How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Daniel Wilson Your Own Question
Daniel Wilson
Daniel Wilson,
Category: Medium and Heavy Trucks
Satisfied Customers: 5136
Experience:  Owner at DJ Wilson
65405794
Type Your Medium and Heavy Trucks Question Here...
Daniel Wilson is online now
A new question is answered every 9 seconds

Century freightliner tractor gears getting stuck. It

Customer Question

Century freightliner tractor gears getting stuck. It sometimes gets stuck on 1st gear n i have to disconnect the batteries but now it goes all the way to 5 th gear and wont go any further. It has code 130s035 07 41
JA: We'll do all we can to help. Is there anything else important you think the Heavy Equipment Mechanic should know?
Customer: I researched and it could be 1 of many things but not sure....xy shifyer, harness, ecu? I do have an air leak in a valve thats under the fifth wheel that has one hose on each side i dnt know if its for the abs.... But i bypassed it and closed it with a hose so the air wont escape. But the gears were getting stuck even before the air leak. The code says trans range high act noresp 130s035 07 41
JA: OK. Got it. I'm sending you to a secure page on JustAnswer where you can place your fully refundable $5 deposit (plus $49 after the Heavy Equipment Mechanic responds). While you're filling out that form, I'll tell the Heavy Equipment Mechanic about your situation and connect you two.
Submitted: 1 year ago.
Category: Medium and Heavy Trucks
Expert:  Daniel Wilson replied 1 year ago.

Hi my name is***** will be glad to help . Click this link and use this procedure to get the eaton codes. Let me know the codes and the full transmission model.

Code retrieval

Customer: replied 1 year ago.
I did include the code130s035 07 (41). (41) should be ur code
Expert:  Daniel Wilson replied 1 year ago.

Fault Code 41: Ran

ge Failed to Engage

J1587:MID 130 SID 56 FMI 7

Overview

Fault Code 41 indicates the transmission is unable to com-

plete a shift across the range. Th

e range is either stuck in HI

or LO, or cannot complete engagement into HI or LO.

Detection

The transmission attempts th

e same range shift 5 consecu-

tive times and determines the shift cannot be completed

based on the speeds across the back box.

Conditions to Set Fault Code Active

Fallback

This fault causes a 5-speed fallback and the transmission

stays in either LO range or

HI range. When the vehicle

comes to a stop, an attempt to

shift into LO range is made.

Possible Causes

This fault code can be caused

by any of the following:

• Low air pressure

• Contaminated air supply

• Air leak

• Range valve

• Range Synchronizer

• Range Actuator, Cylinder, Piston or Yoke

Additional Tools

• Basic hand tools

• Two 0-100 PSI Air Pressure gauges

Expert:  Daniel Wilson replied 1 year ago.

Click on this link and see PDF page 93 on for the test procedure.

Troubleshooting

Related Medium and Heavy Trucks Questions