How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Curtis B. Your Own Question
Curtis B.
Curtis B., Technician
Category: Industrial Equipment
Satisfied Customers: 28345
Experience:  Technican turned service manager on multiple lines of equipment used in industry.
Type Your Industrial Equipment Question Here...
Curtis B. is online now
A new question is answered every 9 seconds

Jlg 2030 flashing 3 with short pause and 3 more. It will

Customer Question

Jlg 2030 flashing 3 with short pause and 3 more . It will raise and lower but will not drive. Batteries are showing full charge but indicator has a red light and wrench symbol
Submitted: 10 months ago.
Category: Industrial Equipment
Expert:  Curtis B. replied 10 months ago.

Hello! Let's see if we can can work together to get to the root of your question!

Expert:  Curtis B. replied 10 months ago.

2030 E, E1, E2, ES? Do you have operators manual on board? Does it give codes for the unit? you say 3 short and again 3 short? Do you have a voltmeter to check the battery voltage? Are the pot hole protectors raised? If one is not tripping the switch, the unit will not drive.

Customer: replied 10 months ago.
Batteries are at 48% change and at 6.2amp. down Rogers are up and switch is fine
Expert:  Curtis B. replied 10 months ago.

Batteries at 48 percent and 6.2 amps, you mean volts per battery? For pack of 24.8 volts?

Customer: replied 10 months ago.
per battery
Expert:  Curtis B. replied 10 months ago.

What does battery pack voltage drop to ,when you raise the scissor?

Customer: replied 10 months ago.
Drops to 10
Expert:  Curtis B. replied 10 months ago.

there's the probelm, with a 24 volt battery pack, the voltage is too low. Charge battery pack or replace bad batteries, Each has t stay above 6 volts under load, which means it has to stay above 24 volts.

Customer: replied 10 months ago.
I have to lifts identical. They both read the same and that has no issues. Charging system works properly and battery's are checking out fine it has to be something else
Expert:  Curtis B. replied 10 months ago.

Where are you measuring the 10 volts? What is it before raising?

Customer: replied 10 months ago.
No as it is raising. It goes up and down just fine no drive,or steering
Expert:  Curtis B. replied 10 months ago.

Either 10 volts is incorrect reading, r you have a voltage problem. This is 24 volt scissor and 10 volts is extremely low!

Customer: replied 10 months ago.
Im measuring from one side so it should be at 12 it's not the charger or the battery's. They check out fine
Customer: replied 10 months ago.
Get off voltage and look elsewhere.
Expert:  Curtis B. replied 10 months ago.

I will opt out and let someone else try to help. Please do not respond to me or it will lock your question, The next expert may need to know the full model number.

Related Industrial Equipment Questions