Industrial Equipment

Have industrial equipment repair questions? Ask an Expert now

Connect one-on-one with {0} who will answer your question

Related Industrial Equipment Questions
Propane fork lift not started in 2 years. It keeps stalling
nothing other than what I indicated I understand gas engines very well … read more
Wayne
Wayne
Journeyman
Vocational, Technical or Trade Scho
12,984 satisfied customers
On a old datsun propane fork lift, 4 cyl. Starts and runs
On a old datsun propane fork lift, 4 cyl. Starts and runs but acts like it runs out of fuel. Worked fairly well till now. Sputters and then dies. What do you look for? Full tank of propane… read more
Edward Haniewski
Edward Haniewski
General Studies/Automotive
1 satisfied customers
I have a Genie S60 with the Ford LRG-423. The engine will
I have a Genie S60 with the Ford LRG-423. The engine will start and run normally but abruptly stops about 5-10 seconds after the start switch is released. No fault shows on the Ignition/Start module. … read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
1,015 satisfied customers
I am wo rking on a Komatsu Forklift. Model FG25ST-14 Serial
I am wo rking on a Komatsu Forklift. Model FG25ST-14 Serial 583448A.cranks over but will not start. The power to the 12 volt solenoid stays on for 4 seconds then it turns off. I think the ignition is … read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,486 satisfied customers
I have an old flat head fork lift. It just started serging
Hi I have an old flat head Clark fork lift. It just started serging when I accelerate and has no power. It idles just fine. … read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,486 satisfied customers
I have a Genie 45-25, manufactured in 1999. Several months
I have a Genie 45-25, manufactured in 1999. Several months back, I noticed a reduction in forward travel power. I changed the hydraulic filter near the tank and that fixed it. I recently experienced t… read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
1,015 satisfied customers
I have a Nissan pneumatic 6000 pound capacity and it was
I have a Nissan pneumatic 6000 pound capacity and it was running great I put a new tank on or the same tank but for started it drop it outside the shop and it died. Tried several times And smelled bur… read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,486 satisfied customers
The unit is a 45/25J,2000 model yr.,s#157201,has 2426
the unit is a 45/25J,2000 model yr.,s#157201,has 2426 hrs.,ford gas,4x4,the machine is all correct from the ground controls. from the platform it will not travel at HI idle. while looking over the mac… read more
Bradley Martin
Bradley Martin
44 satisfied customers
1995 Genie boom lift.When the switch on the main panel is
1995 Genie boom lift.When the switch on the main panel is set to ground control the engine runs perfect.When you switch it to platform control in a few minutes the engine starts to sputter and quits r… read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,486 satisfied customers
Genie Z boom z45/22 with Ford Engine. Plate Form Controls
Genie Z boom z45/22 with Ford Engine. Plate Form Controls work when the switch is in ground control mode.… read more
Bradley Martin
Bradley Martin
44 satisfied customers
I have a 45-22 everything works except it will not move
I have a 45-22 everything works except it will not move forward or back. It goes up to high ideal. But won't move. Any suggestions.… read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,486 satisfied customers
I have a Genie scissor lift GS3246 2003 model. I am getting
I have a Genie scissor lift GS3246 2003 model. I am getting the fault led light on the platform control unit it come and goes. The lift will work for about 30 to 45 minutes. Then the fault light comes… read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,486 satisfied customers
I just purchased a genie z 45 22 it does not run it has a blowed
I just purchased a genie z 45 22 it does not run it has a blowed up Onan propane engine in it I was wondering how I could put it on my trailer it has been sitting for a proximately 1 year I am not fam… read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,486 satisfied customers
I have a 1999 Genie z45\25 diesel lift which I need some help
I have a 1999 Genie z45\25 diesel lift which I need some help with. I purchased at auction 2 months ago. Problem I am having is probably electrical but I have no experience with this type of machine. … read more
spankyjr1
spankyjr1
Journeyman
Vocational, Technical or Trade Scho
150 satisfied customers
I have a 1997 Genie Lift. Model Z-34/221C. Kubota 3 clinder
I have a 1997 Genie Lift. Model Z-34/221C. Kubota 3 clinder engine, gasoline/LP. I do not have much info on this. Problem is the engine starts right up, runs fine, but shuts down in about 20-30 second… read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,486 satisfied customers
I have a Yale 4000# XXXXX forklift that wont start. It has
I have a Yale 4000# XXXXX forklift that won't start. It has been used very little for the past few years but has always started. I started it and it ran like it was running out of gas until it warmed … read more
Daniel Wilson
Daniel Wilson
Auto Mechanics 1&2/diesel mech
1,015 satisfied customers
sometimes will start & run fine, next time it starts & runs
sometimes will start & run fine, next time it starts & runs a few seconds & quits, will not restart, sometimes 2 hrs later starts 7 runs, very in consistent, but getting worse, did crank untill almost… read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,486 satisfied customers
I have a genie z 34/22 with a kubota dual fuel motor. The
i have a genie z 34/22 with a kubota dual fuel motor. The machine operates fine if you hold the start toggle on when you open the throttle . After what ever operation you are using has started you can… read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,486 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Wayne

Wayne

Journeyman

12,984 satisfied customers

worked on lift trucks, and IR air compressors

Cat Man

Cat Man

Cat Engine Expert

224 satisfied customers

I am ASE Master Certified.

cumminsdr

cumminsdr

Mechanic

26 satisfied customers

Cummins Field Tech

Jeremy

Jeremy

Technician

20 satisfied customers

ASE Medium/Heavy Duty Technician, Hydraulics, Brakes, Electrical Certified

dieseldan55

dieseldan55

Mechanic

17 satisfied customers

Road service Mechanic for Volvo Construction Equipment

spankyjr1

spankyjr1

Journeyman

150 satisfied customers

I worked on all types of equipment semis,forklifts,farm,ect.

Bradley Martin

Bradley Martin

44 satisfied customers

Field Technician at Thompson Tractor Company

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x