Medium and Heavy Trucks

Have truck repair questions? Ask an Expert

Connect one-on-one with {0} who will answer your question

Related Medium and Heavy Trucks Questions
DT466E crank / no start. 2006 IH 8100 DT466E. Repairing
Repairing myself. Engine will fire right up on ether and immediately run smooth with no smoke. I have replaced all injector orings, replaced one complete injector, replaced check ball before primer pump, replaced oil pressure sensor due to Solus not showing immediate pressure, and injector harness under cover. I have a manual fuel guage on the system showing 55 psi during cranking and 60 psi after it lights. Solus is showing around 900 psi desired and same actual during cranking. Solus is showing 175-180 rpm during cranking. The only codes that are active are for intake pressure since valve cover is off and sensor is unplugged. … read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
4,737 satisfied customers
Having trouble with 1999 international 4900 dt466e, 1999
having trouble with 1999 international 4900 dt466e … read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
4,737 satisfied customers
I have a 2005 DT466 and it wont start, give it a sniff of
I have a 2005 DT466 and it wont start, give it a sniff of ether and it will fire right up. I'm thinking high pressure oil pump. Any thoughts? … read more
Mike Mcmillan
Mike Mcmillan
Triage Tech/Shop Foreman
Associates
442 satisfied customers
2000 int. 4900 dt466e runs fine untill temp comes up then
2000 int. 4900 dt466e runs fine untill temp comes up then flashes code and runs like crap no HP has been to int dealer all new wiring harness under hood new HPO pump new ecu new ICP regulator and fuel… read more
Mike Mcmillan
Mike Mcmillan
Triage Tech/Shop Foreman
Associates
442 satisfied customers
I have a 2007 international 7400 with dt466e engine in it. I
I have a 2007 international 7400 with dt466e engine in it. I have hard fault codes 136, 141, 142 trying to diag 136 code first found vehicle has no fuel pressure sensor and vehicle will start up run f… read more
Mike Mcmillan
Mike Mcmillan
Triage Tech/Shop Foreman
Associates
442 satisfied customers
Spoke about a vt365 having oil issues oil psi 50 IHOP 567
Hi spoke about a vt365 having oil issues oil psi 50 IHOP 567 psi no fire has full fuel filter will run on shot of ether then die any insite… read more
Mike Mcmillan
Mike Mcmillan
Triage Tech/Shop Foreman
Associates
442 satisfied customers
Having an issue that goes along with this thread. 1998
Having an issue that goes along with this thread. https://www.justanswer.com/medium-and-heavy-truck/bcdj0-1999-international-dt466e-replaced-oil-pump-hpop.html … read more
Andy
Andy
Truck Diagnostic Technician
Vocational, Technical or Trade School
2,812 satisfied customers
2002 7400 VIN2J050598 still fighting a hard start. After the
Andy,2002 7400 VIN2J050598 still fighting a hard start. After the truck sets for a couple days it won't start easy at all. When you hit the key it kind of fires and runs like crap then slows down and … read more
Andy
Andy
Truck Diagnostic Technician
Vocational, Technical or Trade School
2,812 satisfied customers
I am working on an international 4200 with a vt365 (6.0
I am working on an international 4200 with a vt365 (6.0 powerstroke) in it. The truck originally came in with a hard start issue. It did not matter if it was hot or cold but the only way to start it w… read more
Alex Olsen
Alex Olsen
auto/diesel/industrial
524 satisfied customers
2008 dt466 I have a no start condition.I have fuel pressure.
2008 dt466 I have a no start condition.I have fuel pressure. I have 485-500 psi icp. I have 0 in the desired icp. I am confused on that … read more
Alex Olsen
Alex Olsen
auto/diesel/industrial
524 satisfied customers
I have a 2006 international dt 530e. Today while it was
I have a 2006 international dt 530e. Today while it was sitting at idle the truck died, when I got there with the computer, the codes were PID 164 FMI 1 flash code 335, and SID 1-6 FMI 5 flash code 42… read more
Alex Olsen
Alex Olsen
auto/diesel/industrial
524 satisfied customers
10 months ago there was someone that you were helping
hello 10 months ago there was someone that you were helping with an idle surge problem and was corrected when the icp was unplugged. never seen a post on what fixed it. need some help thanks cliff… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
4,737 satisfied customers
1999 International 4900 DT466e. driver heard a pop and lost
1999 International 4900 DT466e. driver heard a pop and lost all throttle response and power. the truck then died. We cant get it to restart and the ICP is 0 on the computer. We are thinking blown inje… read more
diesel-tech
diesel-tech
Owner of landrys truck repair llc
136 satisfied customers
I have a 2003 International 4300 with a dt466e second
Hello, I'm Junior. I have a 2003 International 4300 with a dt466e second generation engine in it. The last 8 digits of the VIN are 3H591702 with an Engine S/N of 470HM2U1387977. I have had the truck w… read more
Andy
Andy
Truck Diagnostic Technician
Vocational, Technical or Trade School
2,812 satisfied customers
2005 IHC 4300 NO POWER TO DRIVE AND CODE SHOWS SPM 612, PMI
2005 IHC 4300 NO POWER TO DRIVE AND CODE SHOWS SPM 612, PMI 14 FUEL SENSOR SIGNAL OUT OF RANGE WE CLEANED FUEL TANK , BECAUSE OF DRIVER PUT GASOLINE INSTEAD OF DIESEL FUEL AND DROVE 10MILES AND STALLE… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
4,737 satisfied customers
I have a 2006 international dt466e that's keeps dying after
I have a 2006 international dt466e that's keeps dying after the oil temp around 170 due to lose of high pressure oil. have replaced regulator, have dead headed high pressure pump and it spikes to 4,00… read more
Andy
Andy
Truck Diagnostic Technician
Vocational, Technical or Trade School
2,812 satisfied customers
i have a dt466e. the truck will not start without giving it
i have a dt466e. the truck will not start without giving it a little bit of ether. After that it will crank right up. I have 35-40 psi on the schrader valve on filter housing during crank. I have trie… read more
Andy
Andy
Truck Diagnostic Technician
Vocational, Technical or Trade School
2,812 satisfied customers
Hi, I have a 2001 international truck with the DT466E. The
Hi, I have a 2001 international truck with the DT466E. The truck was pulling hard up a hill when the warn/engine light came on and it lost power. It has codes 333 and 335. It starts with a wiff of eit… read more
Jeremy
Jeremy
Certified Truck/Bus Technician
Associate Degree
2,740 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Daniel Wilson

Daniel Wilson

4,737 satisfied customers

Owner at DJ Wilson

Cat Man

Cat Man

Cat Engine Expert

5,234 satisfied customers

I am ASE Master Truck Certified.

Wayne

Wayne

Journeyman

4,023 satisfied customers

worked on, Gmc, Macks, Freight liner,Mercedes Benz,,Ford, sterling

Jeremy

Jeremy

Certified Truck/Bus Technician

2,740 satisfied customers

ASE Med/HD Truck Technician, NATEF Diesel Engines and Electrical/Electronics Technician, Network Engineer specializing in CAN faults, Aftertertreatment, and vehicle communications

cumminsdr

cumminsdr

Mechanic

1,700 satisfied customers

All types of Cummins applications

Curtis B.

Curtis B.

Technician

1,571 satisfied customers

Technician turned service manager on multiple lines of trucks and engines, used in industry.

Chris (aka-Moose)

Chris (aka-Moose)

Technician

353 satisfied customers

24 years of experience diagnosing & repairing

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x