HVAC

Have HVAC questions? Ask an HVAC Expert for answers

Connect one-on-one with {0} who will answer your question

Related HVAC Questions
Lennox fireplace, 510 millivolt with burners off lennox
Lennox fireplace, 510 millivolt with burners off lennox fireplace 520 millivolt son with burners off … read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
8,427 satisfied customers
Furnace model N9MP1100F14B1 propane furnace. Turn on at
Furnace model N9MP1100F14B1 propane furnace. Turn on at thermostat, and the fan motor in the furnace turns on, the ignitor glows red hot, there's a little flame that comes comes out from what I assume… read more
Rick
Rick
HVAC Supervisor
28,917 satisfied customers
Xb80 furnace no ignition with 2 blink error code, main fan
Xb80 furnace no ignition with 2 blink error code , main fan runs but no heat. you can put a call from the t-stat for heat and the induction fan turns on and runs, pressure switch closes as soon as the… read more
Tim H.
Tim H.
Lead building engineer
Vocational, Technical or Trade Scho
3,962 satisfied customers
My Lennox Whisperheat stopped producing gas heat, pilot
My Lennox Whisperheat stopped producing gas heat, pilot still lights and fan comes on. 10.8 volts are being delivered to M terminal on gas valve… read more
Rick
Rick
HVAC Supervisor
28,917 satisfied customers
I have a rheem RRGG - 10e31jkr & the gas pack will not ignite
I have a rheem RRGG - 10e31jkr & the gas pack will not ignite the burners. Blower above unit comes on and I hear a spark but cycles start Sequence but no ignition.… read more
Theplumber717
Theplumber717
Plumber
Vocational, Technical or Trade Scho
1,265 satisfied customers
Weil-Mclain VHE furnance short cycles -60 secs with no
Weil-Mclain VHE furnance short cycles for 30-60 secs with no error code on ICM. Replaced flame rod. Voltage across gas valve was erratically dropping from 24 down to zero tripping the solenoid repeate… read more
Appliance Guru
Appliance Guru
21,435 satisfied customers
Inducer motor runs, HSI glows for several seconds, then no
Inducer motor runs, HSI glows for several seconds, then no gas (gas valve doesn't open). Pressure and switch checkout, roll out switches check out for continuity. Already replaced the control board. I… read more
Theplumber717
Theplumber717
Plumber
Vocational, Technical or Trade Scho
1,265 satisfied customers
G20 with 2yr. old Honeywell ignit. control. Pilot on, no main
G20 with 2yr. old Honeywell ignit. control. Pilot on, no main burners on, fan on for cycle then retry. 2 blink code.… read more
Tim H.
Tim H.
Lead building engineer
Vocational, Technical or Trade Scho
3,962 satisfied customers
i have a nordyne L1RA-072N-12A furnace. the pilot comes on
i have a nordyne L1RA-072N-12A furnace. the pilot comes on but the main burners won't kick in. this was intermittent for a week but now won't fire up at all. get 4 flashes on red status light. suggest… read more
Rick
Rick
HVAC Supervisor
28,917 satisfied customers
I have a carrier gas furnace. 1992 build. model 58DHCO-75.
I have a carrier gas furnace. 1992 build. model 58DHCO-75. Gas valve will not open. I am a technician in the electric industry, and have made many checks already. If touch the self test pins together,… read more
Phil
Phil
Mechanical Engineer
Degree, Mech Engr Technology
8,427 satisfied customers
HOW CAN I TEST A VR205M 2823 GAS VALVE? IT OHM METER SHOWS
HOW CAN I TEST A VR205M 2823 GAS VALVE? IT OHM METER SHOWS HIGH RESISTANCE ACROSS THE TERMINALS.… read more
Mark Henley
Mark Henley
HVAC Controls DDC
3,216 satisfied customers
My arcoaire gas furnace (H9MPV125L20B1) will not start the
My arcoaire gas furnace (H9MPV125L20B1) will not start the combustion blower, stopping the startup procedure at the beginning. I can cycle the circulating air blower on and off with the thermostat whe… read more
Tim H.
Tim H.
Lead building engineer
Vocational, Technical or Trade Scho
3,962 satisfied customers
We have a GUPS100-4 unit and pilot light is lit, induction
We have a GUPS100-4 unit and pilot light is lit, induction motor comes on and blower motor comes on but gas valve does not open to light burners.… read more
Douglas
Douglas
Vocational, Technical or Trade Scho
3,118 satisfied customers
when trying to turn on the Heil Furnace the exhausts blower
when trying to turn on the Heil Furnace the exhausts blower turns on and the pilot light lights..but doesn't ignite in the end...what could be the problem? we think it could be the smart valve that do… read more
Matthew
Matthew
HVAC Technician
Bachelor's Degree
2,014 satisfied customers
I have a Concord gas fired furnace Model CG80TB100D14B. I
I have a Concord gas fired furnace Model CG80TB100D14B. I am told Concord is a subsidiary of Lennox. My question deals with the electronic circuit board. Do the furnaces come with surge suppression pr… read more
BillyHvac
BillyHvac
Journeyman Service Technician
State Licensed Mechanical Contractor
14,390 satisfied customers
furnace stopped working. Electric pilot comes on the upper
furnace stopped working. Electric pilot comes on the upper fan comes on the pilot lights but the furnace does not start, like the gas valve is not letting gas into the furnace… read more
freon
freon
Owner
High School or GED
214 satisfied customers
HVAC - I have a Lennox furnace that will not ignite the burners
HVAC - I have a Lennox furnace that will not ignite the burners even though the pilot light is lit and working fine. In December I had problems with the burners cycling on and off. I replaced the flam… read more
Regan Land
Regan Land
General Manager
Vocational, Technical or Trade Scho
772 satisfied customers
10 year old diamond 80 has flame lockout issues. tried cleaning
10 year old diamond 80 has flame lockout issues. tried cleaning the flame sensor and it will light 50% of the time, runfor a few minutes then go out. it will not always re-light. sometimes tapping on … read more
Mark Henley
Mark Henley
HVAC Controls DDC
3,216 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Phil

Phil

Mechanical Engineer

8,427 satisfied customers

Retired HVAC/ Electrical & Boiler contractor. Industrial

Rick Mather

Rick Mather

HVAC Technician

3,133 satisfied customers

35 years experience, HVAC

Matthew

Matthew

HVAC Technician

2,014 satisfied customers

14 years experience in the HVAC field of service, installation, Manual J & D calculations

Brian HVAC Guy

Brian HVAC Guy

HVAC Technician

1,029 satisfied customers

I have been an HVAC/R mechanic/technician for 30+ years.

Kenton Guidry

Kenton Guidry

HVAC Technician

963 satisfied customers

12 years install/service experience.

Tom

Tom

HVAC Technician

770 satisfied customers

16+yrs HVAC/R service. Residential Commerical Industrial

A-1 Tech

A-1 Tech

Service Manager

526 satisfied customers

I have been in the HVAC business for over 40 years.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x