Jeep

Have Jeep questions? Ask a Jeep repair expert for answers

Connect one-on-one with {0} who will answer your question

Related Jeep Questions
2015 jeep grand Cherokee, tilt steering mechanism stuck high
2015 jeep grand Cherokee, tilt steering mechanism stuck high on column and won't move or make any noise, drives ok but inconvienient … read more
Chris (aka- Moose)
Chris (aka- Moose)
Vocational, Technical or Trade School
52,532 satisfied customers
I have a 2007 Grand Cherokee 240000 miles on the 3.7 engine.
Hey Dave I have a 2007 Grand Cherokee 240000 miles on the 3.7 engine. It keeps going into limp mode and it does not always trow a code but when it does its always a P0007 and sometimes comes with a U2… read more
mike switzer
mike switzer
733 satisfied customers
2008 jeep grand Cherokee. goes into limp mode, transmission
2008 jeep grand Cherokee . goes into limp mode , transmission won't shift right , will not exceed 30 mph. Goodyear said bad connection on a module around the throttle body , said that module was about… read more
-Brad-
-Brad-
Foreman Dodge Dealership
Vocational, Technical or Trade Scho
8,263 satisfied customers
2008 Jeep Grand Cherokee 3.7 all wheel drive. Getting trans
2008 Jeep Grand Cherokee 3.7 all wheel drive. Getting trans over temp on dash at start up jeeps in limp mode any ideas? … read more
eauto
eauto
The Car Guy
18,391 satisfied customers
grand cherokee overland: 2008 3 ltr Jeep diesel has lost
2008 3 ltr Jeep diesel has lost full power and only run in limp mode, code p2015 come up how to correct this ?… read more
Greg
Greg
Shop owner, technician
Vocational, Technical or Trade Scho
5,868 satisfied customers
jeep cherokee: I have a 2000 jeep grand cherokee limited quadra
I have a 2000 jeep grand cherokee limited quadra drive 4.7 motor i was driving 20 mph in snow wanted to spin tires pushed gas pedal bout half way it started spinning then heard and felt clubk it coast… read more
Vladimir Grodskiy
Vladimir Grodskiy
Automotive Electrician
Vocational, Technical or Trade Scho
2,724 satisfied customers
Grand Cherokee: I have a 2007 jeep grand cherokee with a 3.0
I have a 2007 jeep grand cherokee with a 3.0 v6 diesel I just put a new swirl motor in it worked at first but started throwing a code the pin connectors were bad replaced them (soldered heat shrink) n… read more
Tim Mohr
Tim Mohr
ASE MASTER TECH
Master's Degree
1,052 satisfied customers
Grand Cherokee: Please explain the ETC & swirl motor?The
Please explain the ETC & swirl motor? The warning light came on today - 2008 Jeep Grand Cherokee Diesel, 79,000kms. Read the manual - called the dealership. They said NOT to drive the vehicle due to i… read more
Vladimir Grodskiy
Vladimir Grodskiy
Automotive Electrician
Vocational, Technical or Trade Scho
2,724 satisfied customers
Jeep Grand Cherokee: hi my 2005 jeep grand cherokee 3.0 crd
hi my 2005 jeep grand cherokee 3.0 crd has gone into limp mode my local garage tells me the fault code is p 2015 intake manifold air control actuator sensor switch,bank 1 can you help please… read more
Chris
Chris
Shop Foreman
3,703 satisfied customers
Grand Cherokee: oil leak..limp mode..needs replacing..sound right
Hi, I have an 08 Grand Cherokee 3.0 CRD.At the 100,000 service the dealer found oil leak onto Swirl Motor and fixed for $400AUD, then one week later after going into limp mode and having to be eventua… read more
Vladimir Grodskiy
Vladimir Grodskiy
Automotive Electrician
Vocational, Technical or Trade Scho
2,724 satisfied customers
Jeep Grand Cherokee 4x4: Re: 2008 Grand Cherokee 3.0 diesel.... My
Re: 2008 Grand Cherokee 3.0 diesel.... My engine light came on at 100900 km and fortunately it was just the number 5 glow plug. The service tech told me that I was very lucky since at at this mileage … read more
ND-TECH
ND-TECH
Chrysler/Jeep/Dodge specialist tech
Vocational, Technical or Trade Scho
1,410 satisfied customers
Jeep Grand Cherokee: crd..limp home..we performed an actuator test
We have had a 3lire CRD Jeep Grand Cherokee 2006. When it first came in we read the codes as swirl flap fault putting it in to limp home. When we performed an actuator test we found the swirl flap mot… read more
Scott
Scott
1,189 satisfied customers
Jeep Grand Cherokee: I read about the faulty shifter module..my dealer
I am hesitant to buy a used Jeep Grand Cherokee because of all the things I read about the faulty shifter module on the internet. I asked my dealer and he claims never to have heard of it. How bad is … read more
eauto
eauto
The Car Guy
18,391 satisfied customers
2002 Jeep Grand Cherokee: a right hand turn..traffic..stopping
I have a 2002 Jeep Grand Cherokee. When I am making a right hand turn, the Jeep turns into the oncoming traffic lane. It seems that the turning radius is stopping the wheel from turning completely. It… read more
garrtim
garrtim
SERVICE MANAGER
2,266 satisfied customers
40 mph I have to let up on the gas for it to shift and again at 60 mph
At 40 mph I have to let up on the gas for it to shift and again at 60 mph, with a little shutter.… read more
David Dill
David Dill
Master Level Chrysler Technician
High School or GED
834 satisfied customers
1999 Jeep Grand Cherokee Limited: 40 mph..roaring..metallic
1999 Jeep Grand Cherokee Limited - When speed is over 40 mph, there is an inconsistent load roaring sound somewhere near the engine. (or possibly transmission - can't really tell)There is also an inco… read more
stevets 61
stevets 61
chrysler / jeep /suzuki tech
Vocational, Technical or Trade Scho
96 satisfied customers
2004 Jeep Grand Cherokee limited: 4.7L V8..low speeds..driveway
I have two questions about my 2004 Jeep Grand Cherokee Limited 4.7L V8 Power Tech. When I turn the steering wheel to the left at low speeds either in the driveway or parking lot the steering wheel mak… read more
Mark
Mark
22 Year Factory trained technician
Vocational, Technical or Trade Scho
2,649 satisfied customers
96 Jeep Grand Cherokee: blowing fuses..the drive shaft..wont shift
I have a 96 Jeep Grand Cherokee. It began blowing fuses and we found some wires hanging near the drive shaft which appeared to be the problem. We fixed all that, but now it won't shift correctly. We a… read more
brownjeff
brownjeff
Associate Degree
13,873 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Thank you so much for your answer. My initial estimate was $325; I got it done for $100 - part and labor.

Lynn B.Ormond Beach, FL

I was skeptical at first but thought I'd give it a try. I was pleasantly surprised. Your site actually is a quality service that I would recommend to others in a heartbeat.

StanSayre, PA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

< Previous | Next >

Meet the Experts:

Chris

Chris

Shop Foreman

3,703 satisfied customers

Jeep Certified Master Tech

Mark

Mark

22 Year Factory trained technician

2,649 satisfied customers

Jeep factory training........25 years in the industry.

Dave

Dave

Jeep Master Tech

1,149 satisfied customers

Chrysler Triple Master, ASE master Tech AA degree in Auto.

moparfl

moparfl

ASE Certified Technician

1,130 satisfied customers

ASE Master Tech Chrysler Dodge Jeep Master Tech

Tim Mohr

Tim Mohr

ASE MASTER TECH

1,052 satisfied customers

30 YRS EXPERIENCE, FOREIGN AND DOMESTIC, GAS AND DEISEL

Ron Z.

Ron Z.

- Jeep Tech -

641 satisfied customers

18+yrs experience. State Inspector & Jeep Diagnostics/Repair

jeepmopar76

jeepmopar76

Jeep/Chrysler Triple Master Tech

579 satisfied customers

32yr ASE Master Tech, 9yr Chrysler Master Tech, 19 yr Jeep Dealership service including AMC/Eagle

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x