HVAC

Have HVAC questions? Ask an HVAC Expert for answers

Connect one-on-one with {0} who will answer your question

Related HVAC Questions
I have pushed the reset button numerous times, and I'm
Hello, I have pushed the reset button numerous times, and I'm locked out. Is there anything I can do to get it unlocked? … read more
Rick
Rick
Supervisor
29,523 satisfied customers
We have a Carrier furnace "plus 90 with hot surface
We have a Carrier furnace "plus 90 with hot surface ignition" that is not working right. This morning, 4 degrees outside. Was supposed to go up from 55 to 68 at 6 am. Did not. We flipped the power swi… read more
gotoman for ac
gotoman for ac
HVAC Service manager and owner
Associate Degree
5,441 satisfied customers
How to I reset a flashing code 2: external lockout(retries
How to I reset a flashing code 2: external lockout(retries or recycles exceeded)? This is a Trane heat and AC unit XR90 … read more
gotoman for ac
gotoman for ac
HVAC Service manager and owner
Associate Degree
5,441 satisfied customers
My name is ***** *****. Im working on a trane tud080r936a.
My name is ***** *****. Im working on a trane tud080r936a. 1st assement, w1 and w2 are jumped on board.furnace lites on high fire then about 5 seconds it drops to low fire, then flame drops out after … read more
airheatman
airheatman
HVAC Technician
6 years college
12,341 satisfied customers
I have a HVAC unit Model # GY9S100C16UP11J What happens is I
I have a HVAC unit Model # ***** What happens is I have a fault code #8 Ignition locked out due to recycles What happens is the burner lights off but after about 10 seconds the flame drops out it cont… read more
gotoman for ac
gotoman for ac
HVAC Service manager and owner
Associate Degree
5,441 satisfied customers
I have an Amana 90 furnace that will run but not bring the
Tom, I have an Amana 90 furnace that will run but not bring the temp up to what the thermostat is set at. It runs a short cycle 6-8 minutes and then cuts out and will try to relight for 3 attempts and… read more
Tim H.
Tim H.
Lead building engineer
Vocational, Technical or Trade Scho
3,962 satisfied customers
My Rheem RGRM gas furnace burners will not stay lit more than
My Rheem RGRM gas furnace burners will not stay lit more than 8 seconds.I have checked the exaust and combustion air and condensate drains and ground wires.Thanks… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,450 satisfied customers
I have an Armstrong air model #g1n80bu050d12a-2a that is starting
I have an Armstrong air model #g1n80bu050d12a-2a that is starting and stopping for about 30 sec and finally just staying off. Then it gives the same 8 flashes (lockout due to to many flame dropouts) I… read more
R.G.
R.G.
318 satisfied customers
Code 8 after cleaning flame rod on York Diamond 80 furnace
I've got a problem with my York Diamond 80 that is eluding me, and I don't trust any local HVAC or appliance repair companies-too many bad experiences with big city dishonest technicians. The problem:… read more
M Oglesby
M Oglesby
Vocational, Technical or Trade Scho
2,038 satisfied customers
I have a Ducane forced air system. The system will only start
I have a Ducane forced air system. The system will only start ramdomly. When the termostat drops below set, it will always try to start, however sometimes it will start other times not. When I pull th… read more
Tim H.
Tim H.
Lead building engineer
Vocational, Technical or Trade Scho
3,962 satisfied customers
I have a York Diamond 90 P3U which for the past ywo weeks would
I have a York Diamond 90 P3U which for the past ywo weeks would cycle to heat, ignite, and then cut out. It would do this many times before actually returning to normal. No error codes at those times.… read more
TimVZ26
TimVZ26
Service Foreman
Vocational, Technical or Trade Scho
157 satisfied customers
My furnace starts without lighting and then stops. Need Help.
My furnace starts to come on and then it just stops. The fan is blowing air for about 30 seconds. It sounds like it starts to light but won't stay lit. What do you think?… read more
Regan Land
Regan Land
General Manager
Vocational, Technical or Trade Scho
772 satisfied customers
My neighbor has a Arcoair furnace in his home. the model #
My neighbor has a Arcoair furnace in his home. the model # XXXXX The ignitors do not stay on. Two of the for "burners" light but go out aftre a few seconds. There is a flash code printed on the outsid… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,450 satisfied customers
my furnace isnt working right it was just blowing cold air
my furnace isnt working right it was just blowing cold air last night when i turned it off waited 5mins and turned it on it would work for a little bit but then the warm air turned cold again today th… read more
Matthew
Matthew
HVAC Technician
Bachelor's Degree
2,014 satisfied customers
My Bryant high efficiency programmable thermostat that was
My Bryant high efficiency programmable thermostat that was newly installed 4/04 is acting up. When my setting is at 70 degrees, the house temp is going lower. when I raise the temp up to 75 the furnac… read more
Matthew
Matthew
HVAC Technician
Bachelor's Degree
2,014 satisfied customers
TDD100R945C0 GAS FURNACE ignites then the flames are at low
TDD100R945C0 GAS FURNACE ignites then the flames are at low pressure then turns off ,trys again ignites then goes out,then p.c board lite reads steady on red to replace ignition module.. is this a boa… read more
Mark Henley
Mark Henley
HVAC Controls DDC
3,216 satisfied customers
I have a Lennox model # G24m3/4-100A-2 gas heater. It is installed
I have a Lennox model # XXXXX gas heater. It is installed in the attic. Fan only blows cold air when set to on and heat. When set to auto and heat, the heater never comes on. The thermostat makes a si… read more
gotoman for ac
gotoman for ac
HVAC Service manager and owner
Associate Degree
5,441 satisfied customers
nordyne M1MA 070A AW series furnace. Keeps blowing luke warm
nordyne M1MA 070A AW series furnace. Keeps blowing luke warm air and HSI continuously lights, because flame keeps going out. Sometimes locks out due to failed ignition (4 blinking red lights). HSI rep… read more
ComfortZone
ComfortZone
Associate Degree
515 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Phil

Phil

Mechanical Engineer

8,697 satisfied customers

Retired HVAC/ Electrical & Boiler contractor. Industrial

Rick Mather

Rick Mather

HVAC Technician

3,133 satisfied customers

35 years experience, HVAC

Matthew

Matthew

HVAC Technician

2,014 satisfied customers

14 years experience in the HVAC field of service, installation, Manual J & D calculations

Brian HVAC Guy

Brian HVAC Guy

HVAC Technician

1,029 satisfied customers

I have been an HVAC/R mechanic/technician for 30+ years.

Kenton Guidry

Kenton Guidry

HVAC Technician

963 satisfied customers

12 years install/service experience.

Tom

Tom

HVAC Technician

770 satisfied customers

16+yrs HVAC/R service. Residential Commerical Industrial

A-1 Tech

A-1 Tech

Service Manager

526 satisfied customers

I have been in the HVAC business for over 40 years.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x