Medium and Heavy Trucks

Have truck repair questions? Ask an Expert

Connect one-on-one with {0} who will answer your question

Related Medium and Heavy Trucks Questions
I have a 2004 dt466e low voltage or open circuit all
I have a 2004 dt466e low voltage or open circuit all cylinders. There's 4000 psi coming from the HPop. An icp low volt code. Replaced sensor replaced injector wiring harness plumbed thru the valve cov… read more
Bradey V
Bradey V
Certificate
DT466E crank / no start. 2006 IH 8100 DT466E. Repairing
Repairing myself. Engine will fire right up on ether and immediately run smooth with no smoke. I have replaced all injector orings, replaced one complete injector, replaced check ball before primer pump, replaced oil pressure sensor due to Solus not showing immediate pressure, and injector harness under cover. I have a manual fuel guage on the system showing 55 psi during cranking and 60 psi after it lights. Solus is showing around 900 psi desired and same actual during cranking. Solus is showing 175-180 rpm during cranking. The only codes that are active are for intake pressure since valve cover is off and sensor is unplugged. … read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
11,892 satisfied customers
International DT466E Crank no start. Unable to build icp
International DT466E Crank no start. Unable to build icp during crankingAlready replaced ipr Base engine oil pressure while cranking 20 psi… read more
Andy
Andy
truck /coach technician
Vocational, Technical or Trade School
207 satisfied customers
2000 INTERNATIONAL 4700 dt 466E, trucks cranks and runs
2000 INTERNATIONAL 4700 dt 466E , trucks cranks and runs perfect but after a few mins , actually goes to shutting off and runnin up and down up and down , i am very knowledgable abt a dt466e i have ac… read more
Andy
Andy
truck /coach technician
Vocational, Technical or Trade School
207 satisfied customers
2000 int. 4900 dt466e runs fine untill temp comes up then
2000 int. 4900 dt466e runs fine untill temp comes up then flashes code and runs like crap no HP has been to int dealer all new wiring harness under hood new HPO pump new ecu new ICP regulator and fuel… read more
Mike Mcmillan
Mike Mcmillan
Triage Tech/Shop Foreman
Associates
431 satisfied customers
Engine idles smoothly with no fault codes. As it starts to
engine idles smoothly with no fault codes. As it starts to accelleraty,, at about 800RPM, I get injector codes sid 5 and 2, fmi 5. A little faster, about 850RPM the rest of the injectors code active. … read more
Mike Mcmillan
Mike Mcmillan
Triage Tech/Shop Foreman
Associates
431 satisfied customers
Hard to start, running okay at idle, but idle up and start
hard to start, running okay at idle, but idle up and start running rough and smoke. … read more
Mike Mcmillan
Mike Mcmillan
Triage Tech/Shop Foreman
Associates
431 satisfied customers
I have a DT466E with low ICP pressure. New IPR valve, new
I have a DT466E with low ICP pressure. New IPR valve, new HPOP, all 6 new injectors, still low ICP. Pulled new HPOP off and had it bench tested, all good. Any suggestions? … read more
Andy
Andy
truck /coach technician
Vocational, Technical or Trade School
207 satisfied customers
Working on a 97 international with a DT466E. Last 8 of VIN
Working on a 97 international with a DT466E. Last 8 of VIN are VH451530.I keep getting two persistent codes. 164-10 Injection control pressure abnormal rate of change. 164-0 Injection control pressure… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
11,892 satisfied customers
2006 international vt365. Has a miss on cylinders 2 and 7.
2006 international vt365. Has a miss on cylinders 2 and 7. Replaced injectors and injector to idm wiring. Both cylinders have 300 psi compression. Truck has new head gaskets as well.… read more
Alex Olsen
Alex Olsen
auto/diesel/industrial
524 satisfied customers
I have a problem with dt466e. it would not start. the truck
Hello Andy I have a problem with dt466e. it would not start. the truck was running and 1 of the injector was push out of the cylinderhead. So the client makes the repairs and it started then and the t… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
11,892 satisfied customers
I have a 2007 international with a dt466 and it won't start.
I have a 2007 international with a dt466 and it won't start. I've checked fuel pressure and injection control pressure they are good. What else to check?… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
11,892 satisfied customers
10 months ago there was someone that you were helping
hello 10 months ago there was someone that you were helping with an idle surge problem and was corrected when the icp was unplugged. never seen a post on what fixed it. need some help thanks cliff… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
11,892 satisfied customers
2001 International 4700 with DT466E engine serial number
2001 International 4700 with DT466E engine serial number(###) ###-#### ***** is pre-EGR with the fuel supply rail mounted to the side of the head. Looking for the minimum pressure required to open the… read more
Andy
Andy
truck /coach technician
Vocational, Technical or Trade School
207 satisfied customers
i have a 2006 international bus with an international
i have a 2006 international bus with an international engine VT365. I replaced the EGR/ oil cooler because they were leaking. After i finished the job the engine didnt start. There is no codes. Please… read more
Jeremy
Jeremy
Certified Truck/Bus Technician
Associate Degree
2,740 satisfied customers
2004 international 4400 with dt466. Runs rough and white smokes.
2004 international 4400 with dt466. Runs rough and white smokes. Fuel pressure shows 60psi at idle. Icu pressure actual and desired match. It will fail all cylinders on a cylinder contribution test. I… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
11,892 satisfied customers
My truck died. Scanner said oil pressure switch. Replaced it
My truck died. Scanner said oil pressure switch. Replaced it no run scanner said icp. Have not replaced that. Checked fuel pressure 60 psi. Oil 60 psi. high pressure pump is next I don't know what pre… read more
Jeremy
Jeremy
Certified Truck/Bus Technician
Associate Degree
2,740 satisfied customers
I am working on a 1996 International 4900 with a DT466E. The
I am working on a 1996 International 4900 with a DT466E. The engine will miss and smoke on no load acceleration. You can smell the raw fuel in the smoke. During troubleshooting it will stop missing an… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
5,234 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Daniel Wilson

Daniel Wilson

11,892 satisfied customers

Owner at DJ Wilson

Cat Man

Cat Man

Cat Engine Expert

5,234 satisfied customers

I am ASE Master Truck Certified.

Wayne

Wayne

Journeyman

4,023 satisfied customers

worked on, Gmc, Macks, Freight liner,Mercedes Benz,,Ford, sterling

Jeremy

Jeremy

Certified Truck/Bus Technician

2,740 satisfied customers

ASE Med/HD Truck Technician, NATEF Diesel Engines and Electrical/Electronics Technician, Network Engineer specializing in CAN faults, Aftertertreatment, and vehicle communications

cumminsdr

cumminsdr

Mechanic

1,700 satisfied customers

All types of Cummins applications

Curtis B.

Curtis B.

Technician

1,571 satisfied customers

Technician turned service manager on multiple lines of trucks and engines, used in industry.

Chris (aka-Moose)

Chris (aka-Moose)

Technician

353 satisfied customers

24 years of experience diagnosing & repairing

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x