Medium and Heavy Trucks

Have truck repair questions? Ask an Expert

Connect one-on-one with {0} who will answer your question

Related Medium and Heavy Trucks Questions
Ami 370 mack engine keeps getting hot done replaced heads
ami 370 mack engine keeps getting hot done replaced heads water pump clutch fan and still gets hot… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
11,534 satisfied customers
We have a 2014 Volvo d16. It came into the shop with a
Hi. We have a 2014 Volvo d16. It came into the shop with a little black oil in the rad. So we changed the oil cooler and flushed the rad. Then test drove truck and got it hot. Coolant was clean. Truck… read more
Mike Mcmillan
Mike Mcmillan
Triage Tech/Shop Foreman
Associates
417 satisfied customers
We have a problem with a detroit 12.7 series. Cooling system
cooling system fan sucks air from the engine to the radiator … read more
spankyjr1
spankyjr1
Retired
Vocational, Technical or Trade Scho
420 satisfied customers
I have a 2010 international dirastar you helped me with
Hello Andy , I have a 2010 international dirastar you helped me with before , it is leaking water through exhaust at turbo , I know egr is bad having it changed to it , but they say it could have a cr… read more
Andy
Andy
truck /coach technician
Vocational, Technical or Trade School
207 satisfied customers
I have a CAT 3406E ser # is the 1LW. Engine starts and runs
Engine starts and runs however cylinders 1,2,3 appear to not be firing when checking exhaust manifold temps the front 3 cylinders only reach around 110 degrees F rear 3 cylinders reach 300 plus. Just put in all new injectors, iinjector pump is putting out about 80psi at idle. Took fuel primer pump off and cleaned, check valve, pressure reliief valve was replaced. Ohm tested head wiring harness did not find anything obvious. Also tested voltage going to injectors all were getting power however do not know what the proprer voltage they should be recieving is? Valves, Jakes all adjusted properly. Just running out of ideas. Hoping for some help. Thanks … read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
5,234 satisfied customers
I have a 3306 c (9TL1) cat engine in a dump truck. Head
I have a 3306 c (9TL1) cat engine in a dump truck. Head gasket blew at fire ring back in feburary replaced at that time. When I replaced I checked very thourally the liner protrusion and followed cat … read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
5,234 satisfied customers
Im trying to fix a problem with fuel system, in cummins isx,
Hi, Im trying to fix a problem with fuel system, in cummins isx, its a volvo 2007 with isx. in the beginning it was air in the fuel system, first we though it was an electrical pump, we replaced elect… read more
Wayne
Wayne
Journeyman
Vocational, Technical or Trade Scho
4,023 satisfied customers
I have a c15 acert serial number mxs rates at 550 hp. The
I have a c15 acert serial number mxs rates at 550 hp. The motor has a cold skip that goes away when water temp reaches about 150. The engine was platinum overhauled by thompson caterpillar. It also re… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
5,234 satisfied customers
I have this cat c15 Acert When cold everything runs ok But
Hello sir I have this cat c15 Acert When cold everything runs ok But after it get hot It starts a little missing What could cause that… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
5,234 satisfied customers
Have a 2000 3126B engine SN #8yl52723 that we changed number
Have a 2000 3126B engine SN #8yl52723 that we changed number #6 injector today per diesel shop recommendation for hard start and lack of power. The truck did run okay and would start but we were tryin… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
5,234 satisfied customers
I have a c15 cat in a 2008 Kenw.with a code 3556-7. ,it
Hi I have a c15 cat in a 2008 Kenw.with a code 3556-7. ,it has a new ard. But there is a line coming off the fuel manifold that is blocked off… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
5,234 satisfied customers
have a 2000 freightliner fl 70 3126 engine loss of power after
have a 2000 freightliner fl 70 3126 engine loss of power after 160 degrees have replaced huei injecters all filters with no success… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
5,234 satisfied customers
We have replaced a head gasket on 2007 Fuso 4.9 diesel turbo
We have replaced a head gasket on 2007 Fuso 4.9 diesel turbo and are having trouble with valve adjustment. Please help with specs and adjusting sequence. Do not have this info. We were able to get hea… read more
Curtis B.
Curtis B.
Technician
Associate Degree
1,571 satisfied customers
Have a 2007 model international 9200 with a Cummins ISx. Getting
Have a 2007 model international 9200 with a Cummins ISx. Getting coolant dripping out of the blow by (crankcase ventilation) pipe. Just replaced the oil cooler and air compressor and dont know if eith… read more
cumminsdr
cumminsdr
Mechanic
High School or GED
1,700 satisfied customers
I HAVE C-13 ACERT WITH PUSHING COOLANT OUT OF THE OVERFLOW.
I HAVE C-13 ACERT WITH PUSHING COOLANT OUT OF THE OVERFLOW. THE THERMOSTAT,AND WATERPUMP HAS BEEN REPLACED ,ALSO BYPASSED AIR COMPRESSOR UNIT IS STILL BUILDING UP PRESSURE… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
5,234 satisfied customers
We have a 2006 IH school bus with a dt 466. It has developed
We have a 2006 IH school bus with a dt 466. It has developed a problem of building too much pressure in the cooling system. I have eliminated about everything I can think of. We are about to pull the … read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
5,234 satisfied customers
Thanks for the fast response. Would there be contaminants
Thanks for the fast response. Would there be contaminants such as oil In the coolant if the head is cracked. Also, one suggestion from another Trucker was to clean the inside of the radiator. Another … read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
5,234 satisfied customers
2007 hino truck is using antifreeze but no leaking in or in
2007 hino truck is using antifreeze but no leaking in or in the oil it run good it don,t get hot but the thetop tank is hot but the bottom tank is cold… read more
spankyjr1
spankyjr1
Retired
Vocational, Technical or Trade Scho
420 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Daniel Wilson

Daniel Wilson

11,534 satisfied customers

Owner at DJ Wilson

Cat Man

Cat Man

Cat Engine Expert

5,234 satisfied customers

I am ASE Master Truck Certified.

Wayne

Wayne

Journeyman

4,023 satisfied customers

worked on, Gmc, Macks, Freight liner,Mercedes Benz,,Ford, sterling

Jeremy

Jeremy

Certified Truck/Bus Technician

2,740 satisfied customers

ASE Med/HD Truck Technician, NATEF Diesel Engines and Electrical/Electronics Technician, Network Engineer specializing in CAN faults, Aftertertreatment, and vehicle communications

cumminsdr

cumminsdr

Mechanic

1,700 satisfied customers

All types of Cummins applications

Curtis B.

Curtis B.

Technician

1,571 satisfied customers

Technician turned service manager on multiple lines of trucks and engines, used in industry.

Chris (aka-Moose)

Chris (aka-Moose)

Technician

353 satisfied customers

24 years of experience diagnosing & repairing

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x