 CUMMINS, STARTS
I HAVE A 2001 AGCHEM 1254 ROGATOR WITH 5.9 CUMMINS, STARTS AND RUNS ABOUT 2 MINUTES, STARTS SPUTTERING AND DIES. WILL START BACK UP AND DOES SAME THING AGAIN HAD A DESIEL MECH. CHECK COMPUTER AND SHOW… read more
Joe
Joe
Service Technician
Associate Degree
822 satisfied customers
2012 6.7 dodge 5500. Truck has dash message and cel p20e8.
2012 6.7 dodge 5500. Truck has dash message and cel p20e8. Please advise with repair experience. Where is the def pressure sensor? Thanks!… read more
Wayne
Wayne
Journeyman
Vocational, Technical or Trade Scho
3,893 satisfied customers
It cranks but doesn't start. It is a 2002 Peterbilt 379 with
Yes, Check fuel pressure, sent ECM to dealer to check, came back all good. Checked for power to ECM and injectors and found to be good. Only active code is for low coolant sensor, there shows one status flag in CAT ET for no engine speed … read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,181 satisfied customers
I have a c7. Fires right up when cold, and runs fine. When
I have a c7. Fires right up when cold, and runs fine. When it gets up to temp and you turn the key off, it will not start back. When engine cools down it will fire back up. I have a logged event on ca… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,181 satisfied customers
UNIT EQUIPPED WITH A C7. TRUCK IS HARD STARTING/LOSING
UNIT EQUIPPED WITH A C7. TRUCK IS HARD STARTING/LOSING PRIME. IF YOU PRIME ENGINE AND GET IT STARTED, TRUCK RUNS FINE WITH NO ISSUES. LET UNIT SIT OVERNIGHT AND IT WILL LOSE PRIME AGAIN. NO SIGNS OF E… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,181 satisfied customers
I am working on a 2009 c-13 with a regen issue. It was going
Dear Catman, I am working on a 2009 c-13 with a regen issue. It was going into regen but in a short period of time it would kick out of regen and throw a code for " aftertreatmant 1 failed to ignite".… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,181 satisfied customers
Cummins 5.9L ISB in a 2003 Ford F650SD. Engine dies out and
Cummins 5.9L ISB in a 2003 Ford F650SD. Engine dies out and wont restart right away. These codes came up. "Supply pump control module, Can communication error. Engine fuel shut off supply voltage erro… read more
Andy
Andy
truck /coach technician
Vocational, Technical or Trade School
207 satisfied customers
I have a freightliner with a cat c7 engine, will not start.
I have a freightliner with a cat c7 engine, will not start. Turns over fine. Power and ground at ecm. Flash codes are 58. Cat et shows cold start and no engine speed. Replaced speed sensors and fuel r… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,181 satisfied customers
Cummins 8.3 ser.46433018 no start accumulator pressure 1552
cummins 8.3 ser.46433018 no start accumulator pressure 1552 while cranking all click tests good… read more
cumminsdr
cumminsdr
Mechanic
High School or GED
1,629 satisfied customers
We have cat c18 generators. I have 2 questions, 1) what do
Hi, we have cat c18 generators. I have 2 questions … read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,181 satisfied customers
Second opinion] I have a Thermoking Tripac evolution not
second opinion] I have a Thermoking Tripac evolution not starting, it cranks but won't start also I removed the hose going to the filter housing when I turn the controller on the lift pump starts send… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
4,431 satisfied customers
I have. Cat 924k serial pwr00866 I have a ground level
Hello I have. Cat 924k serial pwr00866 I have a ground level shutdown e678(1) and the remote shutdown voltage above normal 267 something I changed the switch by the door that the switch I changed I th… read more
catmastertech
catmastertech
Field service technician
Vocational, Technical or Trade Scho
1,301 satisfied customers
Had two cat 3406c installed as main propulsion in a vessel
hi, had two cat 3406c installed as main propulsion in a vessel and the both engines are had to start, after fuel priming engines run fine, 30mins after shutdown both will not start and require priming… read more
Curtis B.
Curtis B.
Technician
Associate Degree
1,413 satisfied customers
Sir we have a 3126 (8YL74450) that a customer decided to
Sir we have a 3126 (8YL74450) that a customer decided to change two injectors in. After doing so the truck will not start. We can communicate with ECM with ET and have done the following, changed oil … read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,181 satisfied customers
Tim, Can I get the valve lash and injector adjustment
Hi Tim, Can I get the valve lash and injector adjustment procedures for the c18 cat engine S# ***** please. Also main bearings torque and vibration damper bolts torque values… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,181 satisfied customers
I have a 2007 International 4300 with a DT466E. I am getting
I have a 2007 International 4300 with a DT466E. I am getting a low coolant severe/critical level. Truck will shutdown shortly after. If I unplug or remove the sensor from the mounting location it will… read more
Andy
Andy
truck /coach technician
Vocational, Technical or Trade School
207 satisfied customers
I have a 98 kw w900 with 3406 e it missed a little then ran
I have a 98 kw w900 with 3406 e it missed a little then ran horrible now wont start at all took ecm to cat tested fine they said one fault was intermittent power but it has proper voltage to ecm from … read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
4,431 satisfied customers
I have a 2001 International 9100 with a ISM cummins. Intermittant
I have a 2001 International 9100 with a ISM cummins. Intermittant crank and no start after shutdown. Starts up fine initially shen cold. If you shut it down , no start. Codes appear SID 17 (237) FMI 4… read more
cumminsdr
cumminsdr
Mechanic
High School or GED
1,629 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Daniel Wilson

Daniel Wilson

4,431 satisfied customers

Owner at DJ Wilson

Cat Man

Cat Man

Cat Engine Expert

10,181 satisfied customers

I am ASE Master Truck Certified.

Wayne

Wayne

Journeyman

3,893 satisfied customers

worked on, Gmc, Macks, Freight liner,Mercedes Benz,,Ford, sterling

Jeremy

Jeremy

Certified Truck/Bus Technician

2,738 satisfied customers

ASE Med/HD Truck Technician, NATEF Diesel Engines and Electrical/Electronics Technician, Network Engineer specializing in CAN faults, Aftertertreatment, and vehicle communications

cumminsdr

cumminsdr

Mechanic

1,629 satisfied customers

All types of Cummins applications

Curtis B.

Curtis B.

Technician

1,413 satisfied customers

Technician turned service manager on multiple lines of trucks and engines, used in industry.

Chris (aka-Moose)

Chris (aka-Moose)

Technician

311 satisfied customers

16 years of experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x