Industrial Equipment

Have industrial equipment repair questions? Ask an Expert now

Connect one-on-one with {0} who will answer your question

Related Industrial Equipment Questions
Hyster 50 and it starts ok and idles fine but when I try to
Hyster 50 and it starts ok and idles fine but when I try to throttle up on it it wants to choke out I've tuned it up and no change does the propane system have a fuel filter this is my only propane pi… read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,486 satisfied customers
I have a NIssan Gas Engine and need to know where the timing
I have a NIssan Gas Engine and need to know where the timing marks on the crank and cam should be for unit to be in time. … read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,486 satisfied customers
I have a hyster 50 forklift. LP It won't fire. I have put on
I have a hyster 50 forklift. LP It won't fire. I have put on a new coil. I thought it was some sensor. I know when oil gets low it won't start. Where do I trouble Shute all the sensors?… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
1,015 satisfied customers
I recently acquired an old factory building. Among the items
Hi. I recently acquired an old factory building. Among the items inside were 2 propane forklifts. They are obviously old and in disrepair, but not clearly at the "carcas" stage either. There are two c… read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,486 satisfied customers
After running about 15 minutes my Hyster forklift starts
After running about 15 minutes my Hyster forklift starts running rough, looses power and eventually quits. It will start again after about 20-30 minutes. The first stage regulator gets frosty - it is … read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,486 satisfied customers
I have a hyster S-30A forklift. The forklift has been
I have a hyster S-30A forklift. The forklift has been running terrible. I changed the plugs, points, condenser,rotor cap, and distributor cap. Now it wont start. what did I do? Plugs are gaped at .025… read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,486 satisfied customers
I HAVE A HYSTER S60XM FORKLIFT WITH A 4 CYLINDER LP SYSTEM
HI I HAVE A HYSTER S60XM FORKLIFT WITH A 4 CYLINDER LP SYSTEM IT HAS IMPCO COBRA MIXER AND IMPCO LP FILTER IT WOULD NOT START IN THE MORNING UNTIL YOU PRESSED THE LP PRIMER BUTTON SO I REPLACED THE LP… read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,486 satisfied customers
C500-50 lpg forklift no start will crank and kind of run off
Clark c500-50 lpg forklift no start will crank and kind of run off starting fluid just crank no start… read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,486 satisfied customers
I need a schematic on the propane system of a Clark forklift
I need a schematic on the propane system of a Clark forklift 1970. It won't start after refilling the propane tank. Is there something I have to do to get it to work?… read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,486 satisfied customers
Engine shut down like out of fuel while in use. Has lp gas
Engine shut down like out of fuel while in use. Has lp gas in bottle. Will start after setting for a while, but only runs a few seconds and sounds like it runs out of gas again. Hyster D456346 forklif… read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,486 satisfied customers
We have a nissan CPF02 rype LP fork lift, chassis No. CPF02
We have a nissan CPF02 rype LP fork lift, chassis No. CPF02 001296, that is hard to start when warehoused in an unheated warehouse. Is there anything we can do to improve it starting easier.… read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,486 satisfied customers
toyota 42-6fgcu20: Toy propane fork lift needed a starter so
Toy propane fork lift needed a starter so I replaced now only cranks has spark and can smell fuel in the intake… read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,486 satisfied customers
Hello We have a forklift problem - lp fuel related - Hyster
Hello We have a forklift problem - lp fuel related - Hyster S60ES - Vaporizer 2 years old - carberator impco 100 two years old - The problem is it has run good until 2 days ago and it was like it ran … read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,486 satisfied customers
my allis chalmers lp gas forklift wont start. Ive replace all
my allis chalmers lp gas forklift wont start. Ive replace all the ignition components rebuilt the vaporizer and replaced the regulator. When I try to start the forklift all it does now is backfire thr… read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,486 satisfied customers
hyster 20 forklift , lpg . Hard to start, once started runs
hyster 20 forklift , lpg . Hard to start, once started runs as long as you are moving fast, move slow or stop and it dies. What are the things i need to check? . motor is sound and has plenty power, I… read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,486 satisfied customers
have a clark forklift model gcs 15 replaced wires plugs and
have a clark forklift model gcs 15 replaced wires plugs and cap/rotor and rad, starter and battery and some valve that shuts fuel off the one that has vac from the carb go to it and replaced vac adv l… read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,486 satisfied customers
My hyster lp fueled forklift starts, runs a few seconds and
My hyster lp fueled forklift starts, runs a few seconds and then dies. starts right back up, runs for a few seconds and then dies.… read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,486 satisfied customers
I have a no start issue on my V50DSA forklift it has a impco
I have a no start issue on my V50DSA forklift it has a impco propane system and when the key is on I can hear gas flowing in the carb. When I pull the front off the converter the pressue from the tank… read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,486 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Wayne

Wayne

Journeyman

13,008 satisfied customers

worked on lift trucks, and IR air compressors

Cat Man

Cat Man

Cat Engine Expert

224 satisfied customers

I am ASE Master Certified.

cumminsdr

cumminsdr

Mechanic

26 satisfied customers

Cummins Field Tech

Jeremy

Jeremy

Technician

20 satisfied customers

ASE Medium/Heavy Duty Technician, Hydraulics, Brakes, Electrical Certified

dieseldan55

dieseldan55

Mechanic

17 satisfied customers

Road service Mechanic for Volvo Construction Equipment

spankyjr1

spankyjr1

Journeyman

151 satisfied customers

I worked on all types of equipment semis,forklifts,farm,ect.

Bradley Martin

Bradley Martin

44 satisfied customers

Field Technician at Thompson Tractor Company

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x