How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask sprinkles08 Your Own Question
sprinkles08
sprinkles08, ASE Certified Technician
Category: Jeep
Satisfied Customers: 22670
Experience:  Chrysler/Dodge/Jeep Master Certified, ASE Master and Advanced Certified, Trans and Hybrid Specialist
9825021
Type Your Jeep Question Here...
sprinkles08 is online now
A new question is answered every 9 seconds

99 Cherokee 4.0 idle control motor will not respond. P0505

Customer Question

99 Cherokee 4.0 idle control motor will not respond. P0505 codes. tried 2 new IAC motors, new programmed PCM. wires from IAc to PCM [ok] only other problem is speedo not reading, clear codes and on 2nd start up Po505 comes up
Submitted: 1 year ago.
Category: Jeep
Customer: replied 1 year ago.
Can also raise idle with scanner but will not respond to come down
Customer: replied 1 year ago.
Scanned input and output sensors on transmission - [ok] replaced speed sensor on t-case - no change Did the test on the gauge cluster, all gauges working fine, removed ground on fire wall and cleaned [common problem] no change
Expert:  sprinkles08 replied 1 year ago.
Hello and welcome to JustAnswer!
P0505 is for an IAC control circuit issue. Possible causes are the IAC, PCM and wiring. If the PCM and IAC have been replaced I'm sure the issue is wiring. Normally the issue is where the harness wraps around the back side of the head.
How was the wiring tested?