How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Mazda expert Your Own Question
Mazda expert
Mazda expert, ASE Certified Technician
Category: Mazda
Satisfied Customers: 10370
Experience:  30 years experience
22989858
Type Your Mazda Question Here...
Mazda expert is online now
A new question is answered every 9 seconds

Mazda Mazda 6 How do I remove the waterpump drive pulley from

Resolved Question:

How do I remove the waterpump drive pulley from the exhaust cam shaft of a 2004 Mazda 6 3.0 V6. I was told that it is a press-fit, but fail to understand how it remains on the cam shaft withoutany type o bolt or retention device.
Submitted: 6 years ago.
Category: Mazda
Expert:  Mazda expert replied 6 years ago.
Welcome to just answer.com. I'm here to help you and your 100% satisfaction is my goal. The water pump pulley is remove then installed using special tools shown here in the procedure

WATER PUMP REMOVAL/INSTALLATION

  1. Disconnect the negative battery cable.
  2. Remove the under cover.
  3. Remove the air cleaner.
  4. Drain the engine coolant.
  5. Remove the water pump drive belt pulley.

 

Attachments are only available to registered users.

Register Here


Replace part A of the SST [303-009 (49 UN30 3009)] with the SST [303-457 (49 UN30 3457)].

Attachments are only available to registered users.

Register Here


Remove the water pump drive belt pulley using the SSTs.

 

  1. Remove in the order indicated in the table.
  2. Install in the reverse order of removal.

NOTE:
Tighten the bolts to the specified torque, then tighten them further 85°- 95° .
Tightening torque: 10 Nm (102 kgf-cm, 89 inch lbs.)

Attachments are only available to registered users.

Register Here


 

  1. Install the water pump drive belt pulley using the SST.
  2. Add the engine coolant.

 

Mazda expert and 4 other Mazda Specialists are ready to help you