Medium and Heavy Trucks

Have truck repair questions? Ask an Expert

Connect one-on-one with {0} who will answer your question

Related Medium and Heavy Trucks Questions
Cat Man, this is my problem and I sure hope you can help. I
Cat Man, this is my problem and I sure hope you can help. I have an 2006 Freightliner Columbia 120 day cab with a dump bed on it with the Cat C-13 acert motor.KCB52162 It currently has 20,792.8 hours … read more
PAPA Chris
PAPA Chris
Field Service Technician
Automotive Technology
44 satisfied customers
I have a Cat serial # MXS 65840. When I start the engine it
Good Morning. I have a Cat serial # MXS 65840. When I start the engine it runs smooth. After about 2 min it starts to run really rough. Then smooth, then rough and stays rough. What I have noticed is,… read more
Justin
Justin
Diesel Technician
Vocational, Technical or Trade School
8 satisfied customers
Cat Man - 2006 C15 Acert. 2,300,105 miles Last Overhauled
Cat Man -2006 C15 Acert. 2,300,105 miles Last Overhauled 1,250,000 miles by Caterpillar. (2006 Kenworth T600)I'm going to preventively overhaul my engine this month & am wondering what your suggestion… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
Cat man I have a c13 in a International truck that before it
Cat man I have a c13 in a International truck that before it warms up will run ruff and miss and blow some white smoke I have a feeling it is the vva's it has no codes. when it warms up fully runs jus… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
2007 Caterpillar C-15 Acert. 1,314,700 miles on original
2007 Caterpillar C-15 Acert. 1,314,700 miles on original engine. I had an overhead ran and within 2 hours of driving, I got check engine light. Flash codes 94 and 95. I replaced the intake oil pressur… read more
AMANDEEP MAHERU
AMANDEEP MAHERU
1 satisfied customers
I have an 07 Cat C-13 ACERT with prefix KCB. It sometimes
I have an 07 Cat C-13 ACERT with prefix KCB. It sometimes has a strong miss at 1500 while pulling a load. The miss gets less strong up to about 1700. It doesn't happen consistently. When it does occur… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
I've C15 BXS with VVAs put to sleep, and tuned to 650hp. I
I've C15 BXS with VVAs put to sleep, and tuned to 650hp. I has an derate issue when cold, with a load it will only build 35 psi boost, and feels draggy, and after you've driven bout 5-10 minutes it st… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
Im looking for a master Caterpillar technician with the
im looking for a master Caterpillar technician with the specs for the variable valve lash and jake lash on a Cat C15 Acert with serial number of MXS07573 with a Cat Jake brake VVA's and twin turbos. … read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
Cat Man, I need to overhaul a cat c13 KCB78215. I have done
Hey Cat Man, I need to overhaul a cat c13 KCB78215. I have done a couple c15s with no trouble but this engine is a lot different. Why would the head be so full of carbon buildup when this engine doesn… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
I have a 2005 w900L with a mxs cat. It through a boost
I have a 2005 w900L with a mxs cat. It through a boost sensor code so I changed it. It through a 92 code so I changed the vva seleniod. It still is deregulated and is throwing a 93 code now. I'm start… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
6,062 satisfied customers
For CAT Man, I have another issue with a different C13 Truck
For CAT Man, hello again. I have another issue with a different C13 LEE Truck engine. After warm up (running for a couple minutes) engine starts to run rough. I removed air intake pipe at cylinder hea… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
Cat Man, I'm working a Cat c-15 mxs05899. The truck wouldn't
Hi Cat Man, I'm working a Cat c-15 mxs05899. The truck wouldn't reach full boost pressure and it took a while to get the truck up to full road speed. I scanned it and got 2 inactive fault codes. The f… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
This question is only for "Cat Man" and I have a questions.
This question is only for "Cat Man" Hi, my name is ***** ***** I have a questions. I own kenworth T600 2007 with C15 Acert NXS09144. with 1 035 600 miles on the engine. I have vibrations on idle 600 r… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
I have a C-13 Acert in a 2007 Peterbilt 387. I am getting a
I have a C-13 Acert in a 2007 Peterbilt 387. I am getting a 2949-7 Check Engine Code, I also have no Jake Brakes or Cruise. I pulled the Valve cover and noticed when cold cylinders 1,3,5 are dropping … read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
Morning there Cat Man. Wondering if you could give me tune
Morning there Cat Man. Wondering if you could give me tune up info on a C-15 ACCERT? Engine serial # XXXXX 'NXS' INT,EXHT,VVA,JAKE, and INJ Heiht. Is the injector height same as older C-15 or do I nee… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
When I had a scan tool hooked to my SDP c15 it said #4 VIVA
When I had a scan tool hooked to my SDP c15 it said #4 VIVA head was not functioning. It would not test as there was a hard fault. Pulled cover and Actuator,not cracked all solenoids test same ohms wi… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
cat man mxs engine it is reading low oil pressure for the intake
cat man mxs engine it is reading low oil pressure for the intake actuators. So I did what I did on the kcb c13 disconected speed sensors and cranked it over looking for a leak. I didn't see anything. … read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
cat man what size are the duetshe pinsthat go in the ecm on
cat man what size are the duetshe pinsthat go in the ecm on a kcb for the VVAs oil pressure sensor. 14 gauge? I have changed the sensor pulled the harness from ecm and load tested it everything works … read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Daniel Wilson

Daniel Wilson

6,062 satisfied customers

Owner at DJ Wilson

Cat Man

Cat Man

Cat Engine Expert

10,344 satisfied customers

I am ASE Master Truck Certified.

Wayne

Wayne

Journeyman

5,115 satisfied customers

worked on, Gmc, Macks, Freight liner,Mercedes Benz,,Ford, sterling

Jeremy

Jeremy

Certified Truck/Bus Technician

2,756 satisfied customers

ASE Med/HD Truck Technician, NATEF Diesel Engines and Electrical/Electronics Technician, Network Engineer specializing in CAN faults, Aftertertreatment, and vehicle communications

Curtis B.

Curtis B.

Technician

1,947 satisfied customers

Technician turned service manager on multiple lines of trucks and engines, used in industry.

cumminsdr

cumminsdr

Mechanic

1,886 satisfied customers

All types of Cummins applications

Chris (aka-Moose)

Chris (aka-Moose)

Technician

641 satisfied customers

24 years of experience diagnosing & repairing

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x