1998 Jeep Truck Grand Cherokee 4WD L6-4.0L VIN S
Select Print Option Complete Article Text Only Image(s) Only
REMOVAL 1. Disconnect and isolate the battery negative cable. 2. Raise and support the vehicle.
3. Disconnect the battery cable and solenoid feed wire from the starter solenoid.
4. Remove the front starter mounting bolt and the automatic transmission oil cooler line bracket. 5. Remove the rear starter mounting bolt and lower the starter. 6. Reverse the removal procedures to install. Tighten the starter hardware as follows: - Upper mounting bolt - 55 N.m (40 ft. lbs.) - Lower mounting bolt - 41 N.m (30 ft. lbs.) - Solenoid battery cable nut - 10 N.m (90 in. lbs.) - Solenoid terminal nut - 6 N.m (55 in. lbs.).
Please let me know if you need anything else on it, just reply back and we will continue
If you are good, Kindly Rate Me.
A Positive Rating is Much Appreciated
This Post will stay open for you to come back and ask me any follow up questions you may have on this issue even after you rate me
ASE Certified Technician