How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Andy Your Own Question
Andy, Truck Diagnostic Technician
Category: Medium and Heavy Trucks
Satisfied Customers: 1648
Experience:  International and Isuzu trucks , International, Maxxforce, Cummins and Isuzu engines, Diagnostic and electrical troubleshooting specialist , Hvac and truck /trailer refrigeration troubleshooter
Type Your Medium and Heavy Trucks Question Here...
Andy is online now
A new question is answered every 9 seconds

International 2005 7600 with cummings fault codes 25:1

Customer Question

international 2005 7600 with cummings fault codes 25:1 612-14p
150: 2 2023-14p
1: 3 613-14a
1: 4 613-14p
truck just spins, will not start
Submitted: 1 year ago.
Category: Medium and Heavy Trucks
Customer: replied 1 year ago.
could be 2006
Expert:  Andy replied 1 year ago.

Hi there . My name is ***** ***** Can we start with the last 8 digits of the vin please? Also can you tell me if the engine lamp comes on at key on ?

Customer: replied 1 year ago.
307016Yes the light come on when key is on and it also says engine warning under the odometer
Expert:  Andy replied 1 year ago.

Have you checked the fuse in the battery box sitting on top of the batteries?

Customer: replied 1 year ago.
it is not blown.
Expert:  Andy replied 1 year ago.

Was it loose at all ? Have you followed that harness towards the ECM ? That harness is what we call the ECM clean power feed harness . Any issues with that harness would cause a no start .

Expert:  Andy replied 1 year ago.

Do you have a scanner to check engine codes? The codes you previously mentionned are generated from the body controller and are faults for other circuits on the truck.

Customer: replied 1 year ago.
Will do some more checking today....try to get the engine scaned......will get back to u....tks
Expert:  Andy replied 1 year ago.

Ok thanks . Once you know the fault , I will be able to send the troubleshooting steps .

Customer: replied 1 year ago.
I think we found the problem.....emc has a burned connector pin. Sending emc off to be checked.tks.
Expert:  Andy replied 1 year ago.

Ok sounds good Tony . Let me know if you need anything else and please don't forget to rate my service to you. Feedback is important . Thank you .

Related Medium and Heavy Trucks Questions