How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask moparfl Your Own Question
moparfl
moparfl, ASE Certified Technician
Category: Jeep
Satisfied Customers: 6330
Experience:  ASE Master Tech Chrysler Dodge Jeep Master Tech
13195827
Type Your Jeep Question Here...
moparfl is online now
A new question is answered every 9 seconds

Jeep Grand Cherokee 2000 w/ engine code P0108. On which manafold

Customer Question

Jeep Grand Cherokee 2000 w/ engine code P0108. On which manafold is the MAP sensor located? Can it be cleaned with something and function better. Occasionally it idles or runs rough. Has actually stalled and died.
Checked and cleared code and it has run good without code returning.
Any advice about good quality replacement at reasonable cost?
Submitted: 7 years ago.
Category: Jeep
Expert:  moparfl replied 7 years ago.
1 - ECT SENSOR
2 - MOUNTING BOLTS (2)
3 - MAP SENSOR
4 - INTAKE MANIFOLD
moparfl and 6 other Jeep Specialists are ready to help you
Expert:  moparfl replied 7 years ago.

MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR - 4.7L V - 8 ENGINE

The MAP sensor is located on the front of the intake manifold MAP and ECT Sensor Locations - 4.7L V - 8 Engine An o-ring seals the sensor to the intake manifold

REMOVAL

  1. Disconnect electrical connector at sensor.
  2. Clean area around MAP sensor.
  3. Remove 2 sensor mounting bolts MAP and ECT Sensor Locations - 4.7L V - 8 Engine
  4. Remove MAP sensor from intake manifold.

INSTALLATION

  1. Clean MAP sensor mounting hole at intake manifold.
  2. Check MAP sensor o-ring seal for cuts or tears.
  3. Position sensor into manifold.
  4. Install MAP sensor mounting bolts (screws) Tighten screws to 3 N·m (25 in. lbs.) torque.
  5. Connect electrical connector.
Customer: replied 7 years ago.
Thanks, XXXXX XXXXX cleaning instead of replacing and hope it solves interment problem.
Expert:  moparfl replied 7 years ago.
Your welcome.
Customer: replied 7 years ago.

I was looking for something else when I saw this question and answer. I do not understand why the answer seems to still be open.

I ask question, you answered, paid fee and thanked you.

Have a great day and thanks again.

Expert:  moparfl replied 7 years ago.
Your welcome. I dont know either