Medium and Heavy Trucks

Have truck repair questions? Ask an Expert

Connect one-on-one with {0} who will answer your question

Related Medium and Heavy Trucks Questions
2ws cat runs but dies. 2013 kenworth w900l. 907000. Motor is
2ws cat runs but dies. JA: What's the make, model, and year of your car? Customer: 2013 kenworth w900l JA: What's the approximate mileage on your car? Customer: 907000 JA: Is there anything else the c… read more
Nich1019
Nich1019
Diesel Technician
Vocational, Technical or Trade School
64 satisfied customers
Which pin do you check on ecm harness to make sure you have
Which pin do you check on ecm harness to make sure you have proper voltage to have ecm turn on and let engine fire up. Engine cranks over fine, just won't always fire up, no check engine lights, batte… read more
Wayne
Wayne
Journeyman
Vocational, Technical or Trade Scho
5,115 satisfied customers
Jakes won't work c15 cat 2004 KW 900l Have replaced dash
jakes won't work c15 cat 2004 KW 900l Have replaced dash switches clutch switch works. every once in a while the jakes will come on but not very often … read more
Nich1019
Nich1019
Diesel Technician
Vocational, Technical or Trade School
64 satisfied customers
My 2005 kenworth w900l with a detroit series 60 has a issue,
Hi. My 2005 kenworth w900l with a detroit series 60 has a issue, When I drive it an then press the ac button to turn on the ac It accelerates around 350 rpm and has more power. When I have it idle and… read more
Joe Green
Joe Green
71 satisfied customers
I have a 2016 Kenworth w900l my brake Applicator needle is
I have a 2016 Kenworth w900l my brake Applicator needle is showing that brakes are being applied full force. My brake lights come on when I open the door. And on the dash it shows secondary air pressu… read more
Nich1019
Nich1019
Diesel Technician
Vocational, Technical or Trade School
64 satisfied customers
I have 2003 kenworth t300 with cat 3126 will not start was
Good morning I have 2003 kenworth t300 with cat 3126 will not start was running just died no voltage at heui pump tach inop no codes … read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
I have a 3176 in a 94' Kenworth SN#9ck31474. I died when I
I have a 3176 in a 94' Kenworth SN#9ck31474. I died when I was warming it up. It slowly ran down like it ran out of fuel. I replaced the water separator and the fuel filter and drained the fuel out of… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
I have a N14 Cummins select that I shut off for about an
I have a N14 Cummins select that I shut off for about an hour and when I went to go restart it it would not start. It has been having a little bit of a doggie idol so I suspected a fuel shut off solen… read more
Mike Mcmillan
Mike Mcmillan
Triage Tech/Shop Foreman
Associates
591 satisfied customers
I have a 2009 Kenworth w900l and I'm currently having
I have a 2009 Kenworth w900l and I'm currently having problems with both the wipers and washer fluid pump. Replaced both wiper motor and switch. Also checked fuses and relays.… read more
Andy
Andy
truck /coach technician
Vocational, Technical or Trade School
214 satisfied customers
Cat man have c-15 cat no start. Cat man kw w900 2/97 cat 5ek
yes truck quit going down road, had towed, 1 Have had ecm taken to cat, cat said bad ecm kenworth dealer programed ecm. 40 pin, installed still no start, so far have replaced engine harness, and cam sensor, have had connected to cat et. no codes, but no rpm while cranking, ( Will run on either . Have checked power on pin 6 and 4 have 12 volts, and ground #5 have used electric motor, have checked power to cam sensor, with volt meter showing 11.5 to 12 volts on two pins, but when trying with electric motor no power, have tried while cranking, also. Have tried pin 6 power to pin 29 sensor ground and have no ground. does not seem to turn injectors on. ( Note have looked at cam gear, and found a piece broken on back side, ) But I think should have rpm signals, … read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
I have a 2007 Kenworth w900l had a leak inside. now I have
I have a 2007 Kenworth w900l had a leak inside. now I have light issues. headlights come on without switch being on. no flashers.no turn signals, no flashers no bright lights. power latch or power win… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
6,062 satisfied customers
95 W900L with 3406E Cat, drawing fuel from right tank only
95 W900L with 3406E Cat, drawing fuel from right tank only and seems to only return to left tank. New splitter valve and 4 new fuel lines. Vents are working and caps are new. … read more
Eddy
Eddy
HD Truck Tech
GED
2 satisfied customers
I have a crank but no start on a 3406e. Cant seem to get a
i have a crank but no start on a 3406e. Cant seem to get a voltage reading at the injectors with the key in the "on" position. i have checked for air in the fuel line but i believe the problem is that… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
2013 kenworth t800 Cummins engine which one is the fuse
2013 kenworth t800 Cummins engine which one is the fuse location for the diagnostic link. Also, which wire in the diagnostic plug that should have 12v. I test the plug and have no power to read what c… read more
cumminsdr
cumminsdr
Mechanic
High School or GED
1,886 satisfied customers
I'm looking at possibly buying a 2006 Kenworth W900L with a
Hi, I'm looking at possibly buying a 2006 Kenworth W900L with a C-15 Cat engine. Is this a good engine and what year exactly did Cat start putting all the emissions equipment on the C-15 ? After all t… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
, I am trying to get a CAN data logger working on a 2003
Hi, I am trying to get a CAN data logger working on a 2003 Kenworth W900L with C15 and manual transmission. The data logger supports the J1939 standard over CAN. The 9-pin connector under the dash is … read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
I have a 1996 W900L with an engine retarder brake problem.
I have a 1996 W900L with an engine retarder brake problem. This unit originally had a smart wheel, but the switches has worn out and the replacement wheel is no longer available. The unit has been con… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
Hi, I have a cat c12 engine in a KW T-800 that will not start.
Hi, I have a cat c12 engine in a KW T-800 that will not start. It seems like its not getting any fuel while cranking. The tanks are full of fuel along with the filters. There is also alot of fuel pres… read more
Cat Man
Cat Man
Cat Engine Expert
Vocational, Technical or Trade Scho
10,344 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Daniel Wilson

Daniel Wilson

6,062 satisfied customers

Owner at DJ Wilson

Cat Man

Cat Man

Cat Engine Expert

10,344 satisfied customers

I am ASE Master Truck Certified.

Wayne

Wayne

Journeyman

5,115 satisfied customers

worked on, Gmc, Macks, Freight liner,Mercedes Benz,,Ford, sterling

Jeremy

Jeremy

Certified Truck/Bus Technician

2,756 satisfied customers

ASE Med/HD Truck Technician, NATEF Diesel Engines and Electrical/Electronics Technician, Network Engineer specializing in CAN faults, Aftertertreatment, and vehicle communications

Curtis B.

Curtis B.

Technician

1,947 satisfied customers

Technician turned service manager on multiple lines of trucks and engines, used in industry.

cumminsdr

cumminsdr

Mechanic

1,886 satisfied customers

All types of Cummins applications

Chris (aka-Moose)

Chris (aka-Moose)

Technician

641 satisfied customers

24 years of experience diagnosing & repairing

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x