Jeep

Have Jeep questions? Ask a Jeep repair expert for answers

Ask an Expert,
Get an Answer ASAP!

Wrangler rubicon: i have a 04 jeep wrangler rubicon that I…

Customer Question
i have a 04 jeep...
i have a 04 jeep wrangler rubicon that I just rebuilt the engine in. and ive been having trouble with the cks and cps. I went to the delear and got one of each put them in today and it is still idling very rough and also had code p1391
Submitted: 3 years ago.Category: Jeep
Show More
Show Less
Ask Your Own Jeep Question
Answered in 10 hours by:
6/28/2015
Jeep Mechanic: Ron, ASE Certified Technician replied 3 years ago
Ron
Ron, ASE Certified Technician
Category: Jeep
Satisfied Customers: 38,839
Experience: 34 year working in the automotive field as a Tech.
Verified
Hello, my name is ***** ***** I am a professional here at Just Answer. I have noticed that your question was not getting a response and thought I would see if you still need help with this.I apologize for the delay and I hope I can still assist you with this here.
The problem you are describing as well as the code you are getting can be caused by any of the following.
CMP WIRE HARNESS
TONE WHEEL/PULSE RING
CKP WIRE HARNESS
CHECKING INTERMITTENT CKP SIGNAL
CAMSHAFT POSITION SENSOR
CRANKSHAFT POSITION SENSOR
TIMING CHAIN ALIGNMENT.
In order to determine the cause you are going to need to do some testing, I have enclosed the steps to do so in the link below, copy and paste the link to your browser to open and view them.
https://dl.dropboxusercontent.com/u/104923897/P1391%20Jun%2028.pdf
Ask Your Own Jeep Question
Was this answer helpful?

How JustAnswer works

step-image
Describe your issueThe assistant will guide you
step-image
Chat 1:1 with a jeep mechanicLicensed Experts are available 24/7
step-image
100% satisfaction guaranteeGet all the answers you need
Ask Ron Your Own Question
Ron
Ron
Ron, ASE Certified Technician
Category: Jeep
Satisfied Customers: 38,839
38,839 Satisfied Customers
Experience: 34 year working in the automotive field as a Tech.

Ron is online now

A new question is answered every 9 seconds

How JustAnswer works:

  • Ask an ExpertExperts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional AnswerVia email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction GuaranteeRate the answer you receive.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Thank you so much for your answer. My initial estimate was $325; I got it done for $100 - part and labor.

Lynn B.Ormond Beach, FL

I was skeptical at first but thought I'd give it a try. I was pleasantly surprised. Your site actually is a quality service that I would recommend to others in a heartbeat.

StanSayre, PA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

< Previous | Next >

Meet the Experts:

Chris

Chris

Shop Foreman

3,578 satisfied customers

Jeep Certified Master Tech

Mark

Mark

22 Year Factory trained technician

2,649 satisfied customers

Jeep factory training........25 years in the industry.

Dave

Dave

Jeep Master Tech

1,149 satisfied customers

Chrysler Triple Master, ASE master Tech AA degree in Auto.

moparfl

moparfl

ASE Certified Technician

1,130 satisfied customers

ASE Master Tech Chrysler Dodge Jeep Master Tech

Tim Mohr

Tim Mohr

ASE MASTER TECH

1,052 satisfied customers

30 YRS EXPERIENCE, FOREIGN AND DOMESTIC, GAS AND DEISEL

Ron Z.

Ron Z.

- Jeep Tech -

641 satisfied customers

18+yrs experience. State Inspector & Jeep Diagnostics/Repair

jeepmopar76

jeepmopar76

Jeep/Chrysler Triple Master Tech

579 satisfied customers

32yr ASE Master Tech, 9yr Chrysler Master Tech, 19 yr Jeep Dealership service including AMC/Eagle

< Previous | Next >

Related Jeep Questions
Rough idle, I changed the TPS, CPS and the sensor next to
Rough idle, I changed the TPS, CPS and the sensor next to the TPS, no luck. … read more
Curtis
Curtis
Vocational, Technical or Trade Scho
1,723 satisfied customers
I have a 2002 wrangler that I believe the computer is shot
I have a 2002 wrangler that I believe the computer is shot in. I recently just put a new starter on it and drove 5 miles , the next morning the jeep starts right up and died about 15 seconds later , i… read more
Ron
Ron
ASE Certified Technician
Vocational, Technical or Trade Scho
38,839 satisfied customers
My 2007 Jeep Wrangler Rubicon this morning was started and
My 2007 Jeep Wrangler Rubicon this morning was started and driven to gas station(< mile away). When I came out and tried to start it, the CEL came on accompanied by a bunch of alarms on the dash. W… read more
Chris
Chris
Shop Foreman
3,578 satisfied customers
Wrangler Unlimited Rubicon: 2012 jeep wrangler rubicon. started
2012 jeep wrangler rubicon. started with p0345 replaced the cam sensor. no help, then replaced crank sensor no help, then replaced ecm and update then got p0345 and p0390. ckd voltage coming from cam … read more
Brad
Brad
Technician at Dodge Dealership
Vocational, Technical or Trade Scho
12 satisfied customers
jeep: i have a 2006 jeep wrangler unlimited rubicon, it shifts
i have a 2006 jeep wrangler unlimited rubicon, it shifts from 1st to 2nd very hard when it first starts. I had the transmission rebuilt twice and the problem continues. the problem goes away after the… read more
joeplow
joeplow
Retired-Disabled
Master Aamco
1 satisfied customers
99 jeep wrangler: 2.5 cel..tps..cam sensor..distributor..crank sensor
i have a 99 jeep wrangler 2.5 cel is on and its running rough pulled codes p1391 p0132 & p0123. ive replaced tps, cam sensor (inside distributor) and crank sensor and full tune up any suggestions… read more
ND-TECH
ND-TECH
Chrysler/Jeep/Dodge specialist tech
Vocational, Technical or Trade Scho
955 satisfied customers
2004 Jeep Wrangler Rubicon: coil pack..rough idle and lack of power
2004 Jeep Wrangler Rubicon Have replaced the plugs, #4 injector and coil pack. Have used Lucas injector cleaner. Still rough idle and lack of power at higher speed. All of this started with CEL and co… read more
Brad
Brad
Technician at Dodge Dealership
Vocational, Technical or Trade Scho
12 satisfied customers
2004 Jeep Wrangler Rubicon: rpms..stalls..traffic..crankshaft sensor
I have 2004 Jeep Wrangler Rubicon that doesn't hold the idle. It [intermittently] drops to 400 rpms and eventually stalls when sitting at a red light or otherwise in slow traffic. I've had the cranksh… read more
eauto
eauto
self employed
High School or GED
74 satisfied customers
94 jeep wrangler: the engine cuts..gets hot..idling..sensors replaced
i have 94 jeep wrangler and the engine cuts out in the summer, when it gets hot. it starts by idling high with no power. i have had the sensors replaced and still nothing. brought it into a jeep deale… read more
CDJMasterTech
CDJMasterTech
Lead Automotive Technician
High School or GED
813 satisfied customers
2003 Jeep Wrangler Rubicon: starts fine..idles rough..it warms up
2003 Jeep Wrangler Rubicon starts fine but idles rough once it warms up. After longer trips it can be hard to restart. 65k miles on it & have had no trouble to date.… read more
moparfl
moparfl
ASE Certified Technician
Vocational, Technical or Trade Scho
1,130 satisfied customers
Jeep wrangler: models..best accessories (lift kit with large tires
I am looking to buy a used jeep wrangler, what are the best years, best models, and best accessories (lift kit with large tires) to put on a jeep. I'm looking for something that has a stable base (i.e… read more
Thomas
Thomas
Mechanic
High School or GED
1,053 satisfied customers
2002 Jeep wrangler s: (6 cylinder)..position sensor..cam sensor
2002 Jeep Wrangler TJ (6 cylinder) has code P1391, I replaced the Crank shaft position sensor (3 days before which fixed the random die outs while driving down the road.), then the Cam shaft position … read more
ricardo hohl
ricardo hohl
automotive instructor
Associate Degree
1,818 satisfied customers
wrangler: have a rubicon express 3.5 lift..wobble..mounting..tires
Ive got an 07 wrangler jk and have a rubicon express 3.5 lift and ive been experiencing some death wobble. should i look for around my track bar, other than mounting points, what is the length that my… read more
Tim Mohr
Tim Mohr
ASE MASTER TECH
Master's Degree
1,052 satisfied customers
2001 Jeep Grand Cherokee: 4.0L..crank sensor..dash said bad cam pos
2001 Jeep Grand Cherokee 4.0L, initially had a crank but no start condition. Replaced crank sensor, still no start. Then retrieved code (?) from dash said bad cam pos. sensor. Replaced cam pos. sensor… read more
sprinkles08
sprinkles08
Technician
High School or GED
11 satisfied customers
Getting a cylinder #1 misfire code in 2003 Jeep Wrangler Rubicon.
Getting a cylinder #1 misfire code in 2003 Jeep Wrangler Rubicon. Recently did a tune-up and replaced the radiator. Runs very rough.… read more
Mark
Mark
22 Year Factory trained technician
Vocational, Technical or Trade Scho
2,649 satisfied customers
99 jeep wrangler: 4.0..cps tps map sensor..check engine..misfire
99 jeep wrangler 4.0 replaced cps tps map sensor new wires pugs cap rotor still getting check engine P1391 manufacturer ignition control or misfire ?… read more
ase_master327
ase_master327
Owner & Student
High School or GED
3,214 satisfied customers
jeep wrangler s: idling..crank sensor,cam sensor..check engine light
I have a jeep wrangler tj 2001,that has trouble idling then stops running completely and won't start.Have replaced the crank sensor,cam sensor ,oil pump part on bottom.It still has same problems and c… read more
petek26
petek26
Automotive Technician
Bachelor's Degree
156 satisfied customers
1990 Jeep wrangler: having trouble starting..happened two..it to idle
I just bought a 1990 Jeep wrangler, Last night I put in a brand new battery because I was having trouble starting it. Today I went to start it, it turned over, started for a couple of seconds, then di… read more
moparfl
moparfl
ASE Certified Technician
Vocational, Technical or Trade Scho
1,130 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x