Marine Electronics

Marine electronics questions? Ask a technician for answers ASAP

Ask an Expert,
Get an Answer ASAP!

Related Marine Electronics Questions
Stalling 200hp outboard. Lookin for some advance / guidance.
Stalling johnson 200hp outboard. Lookin for some advance / guidance.I Bought a used boat about 2 months ago, slowly got it seaworthy, had mechanic rebuild carbs, and had low end rebuilt too. Fuel wate… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
605 satisfied customers
97 75hp Mercury O/, lacks power & vibrates boat under load.
97 75hp Mercury O/B, lacks power & vibrates boat under load. Its mounted on a 24' Kayot pontoon flat deck boat. It used to cruiose @ about 25mph, but now w/engine issue, I can only get to about 12mph … read more
Boat Doc
Boat Doc
566 satisfied customers
Second opinion] 1973 6hp O/ (M# 6R-73S), Running on 50:1
Second opinion] 1973 6hp Johnson O/B (M# *****), Running on 50:1 mix, wont idle---stumbles, misses, stalls any lower than 1/8" before the start position on the throttle/tiller handle, but runs ok/good… read more
Charles
Charles
Certified Mercury Tech
10,500 satisfied customers
Working on the carburetors on my 77 evenrude 85 hp question
hello working on the carburetors on my 77 evenrude 85 hp question is do the high & low speed orifice plugs have holes through them or are they just a plug and are they adjustable… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
91 satisfied customers
I am re-wiring my 50 hp outboard motor. Most electrical
I am re-wiring my 50 hp Johnson outboard motor. Most electrical parts are still good, just dirty as hell. What is the best method on cleaning these?… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
91 satisfied customers
I have a 1986 70 HP that runs great in gear, but won't idle.
I have a 1986 johnson 70 HP that runs great in gear, but won't idle. Motor was recently rebuilt and all carbs have been overhauled and we'll cleaned. Motor idles fine on the muffs, but will stall out … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
91 satisfied customers
I have 3 year old 4 cycle 2.5 hp mercury outboard.great
I have 3 year old 4 cycle 2.5 hp mercury outboard.great engine when i used it 3 yrs ago. shut it down for 2 years and never drained fuel.. couldn't start it. disassembled carb , cleaned it thoroughly,… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
605 satisfied customers
I have a 96 150 hp ocean pro I was just wondering if you
I have a 96 150 hp ocean pro I was just wondering if you could give me some problem solving ideas on what could be wrong . I disconnected the gas hose entering the pump (the one with the white filter)… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
91 satisfied customers
I have a 2003 johnson 50HP 2cyl outboard. When priming the
I have a 2003 johnson 50HP 2cyl outboard. When priming the fuel, you can see massive amounts of gas coming from what looks like a crack in the VRO pump. Obviously I need to replace the pump, however, … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
91 satisfied customers
I have a Yamaha 60hp T60TlRC 4 stroke 2004. It will barely
I have a Yamaha 60hp T60TlRC 4 stroke 2004. It will barely start and very rough idle. Give any gas at all and stalls. I have replaced all four plugs with the correct ones gaped correctly. Take apart a… read more
Charles
Charles
Certified Mercury Tech
10,500 satisfied customers
I have a 225 Johnson year 91 will a stator of a 96 fit it
I have a 225 Johnson year 91 will a stator of a 96 fit it so far all the stators don,t have the wires in the same position where the orange wires are on mine all the others stators I have seen are bro… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
605 satisfied customers
we have a 1982 johnson 75hp 3 cyl engine, having an issue with
we have a 1982 johnson 75hp 3 cyl engine, having an issue with getting higher rpm, top rpm is about 3000 rpm, occasionally it will jump up to about 5000 and take of and go. Not missing or sputtering, … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
605 satisfied customers
I have a 1988 johnson 90hp and i am haveing problems sych and
I have a 1988 johnson 90hp and i am haveing problems sych and linking it because it should be at 4 degrees atdc at idle and the only way i can keep it running is about 12 degrees. It just started to d… read more
Jeremy R.
Jeremy R.
1,138 satisfied customers
Hi! I have a 1998 Johnson Ocean Pro engine without any cables,
Hi! I have a 1998 Johnson Ocean Pro engine without any cables, controls or fuel lines attached (I removed it from a boat I had in the US, and I now live in Sweden). I bought a boat which has an Evinru… read more
Jeremy R.
Jeremy R.
1,138 satisfied customers
1999 johnson outboard 150 horsepower. model# j150plees. I have
1999 johnson outboard 150 horsepower. model# XXXXX I have good compression, have fuel being delivered to motor. The number 3 cylinder has no spark. The # XXXXX cyl is the only hole thathas no spark. I… read more
Noel Schembri
Noel Schembri
Marine Technician
Diploma
51 satisfied customers
I just ask this question but the power went out here and lost
I just ask this question but the power went out here and lost everything so here it is again. I have a 1990 60hp Johnson outboard that i need to set the timing on in the lake but still on the trailor.… read more
Cory
Cory
LICENSED CHARTER CAPTAIN
High School or GED
261 satisfied customers
i have a johnson 88 hp i think it is a 1988 it has a tach
i have a johnson 88 hp i think it is a 1988 it has a tach on it but not wired also thay put new key switch what do ineed to wire it ?… read more
Jeremy R.
Jeremy R.
1,138 satisfied customers
I have a johnson 50 hp 2006 its running after 2300 rpm as if
I have a johnson 50 hp 2006 its running after 2300 rpm as if it had a rev limiter on it .I checked cdi output 178volts top of coil with DVA on,184volts with DVA on bottom of [email protected] 2,800 rpm,coil resis… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,400 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Jason

Jason

Marine Mechanic

605 satisfied customers

Degree in Marine Technology, Also Certified with Mercury Marine, MCM, MIE, VP, Yamaha, Honda, Suzuki

Captain Dave

Captain Dave

USCG Licensed Captain

136 satisfied customers

Over 20 years experience installing, maintaining, and using sophisticated marine electronics.

Tan

Tan

MerCruiser Certified Technician

91 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Neil

Neil

Marine Electronics Dealer

73 satisfied customers

NZCE Electronics and Computing

Ropesmarine

Ropesmarine

Boat Enthusiast

70 satisfied customers

13+ years of installing and troubleshooting, FCC License with radar endorsment, CMET

Noel Schembri

Noel Schembri

Marine Technician

51 satisfied customers

Marine mechanic / electrical technician

yachtwork

yachtwork

Marine Engineer

35 satisfied customers

Yachtmaster Ocean & MEC3

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x