Mazda

Mazda repair questions? Ask mechanics for answers ASAP

Ask an Expert,
Get an Answer ASAP!

Related Mazda Questions
I have a 05 Mazda Rx8 6-port 1.3 renesis rotary engine with
I have a 05 Mazda Rx8 6-port 1.3 renesis rotary engine with manual transmission. … read more
Eric
Eric
Retired
N/A
33,571 satisfied customers
I have a 2003 mazda protege 5 2.0l DOHC. I just replaced the
Hi i have a 2003 mazda protege 5 2.0l DOHC. I just replaced the motor in it due to the old one blowing up. Now i have everything together and it starts up and runs and then dies very quickly after. It… read more
Chad Farhat
Chad Farhat
Owner
Associate Degree
5,839 satisfied customers
Mazda 6: 2005 Mazda 6 2.3 engine getting recurring code P2187.
2005 Mazda 6 2.3 engine getting recurring code P2187. Have a new MAF and new upstream and downstream O2 sensors. Short term trim fluctuates between 6 and 20 and long term is 20.2. Upstream sensor is s… read more
Chad Farhat
Chad Farhat
Owner
Associate Degree
5,839 satisfied customers
Hi Drew, I have a 2000 Mazda Protege, 1.6 4-door DX. I am
Hi Drew, I have a 2000 Mazda Protege, 1.6 4-door DX. I am not sure if I can explain the problem very well. When I am going up a hill the problem is more prevalent. However, when I am driving the car o… read more
Wayne Crawford
Wayne Crawford
3,928 satisfied customers
Mazda Protege DX: 03 Protege P0300 random multiple misfire
'03 Protege P0300 random multiple misfire code present. Replaced spark plugs, wires, coil on plug boots, PCV valve, air filter. Inspected fuel pressure & fuel pressure regulator for leaks. Smoke test … read more
Greg
Greg
Shop owner, technician
Vocational, Technical or Trade Scho
5,794 satisfied customers
Mazda 626: Drew I am still having trouble with code P0106
Drew I am still having trouble with code P0106 resetting. I have gone thru all 10 diagnosis steps that you sent to me. All checks are within spec.s. Can hear initialization noise from EGR valve with k… read more
Drew
Drew
Super Mazda Tech.
Vocational, Technical or Trade Scho
2,188 satisfied customers
Mazda 626LX: I have a 1998 Mazda 626, 2.0L MFI DOHC, with code
I have a 1998 Mazda 626, 2.0L MFI DOHC, with code P0106. I have checked voltage and ground on boost sensor wire Gry-Red 5.0V Blk-Yel 0.V Yel-Blk 4.6V. Removed vacuum from sensor and connected vacuum p… read more
Drew
Drew
Super Mazda Tech.
Vocational, Technical or Trade Scho
2,188 satisfied customers
2002 Mazda Protege5: manual trans..driven..stick..check engine light
I have a 2002 Mazda Protege5 manual trans, our problem is this... when starting form a stop, it start lurching, as if someone has never driven a stick before. here is what has happened. we had a check… read more
Drew
Drew
Super Mazda Tech.
Vocational, Technical or Trade Scho
2,188 satisfied customers
1997 Mazda Protege: terminal..test connector..idle speed..circuit
The grounding of number ten terminal on the test connector of my 1997 Mazda Protege when adjusting timing or idle speed has no effect on either one. This was listed on my smog check as part of the fun… read more
Drew
Drew
Super Mazda Tech.
Vocational, Technical or Trade Scho
2,188 satisfied customers
200 Mazda protege: 000 miles..diagnostic computer..p0401..ve driven
I own a 200 Mazda protege with approx 147,000 miles on it. My CEL came on recently, and as my housemate owns a diagnostic computer, we checked it and got a p0106 error and a p0401 error. The car hasn'… read more
Greg
Greg
Shop owner, technician
Vocational, Technical or Trade Scho
5,794 satisfied customers
mazda protege dx: check engine light..fuel filter..fuel tank..assembly
I have an 01 mazda protege dx (1.6 liter engine) with a check engine light on. I took it to autozone they plugged it in and got a "po171 code - too lean" and suggested changing fuel filter. from what … read more
Greg
Greg
Shop owner, technician
Vocational, Technical or Trade Scho
5,794 satisfied customers
1996 mazda miata: obd2..they are egr,o2 sensor,catalyst
1996 mazda miata will not go to ready on 3 monitors for obd2. they are egr,o2 sensor,catalyst. the o2 heater does go ready. new o2 sensors, catalytic converter, egr and mass air flow sensor. the car w… read more
Drew
Drew
Super Mazda Tech.
Vocational, Technical or Trade Scho
2,188 satisfied customers
Sensors..fault codes..an intake manifold leak cause this
vehicle will not idle ; injector pulse width is 30.9-32 ms at idle;maf reads 7 g/sec;o2 sensors will not switch below 500 mv;no fault codes.will an intake manifold leak cause this?… read more
Amedee
Amedee
Automotive Consultant
Vocational, Technical or Trade Scho
19,484 satisfied customers
99 Miata: normal acceleration , stumbles..gas pedal..mph..crank
99 Miata , falls flat on its face under normal acceleration , stumbles and almost shuts off . If you lightly touch the gas pedal you can run the car up to 100 mph fine , It holds road speed fine ,, ju… read more
Amedee
Amedee
Automotive Consultant
Vocational, Technical or Trade Scho
19,484 satisfied customers
Mazda Protege DX 99 protege dx, 1.6 eng. Check engine lght
99 protege dx, 1.6 eng. Check engine lght activated, Code PO123. Overdrive indicator light blinking. Car only went to 2nd gear, would slow down as if fuel supply low then come back up. Put on OCM scan… read more
Drew
Drew
Super Mazda Tech.
Vocational, Technical or Trade Scho
2,188 satisfied customers
95 mazda 626: v..car idles great.sometimes..rpms..stall..blower
95 mazda 626 v-6 auto.. car idles great.sometimes drive great but while drivin it drops rpms like it turns off then rpms go up and takes off again does not stall and does not mess with radio,blower or… read more
Drew
Drew
Super Mazda Tech.
Vocational, Technical or Trade Scho
2,188 satisfied customers
Mazda Protege 5 I have a 2002 mazda p5 and had a low idle
I have a 2002 mazda p5 and had a low idle and CEL on. I read that this would point to the EGR valve, is this true? I removed the EGR and cleaned it, the plunger spring and valve move freely, and I re-… read more
Drew
Drew
Super Mazda Tech.
Vocational, Technical or Trade Scho
2,188 satisfied customers
Mazda: o2 sensor heater circuits..aftermarket..exhaust..running fine
Question most suited for experienced Mazda factory tech. Vehicle: 2003 Mazdaspeed Protege 2.0L DOHC Turbo roughly 75K miles Vehicle suddenly began running very rough when started after sitting overnig… read more
jeffrey590
jeffrey590
Automotive Diagnostic Specialist
Vocational, Technical or Trade Scho
2,819 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.

CharlesWalnut Creek, CA

As a single woman, I really appreciate an excellent and affordable opinion.
Thank you Geordie, I will not hesitate to contact justanswer in the future!

SueCharleston, WV

Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.

JimCastleberry, FL

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

< Previous | Next >

Meet the Experts:

Drew

Drew

Super Mazda Tech.

2,188 satisfied customers

19 yrs. experience. Mazda Senior Certified Tech, with Ford, Linc. & Merc. experience. ASE L1 Advanced Certified Master Tech.

Chris (aka- Moose)

Chris (aka- Moose)

Technician

54,632 satisfied customers

16 years of experience

mazdamaster577

mazdamaster577

Master Technician

691 satisfied customers

mazda master/shop foreman for 15 years.

George H.

George H.

ASE Certified Technician

459 satisfied customers

15+Years

Ron Z.

Ron Z.

- Mazda Tech -

425 satisfied customers

18+yrs experience. State Inspector and Mazda Diagnostics

Mike Kelly

Mike Kelly

Mazda Mechanic

273 satisfied customers

17 years experience as an auto mechanic, foreign and domestic. 5 years running my own repair business.

Mazda Ed

Mazda Ed

ASE Certified Technician

264 satisfied customers

ASE Certified Mazda Master Technician

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x