Medium and Heavy Trucks

Have truck repair questions? Ask an Expert

Connect one-on-one with {0} who will answer your question

Related Medium and Heavy Trucks Questions
2013 kenworth with a 99 Caterpillar 2ws17499 motor. Truck
2013 kenworth with a 99 Caterpillar 2ws17499 motor. Truck will start but not stay on long enough to perform cut out test. Dies like starving for fuel. But will start again after it dies. Plenty of fue… read more
Nich1019
Nich1019
Diesel Technician
Vocational, Technical or Trade School
47 satisfied customers
2008 KW T800 with SDP cat engine. Engine has surging between
2008 KW T800 with SDP cat engine. Engine has surging between idle and 1000rpms. At 1k rpms it's bad enough to rock the whole truck. Fuel pressure is good. Fuel delivery readings are all over the place… read more
Nich1019
Nich1019
Diesel Technician
Vocational, Technical or Trade School
47 satisfied customers
I have a C6500 GMC with a 3126B, the truck developed a
I have a C6500 GMC with a 3126B, the truck developed a intermittent starting issue. you could give the truck a sniff of ether and it would start right up. The only active code in the ECM was for engin… read more
Gary A.
Gary A.
Associates in Diesel Technology and Business Management
6 satisfied customers
I am working on a Cummins ISL9. Engine serial #73499532. It
I am working on a Cummins ISL9. Engine serial #73499532. It has a crank no start issue. Fault codes are 0778, 0352, and 0692. Code 0692 was an active code prior to the crank no start issue. i am looki… read more
Nich1019
Nich1019
Diesel Technician
Vocational, Technical or Trade School
47 satisfied customers
I'am working on a 2006 Peterbilt truck with a CAT engine.
Hi, I'am working on a 2006 Peterbilt truck with a CAT engine. the engine serial number is ***** The engine fan is stuck on all the time. The fan clutch uses air to disengage.I manually put air to the … read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
I have a 1995 ford ltl9000 with a 3406 cat engine it will
I have a 1995 ford ltl9000 with a 3406 cat engine it will crank but will not start but if you spay it with ether it will start and run all day until you turn it off then it will not start until you sp… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
2006 DT570 no start ether assistants starts and runs ok
Hello. 2006 DT570 no start ether assistants starts and runs ok power don all by I can … read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
6,062 satisfied customers
Cat Man, I have a 2003 Peterbilt with a CAT C-15 MBN16293,
Hi Cat Man, I have a 2003 Peterbilt with a CAT C-15 MBN16293, the engine will not start. When I turn on the ignition none of the dummy lights come on including the check engine light. The truck igniti… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
Cat Man, I'am working on a 2002 Kenworth with a 6NZ64913 Cat
Hi Cat Man, I'am working on a 2002 Kenworth with a 6NZ64913 Cat engine. The truck would start and run for a few seconds then quit. I checked for power and ground at the ecm and found that there was no… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
I'm PJ. I have a 1998 Volvo vn truck with a m11 cummins
Hi, I'm PJ. I have a 1998 Volvo vn truck with a m11 cummins with the celect system. I have a caution light on the dash and want to know if I can pull trouble code with out a scanner?… read more
cumminsdr
cumminsdr
Mechanic
High School or GED
1,886 satisfied customers
Cat Man, I'am working on a CAT 3126 in a 2003 Freightliner
HI Cat Man, I'am working on a CAT 3126 in a 2003 Freightliner truck. The engine serial #is HEP18235.It was hard to start it (turned over fine just wouldn't fire), after firing and stalling twice it fi… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
I have a 02 International 4300 dt466 had to replace front and
I have a 02 International 4300 dt466 had to replace front and rear timing cover, So disassembled the front and had to remove cam unable to pull gear off of camshaft so I pulled head and then puu1lled … read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
6,062 satisfied customers
Cat Man, I'am working on a twin turbo Cat engine serial
Cat Man, I'am working on a twin turbo Cat engine serial number BXS05167, the check engine light was on I scanned it and it came up as code 95 so I replaced the IVAP sensor and the light went out. Afte… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
Hi Cat Man, Iam working on 3406E Cat serial number 5EK78587.
Hi Cat Man, I'am working on 3406E Cat serial number 5EK78587. The engine runs really nice and it is able to get up to full RPM, the problem is the engine is making little to no boost ( 0.7 to 1 lbs) a… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
Hi Cat Man, Iam working on a 1999 Peterbilt 379 with a 3406E
Hi Cat Man, I'am working on a 1999 Peterbilt 379 with a 3406E CAT in it, after sitting for a couple of days it will start up right away like usual but after about 10 seconds it will stall out.To get i… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
Hi Cat Man, Iam working on a C-15 CAT Accert Engine.Serial
Hi Cat Man, I'am working on a C-15 CAT Accert Engine.Serial # XXXXX engine was starting to run rough then it eventually just quit running.My customer said there was a code displayed on his dash comput… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
Hi, I have a 2001 Kenworth T-800 with a C-15 Cat engine in
Hi, I have a 2001 Kenworth T-800 with a C-15 Cat engine in it.The truck serial # XXXXX CAT is a 6NZ engine.Sometimes the foot throttle will just go dead suddenly(just goes to idle when driving),then i… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
96 volvo with cat 3406E died. No fuel flow thru ecm. Would
96 volvo with cat 3406E died. No fuel flow thru ecm. Would only turn over with either spray. Used shop peterbiult ecm ran in shop ok. Then grabbed and ecm from blown motor 98 Volvo with 3406E and swap… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Daniel Wilson

Daniel Wilson

6,062 satisfied customers

Owner at DJ Wilson

Cat Man

Cat Man

Cat Engine Expert

10,344 satisfied customers

I am ASE Master Truck Certified.

Wayne

Wayne

Journeyman

5,115 satisfied customers

worked on, Gmc, Macks, Freight liner,Mercedes Benz,,Ford, sterling

Jeremy

Jeremy

Certified Truck/Bus Technician

2,756 satisfied customers

ASE Med/HD Truck Technician, NATEF Diesel Engines and Electrical/Electronics Technician, Network Engineer specializing in CAN faults, Aftertertreatment, and vehicle communications

Curtis B.

Curtis B.

Technician

1,947 satisfied customers

Technician turned service manager on multiple lines of trucks and engines, used in industry.

cumminsdr

cumminsdr

Mechanic

1,886 satisfied customers

All types of Cummins applications

Chris (aka-Moose)

Chris (aka-Moose)

Technician

641 satisfied customers

24 years of experience diagnosing & repairing

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x