HVAC

Have HVAC questions? Ask an HVAC Expert for answers

Connect one-on-one with {0} who will answer your question

Related HVAC Questions
I have a Breckwell P28FS pellet stove and the maintenance
I have a Breckwell P28FS pellet stove and the maintenance guy suggested I get a new circuit board/control panel. The serial number is ***** so I think its a 1997 unit. I can't figure out where to get … read more
J LaGrutta
J LaGrutta
AA
86 satisfied customers
I didn't really expect a chat right now, but what the heck.
Ok, I didn't really expect a chat right now, but what the heck. I have a quadrafire 1100 insert pellet stove. The augur won't start, but I noticed that the call light doesn't come on. I used a single … read more
Christopher Coleman
Christopher Coleman
Handyman
2,902 satisfied customers
The compressor of our a c unit just went out, its 12 years
The compressor of our a c unit just went out, its 12 years old I think, are there any conditions we did that would cause the compressor to fail ? We had the unit cleaned and what ever supposedly a yea… read more
Twa252842
Twa252842
Handyman / Owner Operator
Vocational, Technical or Trade School
482 satisfied customers
I have a Magnum pellet stove ,It will burn for about 3-5
I have a Magnum pellet stove ,It will burn for about 3-5 hours then start o smoke and fill the housewith smoke,any ideas as to why? … read more
Machinc
Machinc
Retired
1,136 satisfied customers
I have a Whitfield pellet stove that is about 10 yrs old. I
I have a Whitfield pellet stove that is about 10 yrs old. I has been serviced professionally only once. The manual says that the combustion and convection blowers should be serviced annually. I can fi… read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
8,427 satisfied customers
We are having trouble regulating the heat out put of our
We are having trouble regulating the heat out put of our pellet stove. It is running us out of the house! It is a 25-PDVC/55-SHP10. Can a thermostat be wired into this unit. The stove is set at 1-1. … read more
Kcrand36
Kcrand36
Technician/Owner
Vocational, Technical or Trade School
72 satisfied customers
I have a Harman P68 pellet stove. The igniter gets hot but
I have a Harman P68 pellet stove. The igniter gets hot but not hot enough to light the pellets. It works fine on manual but will not start on automatic. I say it works fine on manual but that is after… read more
Gaztech
Gaztech
Technician
Vocational, Technical or Trade School
1,663 satisfied customers
I have a 8 year old castile insert that either fills too
I have a 8 year old castile insert that either fills too little pellets to start the seguence or too much that either smothers the ignited fire or the stove overheats with too many pellets. Last year … read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
8,427 satisfied customers
Heatilator CAB50. Stove worked great all last winter. Two recent
Heatilator CAB50. Stove worked great all last winter. Two recent times the stove started per set thermostat, pellets begin to feed pellets ignite and continue to feed, as soon as the room fan kicks on… read more
Jerry
Jerry
Plumber
High School or GED
1,904 satisfied customers
I have a st. Croix Prescott pellet stove and after I removed
I have a st. Croix Prescott pellet stove and after I removed the exhaust blower to clean it and reconnected it, it appears that the ignition somehow failed as the auger works and throws pellets into t… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,419 satisfied customers
quadra fire 1100-i. Just replaced #1 and #2 snap discs. When
quadra fire 1100-i. Just replaced #1 and #2 snap discs. When the stove is plugged in red thermostat light illuminates, blower comes on and stays running, ignitor is glowing red hot. Pellet feed motor … read more
Jerry
Jerry
Plumber
High School or GED
1,904 satisfied customers
I have a Mt Vernon pellet stove insert. It keeps going into
I have a Mt Vernon pellet stove insert. It keeps going into autoclean . The firepot opens then doesn't close. I check it then it will close and start. Sometimes it just says autoclean and I don't see … read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
8,427 satisfied customers
I have a Harman P68 Pellet stove. I cant the pellets buring
I have a Harman P68 Pellet stove. I can't the pellets buring but the feeder continues to run dumping fresh pellets in the ash container below. Also, after the stove runs for a short period of time, al… read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
8,427 satisfied customers
I have Two Harman pellet stoves, a 61a and an insert. I want
I have Two Harman pellet stoves, a 61a and an insert. I want to now connect them to a digital thermostat so I can reduce the cost of the pellets as I am burning a lot of pellets at night and during th… read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
8,427 satisfied customers
Hi, I have a harmon 25th anniversary stove that is about 4
Hi, I have a harmon 25th anniversary stove that is about 4 years old. I use Instant Heat pellets for three years now. This year the stove is consuming a lot more pellets than in previous years and is … read more
Al-Moderator
Al-Moderator
High School or GED
I have a Winslow Pellet Stove P140 and it turns on fine and
I have a Winslow Pellet Stove P140 and it turns on fine and does the initial burn but then after that the pellets stop feeding and the stove starts to shut down. The ready light is a steady red light.… read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
8,427 satisfied customers
Stove is thermastat controled. When stove comes on it starts
Stove is thermastat controled. When stove comes on it starts @ low setting. Pellets fall in burn pot and after a few moments starts to to burn. I have to push fan button on control board. It comes on.… read more
Will
Will
President
Vocational, Technical or Trade Scho
175 satisfied customers
I just picked up a used lopi pellet insert. The fan runs, the
I just picked up a used lopi pellet insert. The fan runs, the controller strats the process. The Auger has a "maintenance light flashing and wont turn, the inginiter wont heat up. An ideas where to st… read more
DuWayne
DuWayne
Sales/ Service
Vocational, Technical or Trade Scho
126 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Phil

Phil

Mechanical Engineer

8,427 satisfied customers

Retired HVAC/ Electrical & Boiler contractor. Industrial

Rick Mather

Rick Mather

HVAC Technician

3,133 satisfied customers

35 years experience, HVAC

Matthew

Matthew

HVAC Technician

2,014 satisfied customers

14 years experience in the HVAC field of service, installation, Manual J & D calculations

Brian HVAC Guy

Brian HVAC Guy

HVAC Technician

1,029 satisfied customers

I have been an HVAC/R mechanic/technician for 30+ years.

Kenton Guidry

Kenton Guidry

HVAC Technician

963 satisfied customers

12 years install/service experience.

Tom

Tom

HVAC Technician

770 satisfied customers

16+yrs HVAC/R service. Residential Commerical Industrial

A-1 Tech

A-1 Tech

Service Manager

526 satisfied customers

I have been in the HVAC business for over 40 years.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x