Jeep

Have Jeep questions? Ask a Jeep repair expert for answers

Connect one-on-one with {0} who will answer your question

Related Jeep Questions
jeep cherokee: i have a 1998 jeep cherokee 4.0 4x4 that im
i have a 1998 jeep cherokee 4.0 4x4 that im getting a po340 and po700 and po753 and po740 code car will not start turns over fine can find the crankshaft sensor but not the camshaft sensor can you hel… read more
Tim Mohr
Tim Mohr
ASE MASTER TECH
Master's Degree
1,107 satisfied customers
Jeep Cherokee Sport: I have a 1997 Jeep cherokee*****
I have a 1997 Jeep cherokee***** It will start run and idle perfect. Then all of a sudden it will shutter and shutdown and will not start again. sometimes it will start in a few minutes then other tim… read more
Amedee
Amedee
Automotive Consultant
Vocational, Technical or Trade Scho
21,486 satisfied customers
I have a 2006 Jeep with a 4.7L stroker in it. It is throwing
I have a 2006 Jeep with a 4.7L stroker in it. It is throwing the code P0016 and ive replaced the crank sensor the cam sensor and the oil pump drive as it was worn. Any ideas on what is throwing this c… read more
Chris
Chris
Shop Foreman
3,932 satisfied customers
Jeep Wrangler: Engine code P0016- Crank position,camshaft position
Engine code P0016- Crank position,camshaft position correlation-Bank 1 Sensor A. Where is the sensor located that causes this code and what sensor is it?… read more
Euro Specialist
Euro Specialist
Owner/Technician
Vocational, Technical or Trade Scho
665 satisfied customers
Jeep Grand Cherokee Limited: my 1997 jeep grand cherokee has
my 1997 jeep grand cherokee has a 99 durango 5.2 litre motor. My daughter parked it the other day and now it won't start. There is no spark. It has new plugs, wires, distributor cap and rotor that wer… read more
Jerry
Jerry
Service consultant
Vocational, Technical or Trade Scho
13,108 satisfied customers
Jeep Cherokee classic: 98 Jeep cherokee This car has a spook-the
98 Jeep cherokee This car has a spook-the local repair shop and the Jeep Dealership doesnt seem to be able to fix it. The "board" was replaced 2 years ago but that didn't fix the problem for long. Car… read more
Chris
Chris
Shop Foreman
3,932 satisfied customers
Cherokee: 4.0...hei distributor will not work with efi (no cam sensor)
I have a 93' Cherokee with the stock 4.0. I resently attempted to install a DUI (HEI) distributor. After about a 100 hours of problems I finally discovered that the HEI distributor will not work with … read more
Amedee
Amedee
Automotive Consultant
Vocational, Technical or Trade Scho
21,486 satisfied customers
Jeep Cherokee: cylinder..put gas in it it wont start.
Have 1996 4 cylinder Jeep Cherokee I bought cheap. The guy said it ran out of gas. We both put gas in it it won't start. I changed the fuel filter. I had my son turn the engine over I am getting no vo… read more
Ricardo Hohl
Ricardo Hohl
Auto Motive Instructor
Automotive tech
4,550 satisfied customers
1990 Jeep Cherokee Laredo: 4.0 liter..crank..wont start..intermittent
1990 Jeep Cherokee Laredo xj 6cyl. 4.0 liter will crank, but won't start. Problem has been intermittent for last three years. The following items have been replaced; distributor cap, ignition rotor, s… read more
Ricardo Hohl
Ricardo Hohl
Auto Motive Instructor
Automotive tech
4,550 satisfied customers
1994 Jeep Grand Cherokee laredo: 5.2L V8 Auto Trans..everything works
1994 Jeep Grand Cherokee Laredo 5.2L V8 Auto Trans. Having an issue that only occurs when the engine is cold. Once warmed up, everything works and runs beautifully. Here's what happens when starting C… read more
Amedee
Amedee
Automotive Consultant
Vocational, Technical or Trade Scho
21,486 satisfied customers
1999 Jeep cherokee classic: intermittent..cranking..misfire and p0340
I have 1999 Jeep cherokee classic with a inline 6 cylinder. I get error code p1391 intermittent loss of either camshaft or crankshaft position sensor and p0340 no camshft signal detected during cranki… read more
jeepmopar76
jeepmopar76
Jeep/Chrysler Triple Master Tech
Vocational, Technical or Trade Sc
581 satisfied customers
1995 jeep grand cherokee: compression..injector pulse..i switched ecm
I put a used motor from a 1994 jeep grand cherokee wrecked with 5.2 into a 1995 jeep grand cherokee with a 5.2 with low compression. both motors ran when i switched them i put a new crank sensor on th… read more
Ricardo Hohl
Ricardo Hohl
Auto Motive Instructor
Automotive tech
4,550 satisfied customers
1995 Grand Cherokee: cyl..10-15 minutes and shuts down..rechecked
1995 Grand Cherokee 6 cyl. Engine will run 10-15 minutes and shuts down. All connections have been checked and rechecked. My mechanic suspects ECM. He's cleaned all contacts and the problem is still t… read more
brownjeff
brownjeff
Associate Degree
13,873 satisfied customers
95 Jeep Wrangler: misfires..you rev up the throttle while its..neutral
My 95 Jeep Wrangler is a manual 5speed and it misfires and it only does this when going down hills or when you rev up the throttle while its in neutral could it be the carbuerator getting to much gas … read more
Amedee
Amedee
Automotive Consultant
Vocational, Technical or Trade Scho
21,486 satisfied customers
4.0...Brought to me with no distributor or timing set installed
timing question for 4.0. Brought to me with no distributor or timing set installed. what is the best way to setup. haynes book isnt even close.… read more
Richard
Richard
Shop foreman/Lead technician
Vocational, Technical or Trade Scho
4,140 satisfied customers
1997 Jeep wrangler: w/ 2.5l..check engine light..crankshaft postion
1997 Jeep wranger w/ 2.5l 4CYL. Getting check engine light with caod P1391. I replaced the crankshaft postion sensor and code still sets. I'm considering replacing the CAM position sensor and have 2 q… read more
Mark
Mark
22 Year Factory trained technician
Vocational, Technical or Trade Scho
2,808 satisfied customers
1997 Jeep Wrangler: 6 cyl with a 5 speed transmission..intermittant
I have a 1997 Jeep Wrangler, 6 cyl with a 5 speed transmission. It has an intermittant starting problem that seems to be getting worse. The engine will turn over for long periods without starting. The… read more
Jerry
Jerry
Service consultant
Vocational, Technical or Trade Scho
13,108 satisfied customers
It something that has to be done by a garage..expensive fix
how would i check for this problem? Or is it something that has to be done by a garage? Is it an expensive fix ?… read more
Amedee
Amedee
Automotive Consultant
Vocational, Technical or Trade Scho
21,486 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Thank you so much for your answer. My initial estimate was $325; I got it done for $100 - part and labor.

Lynn B.Ormond Beach, FL

I was skeptical at first but thought I'd give it a try. I was pleasantly surprised. Your site actually is a quality service that I would recommend to others in a heartbeat.

StanSayre, PA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

< Previous | Next >

Meet the Experts:

Chris

Chris

Shop Foreman

3,932 satisfied customers

Jeep Certified Master Tech

Mark

Mark

22 Year Factory trained technician

2,808 satisfied customers

Jeep factory training........25 years in the industry.

Dave

Dave

Jeep Master Tech

1,149 satisfied customers

Chrysler Triple Master, ASE master Tech AA degree in Auto.

moparfl

moparfl

ASE Certified Technician

1,130 satisfied customers

ASE Master Tech Chrysler Dodge Jeep Master Tech

Tim Mohr

Tim Mohr

ASE MASTER TECH

1,107 satisfied customers

30 YRS EXPERIENCE, FOREIGN AND DOMESTIC, GAS AND DEISEL

Chris (aka-Moose)

Chris (aka-Moose)

Technician

764 satisfied customers

16 years of experience

jeepmopar76

jeepmopar76

Jeep/Chrysler Triple Master Tech

581 satisfied customers

32yr ASE Master Tech, 9yr Chrysler Master Tech, 19 yr Jeep Dealership service including AMC/Eagle

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x