Jeep

Have Jeep questions? Ask a Jeep repair expert for answers

Connect one-on-one with {0} who will answer your question

Related Jeep Questions
Just put a reman engine in a 1993 jeep wrangler, 4.0 6cyl
Just put a reman engine in a 1993 jeep wrangler, 4.0 6cyl with a/t. difficult to start and runs at 2500-3000 rpm but backfires and dies below that. acts like timing is way retarded. checked with timin… read more
kalamykid
kalamykid
Pactor automotive
Vocational, Technical or Trade Scho
6,021 satisfied customers
Rebuilt the 5.2 engine. Installed in jeep. Cranks but after
Rebuilt the 5.2 engine. Installed in jeep. Cranks but after a few seconds back fires. … read more
kalamykid
kalamykid
Pactor automotive
Vocational, Technical or Trade Scho
6,021 satisfied customers
I have a 1992 Jeep Wrangler, 4.0 l H.O. motor... The
I have a 1992 Jeep Wrangler, 4.0 l H.O. motor... The flywheel was removed without marking it's possition how do I set the flywheel to the correct crank timing to match tdc on my ignition timing. … read more
Ron
Ron
Automotive Tech
Vocational, Technical or Trade Scho
39,819 satisfied customers
I have a 98 tj w/ 2.5 it run fine before I put a ( LUK )
I have a 98 tj w/ 2.5 it run fine before I put a ( LUK ) clutch & flywheel in it . At first it would not start . Had a code for distributor/ ignition pick up . I popped the cap off and the bushings in… read more
-Brad-
-Brad-
Foreman Dodge Dealership
Vocational, Technical or Trade Scho
8,266 satisfied customers
replaced engine control module,spark plugs..rotor..disconnect
replaced engine control module,spark plugs,plug wires,distribator cap and rotor,harmonic balancer, coil. the engine still cuts off, but sometimes it will start right back up and sometines there no fir… read more
brownjeff
brownjeff
Associate Degree
13,873 satisfied customers
A timming chain?and how many pins should bebetween the timming marks
what position should points be at when changing a timming chain?and how many pins should bebetween the timming marks?… read more
George H.
George H.
Technician
Associate Degree
19,159 satisfied customers
Just broke both Distributor cap screws attempting to change
Just broke both Distributor cap screws attempting to change cap and rotor. Now I need to replace distributor. How do I remove old distributor. Vehicle is 1998 Jeep Wrangler 4.0L 6 Cyl… read more
brownjeff
brownjeff
Associate Degree
13,873 satisfied customers
94 Jeep Grand Cherokee 4x4: 5.2 V-8...broken timing chain
I bought a 94 Jeep Grand Cherokee 4x4. It has a 5.2 V-8. The Seller told me it has a broken timing chain. I have been reading on the internet that if the timing chain breaks it causes bent valves and … read more
kalamykid
kalamykid
Pactor automotive
Vocational, Technical or Trade Scho
6,021 satisfied customers
95 jeep: accelerate..throttle body..vaccum leaks..few of the injectors
i have a 95 jeep grand , it came with a 318 (5.2) i bent a rod so i stuck in a 96 ,360 (5.9) computer and all, when idle does good when in park and reving the engine sounds strong , but when im in dri… read more
Ricardo Hohl
Ricardo Hohl
Auto Motive Instructor
Automotive tech
4,509 satisfied customers
1193 jeep grand wagoneer: 2 it will start up and run great what is
My 1193 jeep grand wagoneer will start sometimes run all day then not start again in a hour are 2 it will start up and run great what is wrong… read more
brownjeff
brownjeff
Associate Degree
13,873 satisfied customers
1988 cherokee: 4.0...blown head gasket..new head gasket..timing chain
I have a 1988 cheokee with a 4.0. we bought it with a blown head gasket. we put a new head gasket on changed the timing chain due to 230000miles. my problem is after the work the engine idles good but… read more
Mark
Mark
22 Year Factory trained technician
Vocational, Technical or Trade Scho
2,760 satisfied customers
95 Jeep Wrangler: misfires..you rev up the throttle while its..neutral
My 95 Jeep Wrangler is a manual 5speed and it misfires and it only does this when going down hills or when you rev up the throttle while its in neutral could it be the carbuerator getting to much gas … read more
Amedee
Amedee
Automotive Consultant
Vocational, Technical or Trade Scho
21,112 satisfied customers
4.0...Brought to me with no distributor or timing set installed
timing question for 4.0. Brought to me with no distributor or timing set installed. what is the best way to setup. haynes book isnt even close.… read more
Richard
Richard
Shop foreman/Lead technician
Vocational, Technical or Trade Scho
4,140 satisfied customers
97 jeep wrangler 2.5 sputters like out of fuel or air when
97 jeep wrangler 2.5 sputters like out of fuel or air when taking off. Once up to speed mostly fine, but an occasional sputter. seems to idel fine. every once in a while, when you hit the key it grunt… read more
Richard
Richard
Shop foreman/Lead technician
Vocational, Technical or Trade Scho
4,140 satisfied customers
1990 jeep grand wagoneer: front end..distributor..rotor..exhaust
i have a 1990 jeep grand wagoneer with a 360 5.9 L7 motor. the timing chaing gear cover developed a gasket leak so i pulled everything of the front end of the motor except the timing gears and chain. … read more
moparfl
moparfl
ASE Certified Technician
Vocational, Technical or Trade Scho
1,130 satisfied customers
1997 Jeep wrangler: check engine light..Crank sensor..cap..rotor
1997 Jeep wranger w/ 2.5l 4CYL. Getting check engine light with code P1391 (Intermittent loss of cam or crank signal). Have replaced CAM sensor and Crank sensor, cap and rotor. Still get P1391. I then… read more
Arench
Arench
President
CT State GED w/ Honors
1,484 satisfied customers
1995 jeep wrangler: 2.5 L..rocker arm..knocking noise..lifter it self
i have a 1995 jeep wrangler 2.5 L and one tech told me the rocker arm could not be adjusted for the slight knocking noise in the engine, but possibly it was the push rod or the lifter it self. how can… read more
b5demon
b5demon
Automotive Technician
Vocational, Technical or Trade Scho
3,740 satisfied customers
cherokee limited: TIMING BELT..ROTOR, COIL, DISTRIBUTOR, SPARK PLUGS
1994 EEP CHEREKE LIMITED - 5.2 LITER ENGINE - ENGINE TURNS BUT NO FIRE, EVERYTHING SHUT DOWN CHANGED TIMING BELT, ROTOR, COIL, DISTRIBUTOR, SPARK PLUGS, AND WIRES. wILL RUN FOR A WHILE THEN EVERYTHING… read more
autoracer
autoracer
High School or GED
22 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Thank you so much for your answer. My initial estimate was $325; I got it done for $100 - part and labor.

Lynn B.Ormond Beach, FL

I was skeptical at first but thought I'd give it a try. I was pleasantly surprised. Your site actually is a quality service that I would recommend to others in a heartbeat.

StanSayre, PA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

< Previous | Next >

Meet the Experts:

Chris

Chris

Shop Foreman

3,850 satisfied customers

Jeep Certified Master Tech

Mark

Mark

22 Year Factory trained technician

2,760 satisfied customers

Jeep factory training........25 years in the industry.

Dave

Dave

Jeep Master Tech

1,149 satisfied customers

Chrysler Triple Master, ASE master Tech AA degree in Auto.

moparfl

moparfl

ASE Certified Technician

1,130 satisfied customers

ASE Master Tech Chrysler Dodge Jeep Master Tech

Tim Mohr

Tim Mohr

ASE MASTER TECH

1,094 satisfied customers

30 YRS EXPERIENCE, FOREIGN AND DOMESTIC, GAS AND DEISEL

Chris (aka-Moose)

Chris (aka-Moose)

Technician

699 satisfied customers

16 years of experience

jeepmopar76

jeepmopar76

Jeep/Chrysler Triple Master Tech

581 satisfied customers

32yr ASE Master Tech, 9yr Chrysler Master Tech, 19 yr Jeep Dealership service including AMC/Eagle

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x