Jeep

Have Jeep questions? Ask a Jeep repair expert for answers

Connect one-on-one with {0} who will answer your question

Related Jeep Questions
My Husband needs to find the location of the Transmission
My Husband needs to find the location of the Transmission pressure sensor Transducer. Part 545RFE on his 2010 Jeep Wrangler unlimited. He has the part but can't seem to find where the part is located … read more
Mark
Mark
22 Year Factory trained technician
Vocational, Technical or Trade Scho
12,150 satisfied customers
2018 Wrangler 4 Door, Red lightning bolt comes on when I
2018 Wrangler 4 Door, Red lightning bolt comes on when I start the car along with the check engine light. car drives fine then all of a sudden dies and goes into some kind of limp mode, loss of power … read more
sprinkles08
sprinkles08
Technician
High School or GED
19,027 satisfied customers
P0340 repeatedly over the past decade. 2006 Rubicon 4.0
P0340 repeatedly over the past decade. 2006 Rubicon 4.0 auto. … read more
Amedee
Amedee
Automotive Consultant
Vocational, Technical or Trade Scho
21,096 satisfied customers
I am not pulling any codes, but my diagnostic tool reads
I am not pulling any codes, but my diagnostic tool reads #7E8 engine and #7E9 A/T on the tool. Car won't start and shut down while driving and has been this way since. … read more
JOHN aka Eauto
JOHN aka Eauto
self employed
High School or GED
19,972 satisfied customers
I have a 2008 jeep wrangler with a manual transmission.
I have a 2008 jeep wrangler with a manual transmission. anyhow, my jeep had the abs, esp, and the traction control lights on. Apparently, I had a problem with the ABS Module. After changing it, all th… read more
Chad Farhat
Chad Farhat
Owner
Associate Degree
7,571 satisfied customers
I have a 2014 jeep jk wrangler that has engine lite on and
I have a 2014 jeep jk wrangler that has engine lite on and traction lite on, computer codes p0016,p0017,p0018,p0019 codes and I have replaced crank sensor and cam sensors. Still in limp mode … read more
David Craig
David Craig
OWNER/MECHANIC
Associates
9,514 satisfied customers
My Jeep is a Wrangler 2005. When I start it up...everytime,
My Jeep is a Wrangler 2005 . When I start it up...everytime, it will not go beyond 2,200 rpm. I can drive it for hours and it does the same thing. If I drive it for about 10 minutes, turn it off, and … read more
Tim Mohr
Tim Mohr
ASE MASTER TECH
Master's Degree
1,094 satisfied customers
I have a p0013 code in my Wrangler Rubicon 2013. We ve just
I have a p0013 code in my Wrangler Rubicon 2013. We ve just changed refitted camshaft, as the left chain got loose and damaged a series of elements. With this code on, is it wise to ge tthe jeep on th… read more
Jagmaster
Jagmaster
Bachelor's Degree
553 satisfied customers
I have 2002 wrangler 4.0 litre thay cuts out and sometimes
I have 2002 wrangler 4.0 litre thay cuts out and sometimes will act like its running on 4 cyl and occasionly will quit, have changed cam sensor and crank sensor … read more
Dan
Dan
Automotive Technician
Vocational, Technical or Trade Scho
24,601 satisfied customers
Engine code P340' camshaft position sensor A circuit ( Bank
Engine code P340' camshaft position sensor A circuit ( Bank 1 or single sensor) ? … read more
Jerry
Jerry
Service consultant
Vocational, Technical or Trade Scho
13,108 satisfied customers
I installed a new factory CD player/stereo in my 08 Jeep
I installed a new factory CD player/stereo in my 08 Jeep Wrangler and it's asking for anti-theft code. I obtained this radio from my brother who took it out of his new Jeep Wrangler - same exact radio… read more
-Brad-
-Brad-
Foreman Dodge Dealership
Vocational, Technical or Trade Scho
8,266 satisfied customers
Wrangle Sahara Unlimited: I'm having this exact same problem.The
I'm having this exact same problem. The P0138 & P0155 error codes occurred only after the Dealer replaced the TIPM and the ECU to solve an issue with the transmission going into limp mode. I have sinc… read more
Chris (aka-Moose)
Chris (aka-Moose)
Technician
Vocational, Technical or Trade School
699 satisfied customers
JEEP Liberty: fixing..fault so that it clears the limp Mode?Thanks
I have a JEEP Liberty (Cherokee in Australia) 2005 2.8 l CRD. How do I clear the codes after fixing a fault so that it clears the Limp Mode? Thanks, Ed… read more
ND-TECH
ND-TECH
Chrysler/Jeep/Dodge specialist tech
Vocational, Technical or Trade Scho
1,410 satisfied customers
2003 Jeep Liberty Sport: V6..over, start sometimes then just die
I have a 2003 Jeep Liberty Sport with the 3.7 V6. Just recently, it's started dieing on me while driving. It will turn over, start sometimes then just die and will not start again. Only after several … read more
kalamykid
kalamykid
Pactor automotive
Vocational, Technical or Trade Scho
6,020 satisfied customers
1997 jeep wrangler 4.0L check engine is on and the code is
1997 jeep wrangler 4.0L check engine is on and the code is P0340. well my jeep will start when the motor is cool but it will just crank and crank after driving for a few miles but then start again whe… read more
Mr. T
Mr. T
Mechanic
Vocational, Technical or Trade Scho
452 satisfied customers
2001 Cherokee: Arizona in the early hours this morning, it
I have a 4.0 2WD 2001 Cherokee with 36k. While driving through Arizona in the early hours this morning, it completely died. The Jeep had been driven aproximately 500 miles nonstop from Denver on route… read more
rpmdiag
rpmdiag
High school
9,040 satisfied customers
Light code from my 1992 wrangler. # XXXXX The code is suppose to mean.
I get a light code from my 1992 wrangler. # XXXXX The code is suppose to mean. Cam is not in sync with the fuel injsction while cranking engine. Is there a cam sensor? This jeep will start and run gre… read more
ttiger79
ttiger79
Auto Mechanic
High School or GED
880 satisfied customers
2008 jeep: stereo..No engine light came on one moment..driving fine
I have purchased a new 2008 jeep 4 door unlimited wrangler. I have since installed a after-market stereo system (it was done professionally). 2 weeks after installation my Jeep went into limp in mode.… read more
Donny
Donny
Associate Degree
828 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Thank you so much for your answer. My initial estimate was $325; I got it done for $100 - part and labor.

Lynn B.Ormond Beach, FL

I was skeptical at first but thought I'd give it a try. I was pleasantly surprised. Your site actually is a quality service that I would recommend to others in a heartbeat.

StanSayre, PA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

< Previous | Next >

Meet the Experts:

Chris

Chris

Shop Foreman

3,850 satisfied customers

Jeep Certified Master Tech

Mark

Mark

22 Year Factory trained technician

12,150 satisfied customers

Jeep factory training........25 years in the industry.

Dave

Dave

Jeep Master Tech

1,149 satisfied customers

Chrysler Triple Master, ASE master Tech AA degree in Auto.

moparfl

moparfl

ASE Certified Technician

1,130 satisfied customers

ASE Master Tech Chrysler Dodge Jeep Master Tech

Tim Mohr

Tim Mohr

ASE MASTER TECH

1,094 satisfied customers

30 YRS EXPERIENCE, FOREIGN AND DOMESTIC, GAS AND DEISEL

Chris (aka-Moose)

Chris (aka-Moose)

Technician

699 satisfied customers

16 years of experience

jeepmopar76

jeepmopar76

Jeep/Chrysler Triple Master Tech

581 satisfied customers

32yr ASE Master Tech, 9yr Chrysler Master Tech, 19 yr Jeep Dealership service including AMC/Eagle

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x