How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Wayne Your Own Question
Wayne
Wayne, Journeyman
Category: Medium and Heavy Trucks
Satisfied Customers: 9536
Experience:  worked on, Gmc, Macks, Freight liner,Mercedes Benz,,Ford, sterling
6825259
Type Your Medium and Heavy Trucks Question Here...
Wayne is online now
A new question is answered every 9 seconds

What is the valve clearance spec. 4-390 non tubo eng

Customer Question

what is the valve clearance spec. for a 4-390 non tubo engine
Submitted: 2 years ago.
Category: Medium and Heavy Trucks
Expert:  Wayne replied 2 years ago.
Hi I'm Wayne I will help you with this There should be a timing pen located right below the injection pump. It pins on the cam, so when falls the engine is at top center compression number one. Adjust intake and exhaust on Cly one, intake on two and exhaust on number three. Pull timing pin so tip does not break off , mark balancer and rotate engine 360 deg. Then adjust exhaust on Cly two , intake on three and intake and exhaust on four. Intake .010. Exhaust .020 If this Helped you please Rate My Answer 3 stars or moreIf you need more infoUse the request Button, not a Poor/Bad Rating Thank You Wayne

Related Medium and Heavy Trucks Questions