HVAC

Have HVAC questions? Ask an HVAC Expert for answers

Connect one-on-one with {0} who will answer your question

Related HVAC Questions
I have a Lochinvar gas hot water heater model DVN041 that
Hello, I have a Lochinvar gas hot water heater model DVN041 that calls for heat and the exhaust fan runs, the heater does not fire. If I shut the unit off for 10 seconds and then turn it back on, the … read more
Rick
Rick
Supervisor
29,163 satisfied customers
My unit is over five years old. Work very good till now.
My unit is over five years old. Work very good till now. refuse to lite. I pulled it apart to clean the orifice on water side. Work again then no lite again. Igniter is off & on, sometimes, when flame… read more
Gaztech
Gaztech
Technician
Vocational, Technical or Trade School
1,663 satisfied customers
I have a Trane XL80 that kept shutting down. I took the
I have a Trane XL80 that kept shutting down. I took the flame sensor out and cleaned it with 0000 steel wool and re-installed it. The furnace started up correctly and finally ran until it reached the … read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
10,265 satisfied customers
I have a Goodman furnace in a 6 year old house. The thermostat
I have a Goodman furnace in a 6 year old house. The thermostat is a carrier and has 2 wires coming in. It controls the heat and the air. The furnace turns on the immediately turns off. Then after abou… read more
HVAC Guru
HVAC Guru
21,722 satisfied customers
I have a 20 year old Rheem furnace with a Honeywell programable
I have a 20 year old Rheem furnace with a Honeywell programable thermastat.Recently on several occasion the furnace has failed to light. The first time I saw the firebox fan was working but the ignite… read more
HVAC Guru
HVAC Guru
21,722 satisfied customers
Janitrol Furnace Blower Motor Runs For A Few Minutes, Won't Ignite
Janitrol furnace won't ignite. Has a new flame sensor. Igniter glows when trying to ignite but nothing happens except blower motor runs for 3--4 minutes and shuts off. Tried to reset by turning switch… read more
airheatman
airheatman
Heating & Air Conditioning Contractor
6 years college
10,265 satisfied customers
Hello, My furnace is a G8T10016UHB11A and I replaced the surface
Hello, My furnace is a G8T10016UHB11A and I replaced the surface ignitor last week (6 days ago.) The furnace worked great all week. Last night it started blowing cold air again. I have confirmed with … read more
gotoman for ac
gotoman for ac
HVAC Service manager and owner
Associate Degree
5,433 satisfied customers
Code 8 after cleaning flame rod on York Diamond 80 furnace
I've got a problem with my York Diamond 80 that is eluding me, and I don't trust any local HVAC or appliance repair companies-too many bad experiences with big city dishonest technicians. The problem:… read more
M Oglesby
M Oglesby
Vocational, Technical or Trade Scho
2,038 satisfied customers
I have a 90 percent efficient furnace made by Heat Controller,
I have a 90 percent efficient furnace made by Heat Controller, Inc. It is about 18 years old. I just recently replaced the Igniter last year, this year I put in a new control board #62-24084-82 with a… read more
Tim H.
Tim H.
Lead building engineer
Vocational, Technical or Trade Scho
3,962 satisfied customers
I have a 20 year old amana high efficency 80 gas furnace. One
I have a 20 year old amana high efficency 80 gas furnace. One day I have heat and the next I don't. I'll have heat for a week and then one day nothing. This had been going on for a month and its start… read more
Tim H.
Tim H.
Lead building engineer
Vocational, Technical or Trade Scho
3,962 satisfied customers
I have an Armstrong Ultra II 90 Gas furnace about 20 years
I have an Armstrong Ultra II 90 Gas furnace about 20 years old. Almost every year it needs service because when the thermostat calls for heat the draft motor comes on and the igniter keeps clicking bu… read more
Rick Mather
Rick Mather
HVAC Technician
Vocational, Technical or Trade Scho
3,133 satisfied customers
my furance (gas) is igniting for about 2-3 seconds then stops
my furance (gas) is igniting for about 2-3 seconds then stops (fans & blower continue to run), then this just keeps continuing (it keeps igniting and stops). The filter is not clogged (I tried without… read more
Heath Moyer
Heath Moyer
1,071 satisfied customers
My furnace will not give power to the igniter, the gas comes
My furnace will not give power to the igniter, the gas comes on and I can lite it manually. I have checked with a meter and at 1st it gets a flick of power but no more (everything else seems to work l… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,418 satisfied customers
I have an Amana upright gas furnace, about 10 years old. In
I have an Amana upright gas furnace, about 10 years old. In the past few weeks it has been acting erratically in that when the thermostat calls for heat, the draft fan starts fine, the igniter gets ho… read more
Rick
Rick
Supervisor
29,163 satisfied customers
My Carrier Gas Furnace will not stay lit. It is an induce
My Carrier Gas Furnace will not stay lit. It is an induce combustion furnace which is only a little over a year old. Model no. is 58STA . Here is what happens when you turn the furnace on: Induction f… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,418 satisfied customers
I have a Nordyne MMHB-090ABHR-06. I replaced the igniter last
I have a Nordyne MMHB-090ABHR-06. I replaced the igniter last week. Now the flame kicks on and off. My research would lead me to the flame sensor. But I can't find a flame sensor on this furnace. Wher… read more
Al
Al
Master Service Technician
Votec, College, Master Electrical S
24 satisfied customers
I have a HEIL PL gas furnace Model NULK050MF03, 50,000 BTU
I have a HEIL PL gas furnace Model NULK050MF03, 50,000 BTU which is 20 years old. For the last couple years it occasionally misfires. If you unplug it and then replug it back in then it will work for … read more
tomgoe
tomgoe
owner
Vocational, Technical or Trade Scho
1,763 satisfied customers
I have an Air Ease Ultra SX 80 furnace that is 12 years old.
I have an Air Ease Ultra SX 80 furnace that is 12 years old. The T-stat calls for heat, the HSI(hot start igniter) gets yellow hot, the pilot light starts burning, the FS(flame sensor) gets red hot, a… read more
Ronald
Ronald
Consultant
Bachelor's Degree
4 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Phil

Phil

Mechanical Engineer

8,427 satisfied customers

Retired HVAC/ Electrical & Boiler contractor. Industrial

Rick Mather

Rick Mather

HVAC Technician

3,133 satisfied customers

35 years experience, HVAC

Matthew

Matthew

HVAC Technician

2,014 satisfied customers

14 years experience in the HVAC field of service, installation, Manual J & D calculations

Brian HVAC Guy

Brian HVAC Guy

HVAC Technician

1,029 satisfied customers

I have been an HVAC/R mechanic/technician for 30+ years.

Kenton Guidry

Kenton Guidry

HVAC Technician

963 satisfied customers

12 years install/service experience.

Tom

Tom

HVAC Technician

770 satisfied customers

16+yrs HVAC/R service. Residential Commerical Industrial

A-1 Tech

A-1 Tech

Service Manager

526 satisfied customers

I have been in the HVAC business for over 40 years.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x