HVAC

Have HVAC questions? Ask an HVAC Expert for answers

Connect one-on-one with {0} who will answer your question

Related HVAC Questions
I have a code 33 on a payne furnace. changed the filter,
I have a code 33 on a payne furnace. changed the filter, checked the AC coil, I cant seem to find a reset button, tried shutting down the unit for several minutes. … read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,442 satisfied customers
My Payne Furnace 80FAU-12B does not light the burner for
My Payne Furnace 80FAU-12B does not light the burner for heat. The pilot is lit and unit has power … read more
Twa252842
Twa252842
Handyman / Owner Operator
Vocational, Technical or Trade School
500 satisfied customers
I have a Kenmore furnace. I am getting error code 3-5 which
I have a Kenmore furnace. I am getting error code 3-5 which is a gas valve issue. I purchased a new one in the hopes of fixing, but I plugged in the new gas valve just to see if it would cycle and sta… read more
Tamar D
Tamar D
HVAC Mechanic II / Service Tech
Vocational, Technical or Trade School
1,884 satisfied customers
Sure. I just installed a Payne pg92s furnace, brand new
Sure. I just installed a Payne pg92s furnace, brand new install. And it's throwing an error code 22 2 short 2 long blinks … read more
Cliff
Cliff
HVAC Contractor / HVAC Instructor
Bachelor's Degree
397 satisfied customers
Im getting an error code of 12 on my carrier furnace, trying
im getting an error code of 12 on my carrier furnace, trying to figure out how to fix it … read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
10,410 satisfied customers
I have a Plus 80 giving me an error code of 21. If I turn
I have a Bryant Plus 80 giving me an error code of 21. If I turn off the power and then wait a little bit, turning power back on it will ignite and run. But on next cycle it fails to run and gives the… read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
10,410 satisfied customers
I have furnace error code 34 and I noticed the Hot surface
I have furnace error code 34 and I noticed the Hot surface ignitor was not glowing, so I replaced it but still not glowing, blower starts, inducer motor starts, gas is hissing then it shuts off and lo… read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
8,427 satisfied customers
Armstrong Ultra V Tech 80 Gas Furnace Igniter will not glow.
Armstrong Ultra V Tech 80 Gas Furnace Igniter will not glow. I have replaced original igniter (no continuity) still no glow. Draft blower runs as should, pressure switch is ok, no restrictions in air … read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,442 satisfied customers
My central air is turning off and then turning back on
My central air is turning off and then turning back on within a few seconds. Has been doing this for a few hours now. Bad Thermostat? … read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
10,410 satisfied customers
Just put in a brand new white Rodgers 50a55-843. And keep getting
Just put in a brand new white Rodgers 50a55-843. And keep getting pressure switch stuck open. I don't think it's pressure switch… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,442 satisfied customers
I am replacing the gas valve on a Payne Plus 90 gas furnace,
I am replacing the gas valve on a Payne Plus 90 gas furnace, Model 398AAV060120AAKA. Original valve is part number #36E36 263 and seems to be obsolete. The replacement is a universal gas valve, part n… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,442 satisfied customers
Trying to figure out why my furnace wont heat Payne pg8jaa
Trying to figure out why my furnace won't heat Payne pg8jaa tried reading other things on this site but it Diddnt help… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,442 satisfied customers
I have a payne furnace is give me a code 33 mod pg8maa024070
I have a payne furnace is give me a code 33 mod pg8maa024070 ser 4506a18928, when the furnace just turned on with power it go straight to the code 33 the inducer fan did not come on at all just the bl… read more
Tim H.
Tim H.
Lead building engineer
Vocational, Technical or Trade Scho
3,962 satisfied customers
I have a model 1155 gas furnace and it is very hard to get
I have a model 1155 gas furnace and it is very hard to get the pilot lite light and if get it to light it goes out when it cycles.… read more
hvacexpertjoe
hvacexpertjoe
Electronics Technician
Vocational, Technical or Trade Scho
186 satisfied customers
How do I start my Payne furnace Model number 36J24 The
How do I start my Payne furnace Model number 36J24? The Gas and the burner have been off all summer. The is a red valve with and S on top and an O on the bottom which is installed in the gas line. I g… read more
Richard
Richard
District Technical Manager
Vocational, Technical or Trade Scho
1,514 satisfied customers
I AM LOOKINAT A PAYNE PGYAB060100 CONDENSED GAS FURNACE AND
I AM LOOKINAT A PAYNE PGYAB060100 CONDENSED GAS FURNACE AND HAVE THE FOLLOWING QUESTIONS 1 -------- HOW IS THE FURNACE STARTED 2--------- SHOULD THE INSTALLER RUN INTAKE PIPE FROM FURNACE TO OUTSIDE T… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,442 satisfied customers
Hello, Technicians I have a Payne 125,000 BTU Natural gas
Hello, Technicians I have a Payne 125,000 BTU Natural gas furnace model #394gaz048125. It's approximately 20 years old & was given a clean bill of health 3 months ago by a technician. Now it's NOT wan… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,442 satisfied customers
WORK ON A XV95 TRANE FURNACE IS ABOUT YEARS OLD AND IS BLINKING
WORK ON A XV95 TRANE FURNACE IS ABOUT YEARS OLD AND IS BLINKING ERROR CODE # XXXXX WE CHECK FOR PROPER GROUNDIND,VOLTAGE,NEUTRAL,REPLACE CONTROL BOARD,IGNITER,GAS VALVE AND CHECK DRAFT INDUCER LIMIT A… read more
Douglas
Douglas
Vocational, Technical or Trade Scho
3,118 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Phil

Phil

Mechanical Engineer

8,427 satisfied customers

Retired HVAC/ Electrical & Boiler contractor. Industrial

Rick Mather

Rick Mather

HVAC Technician

3,133 satisfied customers

35 years experience, HVAC

Matthew

Matthew

HVAC Technician

2,014 satisfied customers

14 years experience in the HVAC field of service, installation, Manual J & D calculations

Brian HVAC Guy

Brian HVAC Guy

HVAC Technician

1,029 satisfied customers

I have been an HVAC/R mechanic/technician for 30+ years.

Kenton Guidry

Kenton Guidry

HVAC Technician

963 satisfied customers

12 years install/service experience.

Tom

Tom

HVAC Technician

770 satisfied customers

16+yrs HVAC/R service. Residential Commerical Industrial

A-1 Tech

A-1 Tech

Service Manager

526 satisfied customers

I have been in the HVAC business for over 40 years.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x